Kramer 617R Bedienungsanleitung

Kramer Audio-/Video-Extender 617R

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Kramer 617R (4 Seiten) in der Kategorie Audio-/Video-Extender. Dieser Bedienungsanleitung war für 7 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/4

Installation Instructions

MODELS:

617T, 617R

4K HDR HDMI Tx/Rx over Extended-Reach

Mul-Mode Fiber Opc Cable

SAFETY WARNING

Disconnect the unit from the power supply before opening and servicing

For the latest information products a list Kramer distributors, visit Web site where on our and of our

updates to this user manual may be found.

We welcome your questions, comments, and feedback.

www.KramerAV.com

info@KramerAV.com

P/N:

2900- 301021

Rev:

617T 617R, 4K HDR HDMI Tx/Rx over Extended-Reach Multi-Mode Fiber

Optic Cable

Congratulations on purchasing your Kramer Plug and Play active 4K HDR HDMI 617T and 617R

Tx/Rx over Extended-Reach Multi-Mode (MM) Fiber Optic cable. extend signals of up 617T and 617R

to @60Hz (4:4:4), over a distance of up to 24096 160x2 00m ( ) without signal scaling or data 656ft

compression, providing a maximum data rate of Gbps. easily and securely 18 617T and 617R are

connected via a 2LC ﬁber connector and can be powered from the USB connector Alternatively, . 617T

only can be powered from the HDMI interface (pin # 18).

Figure 1 617T Transmitter and 617R Receiver :

Safety

Caution:

There are no operator serviceable parts inside the unit.

Warning:

Disconnect the power and unplug the unit from the wall before installing.

Warning:

Avoid direct eye exposure into the optic connectors when powered,

although this product is regulated strictly enough to operate under the

Laser Class 3R for eye safety.

See www.KramerAV.com for updated safety information.

Installation

To install and : 617T 617R

1. Unpack the contents of the package with care.

We recommend that you save the original box and packaging materials for possible future

shipment.

2. Turn on the power to the HDMI source (for example, a laptop) and acceptor (for example, a

display).

3. Power the :617T and 617R

• Connect the micro USB connector on each device to a USB cable (supplied).

• Connect the USB cable either to the wall-mount power adapter (supplied) and to the

mains, or to a USB port.

T POWER LED lights and the STATUS LED ﬂashes three times. he

Although can be powered via pin # the HDMI interface, we 617T 18 on

recommend that you use the USB power adapter.

617R can only be powered via the USB power adapter.

4. Connect the two LC optical ﬁbers between 617T and 617R.

Connect (A) to (A) and (B) to (B). Make sure that the duplex connectors are connected

properly.

The STATUS LED ﬂashes.

Do not look directly into the LC connectors on the (the transmitter side) 617T

when it’s powered.

This product operates under LASER Class I, classiﬁed by CDRH/FDA for eye

safety.

We recommend that you avoid using intermediate cables or adapters. Using

them may aﬀect the transmission quality.

5. Connect to the MI connector on the source side on the acceptor side. 617T HD and 617R

Make sure that the is always connected to the source side and the 617T

617R is connected to the acceptor side.

Once the system is connected the Status LEDs on both ﬂash. 617T and 617R

Troubleshooting

If the display appears black:

• Check that the power source adapters are properly connected on both sides.

• Check that both HDMI connector heads fully plugged into the devices. are

• Check that the source and display devices are both switched on.

• Reset the system by disconnecting and then reconnecting the , or by 617T or 617R

disconnecting and then reconnecting the power adapters.

• Reboot the system.

Produktspezifikationen

Marke:	Kramer
Kategorie:	Audio-/Video-Extender
Modell:	617R
Breite:	26 mm
Tiefe:	72 mm
Gewicht:	120 g
AC-Netzadapter:	Ja
Mitgelieferte Kabel:	USB
Produktfarbe:	Schwarz
Übertragungstechnik:	Kabelgebunden
Höhe:	15 mm
Betriebstemperatur:	0 - 50 °C
Relative Luftfeuchtigkeit in Betrieb:	0 - 85 %
Verpackungsbreite:	193 mm
Verpackungstiefe:	253 mm
Verpackungshöhe:	620 mm
Paketgewicht:	1480 g
Zertifizierung:	CE: EN 55032:2012/AC: 2013 (A), EN 61000–3–2:2014, EN 61000–3–3:2013, EN 55024:2010\nFCC: CFR 47 15 SUBPART B B, 15.101
Stromverbrauch (Standardbetrieb):	2.5 W
Typ:	AV-Sender & -Empfänger
Temperaturbereich bei Lagerung:	-30 - 70 °C
HDCP:	Ja
USB-Stecker:	Mikro-USB
Anzahl der USB-Anschlüsse:	2
Maximale Auflösung:	4096 x 2160 Pixel
HDMI-Version:	2.0
Nachhaltigkeitszertifikate:	RoHS
Maximal mögliche Übertragungsstrecke:	200 m
Arbeitsspannung:	5 V
Bandbreite:	6 Gbit/s
HDCP-Version:	2.2
Optischer Kabelverbinder:	LC
Kabel mode struktur:	Multi-Modus
Consumer Electronics Control (CEC) Unterstützung:	Ja
Erweiterte Display-Identifikationsdaten (EDID):	Ja