Marshall RF-1 Reflector Bedienungsanleitung
Marshall
Gitarrenverstärker
RF-1 Reflector
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Marshall RF-1 Reflector (5 Seiten) in der Kategorie Gitarrenverstärker. Dieser Bedienungsanleitung war für 11 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/5
RF-1 Reflector
Reflector Suggested Settings
Owners Manual
HALL (Amp: Clean)
PLATE (Amp: Clean)
ROOM (Amp: Clean)
SPRING (Amp: Clean)
3
5 6 7 8
11
10
9
1
24
From The Chairman
I would like to personally thank you
for selecting one of our effects pedals.
For over 40 years the Marshall name has been synonymous
with the greatest guitar tones in music. We have worked hand
in hand with guitarists from all levels throughout the world to
maintain and improve that special ingredient, ‘The Marshall
Sound.’
Our range of effects pedals gives the opportunity to augment
the classic Marshall tone to add Marshall character to a guitar
set-up.
All our pedals are made with the same utmost attention to
quality, in both materials and manufacture as our world
renowned amplifiers, cabinets and combos, in order to provide
you with optimum reliability and tone.
I would like to wish you every success with all of your musical
endeavours and also your new Marshall effects pedal, which I
am sure you will find a pleasure to play for many years to
come.
Yours Sincerely,
2 3
Introduction
The Reflector pedal is a stereo reverb pedal offering a
maximum delay time of 2000ms. From a spacious hall to the
sound of a studio plate via the pulsing of a vintage spring, the
Reflector recreates six different reverb modes for you to
explore giving you full control over the reverb time, damping
and level of every mode.
The Reflector's dual outputs offer the choice of using a
passive bypass for the main signal path to ensure complete
tonal integrity or allowing the pedal to spill-over allowing your
reverb tails to naturally die away. Combined the outputs create
a stereo reverb effect creating a wide spacious field.
Below is a complete run down of the Reflector's features for
your information. We have also enclosed a number of
suggested settings to help guide you. It should be
remembered that these are only suggested settings and you
should really experiment as much as possible.
Features
1. 'In' Jack Socket
This is the input jack for connection to your guitar or to the
output of another effects pedal when linking pedals together.
2. 'Expression' Socket
An expression pedal can be connected to this socket to
control the decay time. Moving the pedal overrides the
reverb time setting on the pedal allowing you to
increase/decrease the control as you perform.
Always use good quality shielded leads.
Always use 9V regulated DC supply with centre negative rated
at 80mA or above.
Although it may seem obvious the first action in achieving a
good effected sound (be it duration / compression etc.) is to
find the perfect bypassed sound. This will then allow the
correct level to be set with the effect unit to allow a cut or
boost in volume and a realistic tone.
On clean channels it is advisable to set the gain (or volume)
to a setting of no less than one quarter maximum so as not to
get unrealistic results due to any volume dependent tonal
shaping on the amplifier preamp.
Setting Up
ENGLISH
Produktspezifikationen
| Marke: | Marshall |
| Kategorie: | Gitarrenverstärker |
| Modell: | RF-1 Reflector |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Marshall RF-1 Reflector benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Gitarrenverstärker Marshall
23 September 2024
31 August 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
Bedienungsanleitung Gitarrenverstärker
- Gitarrenverstärker Valeton
- Gitarrenverstärker Roland
- Gitarrenverstärker Vox
- Gitarrenverstärker Yamaha
- Gitarrenverstärker Peavey
- Gitarrenverstärker Fender
- Gitarrenverstärker Behringer
- Gitarrenverstärker Boss
- Gitarrenverstärker Line 6
- Gitarrenverstärker Radial Engineering
- Gitarrenverstärker Hartke
- Gitarrenverstärker ART
- Gitarrenverstärker Harley Benton
- Gitarrenverstärker Electro Harmonix
- Gitarrenverstärker Blackstar
- Gitarrenverstärker Bugera
- Gitarrenverstärker TC Electronic
- Gitarrenverstärker Palmer
- Gitarrenverstärker Ampeg
- Gitarrenverstärker Laney
- Gitarrenverstärker SPL
- Gitarrenverstärker Ashdown Engineering
- Gitarrenverstärker AER
- Gitarrenverstärker Markbass
- Gitarrenverstärker EBS
- Gitarrenverstärker Fishman
- Gitarrenverstärker Voodoo Lab
- Gitarrenverstärker GR Bass
- Gitarrenverstärker Two Notes
- Gitarrenverstärker Hughes & Kettner
- Gitarrenverstärker Dimavery
- Gitarrenverstärker AMT
- Gitarrenverstärker Budda
- Gitarrenverstärker Empress Effects
- Gitarrenverstärker DACS Audio
- Gitarrenverstärker Rivera
- Gitarrenverstärker DV Mark
Neueste Bedienungsanleitung für -Kategorien-
3 Oktober 2024
3 Oktober 2024
3 Oktober 2024
3 Oktober 2024
3 Oktober 2024
19 September 2024
16 September 2024
6 September 2024
5 September 2024
5 September 2024