Kicker SubStage SSIEXT07 Bedienungsanleitung

Kicker Subwoofer SubStage SSIEXT07

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Kicker SubStage SSIEXT07 (10 Seiten) in der Kategorie Subwoofer. Dieser Bedienungsanleitung war für 16 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/10
1
SSIEXT07
Designed for 2007 and newer GM® Silverado/Sierra Extended Cab vehicles
(Not compatible with vehicles equipped with the full-width rear bench)
Subwoofer Assembly
Subwoofer Power Harness
Subwoofer Body Harness
Wire Taps x2
25A Fuse
Wire Ties x6
Adaptor Harness
©2012 Stillwater Designs
SSIEXT07-A.2-20121213
2
Installation
1. Disconnect the negative battery cable from the battery. (For diesel engines with dual batteries disconnect
both negative cables)
2. Remove cover on the driver’s end of the dash. Fig. 1
3. Remove the bolt securing the parking brake release lever. Some trucks may not have a release lever but
there is still a bolt in that location that needs to be removed. Fig. 2
4. Remove the two screws securing the panel below the steering column and pull the panel loose. Fig. 2
5. Remove the two screws securing the panel below the radio and pull the panel loose.
6. Pull loose the radio bezel and disconnect wiring. Fig. 3
7. Remove the six screws securing the radio and HVAC controls. HVAC control wiring does not need to be
disconnected. Fig. 4
8. Pull radio from dash and disconnect all wiring.
9. Route the signal input wire with the white two pin connector on it along the driver’s side of the vehicle and
up to the driver’s kick panel or radio opening depending on installation. (If vehicle is equipped with the
Factory Premium sound system, refer to the instructions for Factory Premium sound system for signal wire
routing and connection.)
Subwoofer Input Connection with Optional Amplifi er
10. Connect the white two pin connector of the amplifi er harness to the corresponding connector of the
subwoofer harness.
3
Subwoofer Input Connection without Optional Amplifi er and without Factory Premium Audio
11. Connect the six inch adaptor harness to the end of the two pin connector. Locate position 2 and 9 on
the radio connector and install one of the blue wire taps onto the wire. Lay the wire in the open channel, fold
the wire tap over and squeeze with a pair of pliers until it snaps shut. Connect the green wire of the adaptor
harness to the wire in position 2 and the brown wire to the wire in position 9. Fig. 7
Subwoofer Input Connection with Factory Premium Audio
12. Pry loose the storage tray in the center console. Fig. 5
13. Starting at the end of the subwoofer harness that was routed toward the dash, carefully cut the
sheathing back about 30 inches. Fig. 6
14. Pull the signal wire out and route it under the carpet and into the center console. Connect the six inch
adaptor harness to the end of the two pin connector. Locate the blue with a white stripe wire and the green
with a black strip wire. Install one of the blue wire taps onto each wire. Lay the wire in the open channel, fold
the wire tap over and squeeze with a pair of pliers until the wire tap snaps shut. Fig. 7
15. Connect the green wire of the adaptor harness to the blue/white wire and the brown wire of the adaptor
harness to the green/black wire. Fig. 8
NOTE: Remember to place your warranty card in the glove box for future use.


Produktspezifikationen

Marke: Kicker
Kategorie: Subwoofer
Modell: SubStage SSIEXT07

Brauchst du Hilfe?

Wenn Sie Hilfe mit Kicker SubStage SSIEXT07 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Subwoofer Kicker

Bedienungsanleitung Subwoofer

Neueste Bedienungsanleitung für -Kategorien-