La Crosse Technology WT-8029U-IT Bedienungsanleitung
La Crosse Technology
Uhr
WT-8029U-IT
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für La Crosse Technology WT-8029U-IT (9 Seiten) in der Kategorie Uhr. Dieser Bedienungsanleitung war für 7 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/9
1
WT-8029U
RADIO-CONTROLLED SOLAR CLOCK
INSTRUCTION MANUAL
Contents
Languages Page
__________________________________________
English 2
French 18
Spanish 36
2
LCD1
displa
y
Battery cover
Wall Mount
Location
LCD2
display
Foldable
stands
Sola
r
panel
TABLE OF CONTENTS
Topic Page
Features 3
Battery Installation 3
Setting Up 5
Atomic time - WWVB Radio Controlled Time 5
Function keys 6
LCD Screen 7
Manual Settings 7
Alarm setting and snooze 11
Mounting 12
Care and maintenance 14
Specifications 15
Warranty 16
FEATURES:
RADIO-CONTROLLED SOLAR CLOCK:
Function keys
3
WWVB Radio controlled time with manual time setting
Time display: hour, minute, second
12/24h time format display
Alarm setting with snooze function
Calendar display
Weekday display (4 languages to choose from: English,
Spanish, French, German)
Time zone setting
Daylight savings time ON/OFF option (DST)
Solar mode setting
Indoor temperature display in ºF/ ºC selectable
Indoor humidity display in RH%
Primary Alkaline battery or rechargeable Alkaline battery
selection
Low battery indicator
Wall mount or freestanding
TO INSTALL / REPLACE BATTERY
The solar clock can use either the included 1 x alkaline
rechargeable battery (charged by solar panel) or 1 x AA
alkaline battery (non-rechargeable; not included).
INITIAL SETUP
It is very important to follow these steps:
1. First, remove the label covering over the battery
compartment on the back.
2. Open the battery compartment, and MAKE SURE that
the battery switch is in the BATTERY position (not the
SOLAR position).
Battery switch in the BATTERY position
3. Now locate the battery insulator tab, and gently pull to
remove it.
4. Slide the battery switch to the SOLAR position
5. Battery switch in the SOLAR position
6. Continue to section titled “Setup After
Changing/Installing the Battery”
4
TO INSTALL / REPLACE BATTERY
The included alkaline rechargeable battery should provide you
with many years of service. If your battery needs to be
replaced, we suggest you use a fully charged AA Alkaline.
Rechargeable batteries should be fully charged before inserting
into clock. Alkaline rechargeable batteries are
recommended.
If you choose to use a non-rechargeable battery, the battery
switch MUST be moved to the BATTERY position (not the
SOLAR position). In this position, the solar cells do not charge
the battery.
REGARDLESS OF THE TYPE OF BATTERY INSTALLED,
THE BATTERY SWITCH MUST BE IN THE BATTERY
POSITION WHEN THE BATTERY IS INSERTED.
If a rechargeable battery is used, the Battery switch should
be moved to the SOLAR position AFTER it is has been
inserted.
To use the included rechargeable Alkaline battery
(charged by solar panel):
1. It is important to allow sufficient light to reach the solar
panel while activating the solar clock. Make sure the
lights are on in the setup room and the solar panel is
facing a 60W light bulb or brighter - do not cover with
hands or other objects.
2. Replace battery cover
3. Remove the black protective foil on the solar panel.
DO NOT SET THE CLOCK.
To use a non-rechargeable Alkaline battery:
1. Remove the included rechargeable AA battery from the
compartment.
2. Use the switch to select the alkaline battery (see below).
5
3. Insert 1 x AA Alkaline battery into the compartment,
observing the correct polarity (see marking inside battery
compartment.
4. Replace battery cover
DO NOT SET THE CLOCK.
Note: For best performance, batteries should be replaced at
least once every 2 years to maintain the best running accuracy.
Ensure that the batteries used are new and the correct size.
Please help in the preservation of the
environment and return used batteries to an
authorized depot.
SETUP AFTER CHANGING/REPLACING THE
BATTERY
1. After powering up the solar clock, all LCD segments will
light up briefly and it will show the time (12:00), indoor
temperature, date, and indoor humidity.
Use switch to
select which
type of battery
will be used
before
inserting the
battery into
the
compartment
Battery
compartment
cover
Rechargeable Alkaline
battery switch position
Primary Alkaline
battery switch position
6
2. Next the WWVB time code reception will automatically
start. This reception typically takes 10 minutes in good
conditions. If after 10 minutes the WWVB time has not
been received, use the “SET” key to enter the set-up
mode to manually set the Time, Time Zone and Date
(see manual settings below). The clock will continue to
search for WWVB each hour between 12am and 6am.
When the clock has successfully connected with WWVB,
it will override the manually set time and date.
Note: When changing the battery:
1. Be careful that it does not spring free from the
contacts.
2. Press any button 20 times with the battery
removed.
3. Always wait at least 10 minutes after removing
battery before re-inserting; otherwise start up
problems may occur.
WWVB RADIO CONTROLLED TIME
The NIST radio station, WWVB, is located in Ft. Collins,
Colorado and transmits the exact time signal continuously
throughout the United States at 60 kHz. The signal can be
received up to 2,000 miles away through the internal antenna in
the atomic clock. However, due to the nature of the Earth’s
Ionosphere, reception is very limited during daylight hours. The
atomic clock will search for a signal every night when reception
is best. The WWVB radio station derives its signal from the
NIST atomic clock in Boulder, Colorado. A team of atomic
physicists continually measures every second of every day to
an accuracy of ten billionths of a second a day. These
physicists have created an international standard, measuring a
second as 9,192,631,770 vibrations of a Cesium 133 atom in a
vacuum. This atomic clock regulates the WWVB transmitter.
After 15 minutes the WWVB tower icon in the clock display will
start flashing in the top center of the LCD. This indicates the
clock has detected a radio signal and is trying to receive it.
When the time code is received, the WWVB tower becomes
permanently lit and the time will be displayed.
Produktspezifikationen
| Marke: | La Crosse Technology |
| Kategorie: | Uhr |
| Modell: | WT-8029U-IT |
Brauchst du Hilfe?
Wenn Sie Hilfe mit La Crosse Technology WT-8029U-IT benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Uhr La Crosse Technology
4 Oktober 2024
4 Oktober 2024
2 Oktober 2024
2 Oktober 2024
30 September 2024
27 September 2024
24 September 2024
22 September 2024
21 September 2024
20 September 2024
Bedienungsanleitung Uhr
- Uhr Samsung
- Uhr Hama
- Uhr Nedis
- Uhr Profile
- Uhr Camry
- Uhr Velleman
- Uhr IKEA
- Uhr ADE
- Uhr Alecto
- Uhr Auriol
- Uhr Cresta
- Uhr Denver
- Uhr Dexford
- Uhr ECG
- Uhr Eurochron
- Uhr Gira
- Uhr Irox
- Uhr Jacob Jensen
- Uhr König
- Uhr MarQuant
- Uhr Mebus
- Uhr Sempre
- Uhr Techno Line
- Uhr Technoline
- Uhr TFA
- Uhr Trevi
- Uhr Weinberger
- Uhr Braun
- Uhr SEG
- Uhr Tronic
- Uhr Geemarc
- Uhr Muse
- Uhr Elro
- Uhr Livoo
- Uhr Jaguar
- Uhr Lotus
- Uhr Michael Kors
- Uhr Casio
- Uhr Citizen
- Uhr United Office
- Uhr Balance
- Uhr Fysic
- Uhr Karlsson
- Uhr Krontaler
- Uhr Mondaine
- Uhr Fisher-Price
- Uhr Lenovo
- Uhr Xiron
- Uhr Suunto
- Uhr Globaltronics
- Uhr Ascot
- Uhr Zuiver
- Uhr Hager
- Uhr Edox
- Uhr Lorus
- Uhr Huawei
- Uhr JUNG
- Uhr Lexon
- Uhr Ranex
- Uhr Kogan
- Uhr Audiovox
- Uhr Salter
- Uhr Davis
- Uhr Diesel
- Uhr Invicta
- Uhr Orient
- Uhr Zenith
- Uhr Vitek
- Uhr Elation
- Uhr RCA
- Uhr AV:link
- Uhr McIntosh
- Uhr ART
- Uhr Oregon Scientific
- Uhr Digi-tech
- Uhr Dormakaba
- Uhr Ecom
- Uhr Gingko
- Uhr Global Tronics
- Uhr Glunz
- Uhr Hermle
- Uhr IHome
- Uhr La Crosse
- Uhr Lydion
- Uhr QQ
- Uhr Taylor
- Uhr World Timer Chronograph
- Uhr TFA Dostmann
- Uhr Equity
- Uhr AcuRite
- Uhr DB Technologies
- Uhr Amplicom
- Uhr Electronics International
- Uhr Chacon
- Uhr Pyramid
- Uhr Focus Electrics
- Uhr Antelope Audio
- Uhr ASA
- Uhr CyberData Systems
- Uhr Antelope
- Uhr Accusplit
- Uhr Balance Time
- Uhr Valcom
- Uhr BBrain
- Uhr Bearware
Neueste Bedienungsanleitung für -Kategorien-
7 Oktober 2024
6 Oktober 2024
5 Oktober 2024
3 Oktober 2024
17 September 2024
16 September 2024
9 September 2024
7 September 2024
6 September 2024
6 September 2024