Kicker Solo-Baric S10L7 Bedienungsanleitung

Kicker Subwoofer Solo-Baric S10L7

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Kicker Solo-Baric S10L7 (11 Seiten) in der Kategorie Subwoofer. Dieser Bedienungsanleitung war für 30 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/11
Owner’s Manual | English
Manual del Propietario | Español
SOLO-BARIC® ALTAVOZ PARA SONIDOS GRAVES
Benutzerhandbuch | Deutsch
SOLO-BARIC® TIEFTÖNER
Manuel d’utilisation | Française
SOLO-BARIC® HAUT-PARLEUR D’EXTRÊMES GRAVES
SOLO-BARIC® SUBWOOFER
S8L7 | S10L7 | S12L7 | S15L7
2011 L7 Multilingual Rev B.indd 1
2011 L7 Multilingual Rev B.indd 1
2011 L7 Multilingual Rev B.indd 1
2011 L7 Multilingual Rev B.indd 12011 L7 Multilingual Rev B.indd 1 9/9/2010 3:15:41 PM
9/9/2010 3:15:41 PM
9/9/2010 3:15:41 PM
9/9/2010 3:15:41 PM9/9/2010 3:15:41 PM
2
B
Use
“tem
line.
pan
All t
enc
des
the
1.5”
ft3, a
Figu
bac
SPECIFICATIONS
WIRING
Solo-Baric L7 subwoofers are available with dual 2 (ohm) or dual 4 voice coils. Both coils must be  
connected to a source of amplifi cation. The dual 2 woofer will generate a 1 load if the coils are wired  
in parallel or a 4 load in series. The dual 4 woofer will provide a 2 load wired in parallel or 8 load  
wired in series. The terminals with the white dots are for the rst voice coil. The terminals with solid-red
and solid-black markings are for the second voice coil. See Figure 1.
SOLO-BARIC L7 SUBWOOFER
OWNER’S MANUAL
Authorized KICKER Dealer:
Purchase Date:
Speaker Model Number:
Speaker Serial Number:
Model S8L7 S10L7 S12L7 S15L7
Nominal Impedance [Zn], ohm 2 or 4 2 or 4 2 or 4 2 or 4
Resonance Frequency [fs], Hz 47.2 37.5 34 26.3
Power Handling Watts, Peak (RMS) 900 (450) 1200 (600) 1500 (750) 2000 (1000)
Sensitivity [SPLo], dB @ 1W, 1m 82.37 85.87 86.90 88.56
Effective Excursion [EXmax™], in (mm) .48 (12.2) .55 (13.9) .56 (14.1) .63 (16.1)
DC Resistance [Re], ohm 6.6 7.9 6.8 7.0
Mechanical Q-Factor [Qms] 8.828 9.791 9.488 11.868
Electrical Q-Factor [Qes] .802 .535 .571 .565
Total Q-Factor [Qts] .735 .507 .539 .539
Equivalent Volume [Vas], ft³ (L) .322 (9.127) 1.0 (28.347) 1.916 (54.274) 5.263 (149.048)
Outer Frame Diameter, in (cm) 8-3/16 (22.4) 10-11/16 (27.1) 12-5/8 (32) 15-5/8 (39.7)
Hole Cut-Out Diameter, in (cm) 7-1/4 (18.4) 9-5/16 (23.7) 11-1/16 (28.1) 13-3/4 (34.9)
Mounting Depth, in (cm) 4-3/4 (12.1) 6-1/4 (15.9) 6 13/16 (17.3) 8 11/16 (22.1)
S8L7 / S10L7 / S12L7 / S15L7Models:
Note: All specifi cations and performance gures are subject to change. Please visit www.kicker.com for the most
current information. To get the best performance from your new KICKER Subwoofer, we recommend using genuine
KICKER Accessories and Wiring. Please allow two weeks of break-in time for the subwoofer to reach optimum
performance.
Figu
Cut
coil
coil
Sound Check: Poor bass response? Check the system phasing by reversing the positive and negative
speaker connections on the subwoofer. If the bass improves, then the subwoofer was out of phase in
reference to the rest of the audio system.
2011 L7 Multilingual Rev B.indd 2-3
2011 L7 Multilingual Rev B.indd 2-3
2011 L7 Multilingual Rev B.indd 2-3
2011 L7 Multilingual Rev B.indd 2-32011 L7 Multilingual Rev B.indd 2-3
4
Do not install a port opening against a solid surface, such as an internal brace, back-panel or trunk wall,
seat or interior panel of your vehicle. The port opening must remain unobstructed. Use the smallest
dimension of the rectangular port as the minimum amount of space between the port opening and any
solid surface to insure unrestricted air ow.
If you prefer an ultra-smooth bass response, you should loosely ll your L7 enclosure with poly-fi l
stuffi ng. Ported designs will require covering the end of the port (located inside the box) with grill cloth,
chicken wire, or expanded metal to prevent the poly-fi l from exiting the port. The use of poly-fi l will slightly
decrease effi ciency, but will deepen and extend the low frequency output.
For more advice on box building, refer to your Authorized Kicker Dealer, or click on the Support tab on
the Kicker homepage, www.kicker.com. Please e-mail support@kicker.com or call Technical Support at
(405) 624-8583 for specifi c or unanswered questions.
V
The
If sp
des
any
limit
freq
The
Alth
con
outp
des
D
D D
Figure 3 Figure 4
D = 3” x 3” for S12L7, S15L7
D = 2” x 2” for S8L7, S10L7
Ve
Bo
Po
Po
Po
Ve
Bo
Po
Po
Po
SEALED ENCLOSURE APPLICATIONS
Model Volume ft3 (L) Panel A in. (cm) Panel B in. (cm) Panel C in. (cm)
S8L7 .5 (14.16) 11X11 (27.9X27.9) 11x9.5 (27.9x24.1) 9.5x9.5 (24.1x24.1)
S10L7 1 (28.32) 13.5X13.5 (34.3X34.3) 13.5x12 (34.3x30.5) 12x12 (30.5x30.5)
S12L7 1.25 (35.4) 14.5X14.5 (36.8X36.8) 14.5x13 (36.8x33) 13x13 (33x33)
S15L7 2 (56.64) 16.5x16.5 (42x42) 16.5x15 (42x38.1) 15x15 (38.1x38.1)
Model Volume ft3 (L) Power Handling
S8L7 .5 (14.16) 200W RMS
S10L7 1 (28.32) 600W RMS
S12L7 1.25 (35.4) 750W RMS
S15L7 2 (56.64) 1000W RMS
Model Volume ft3 (L) Power Handling
S8L7 .75 (21.24) 200W RMS
S10L7 1.25 (35.4) 600W RMS
S12L7 2 (56.64) 750W RMS
S15L7 6 (169.9) 1000W RMS
Panel Dimensions for Compact Sealed Enclosures using 3/4” (1.9cm) thick MDF (See Figure 5)
Sealed Compact Sealed SQ
The
than
exc
box
the
at th
des
acc
leve
The
syst
enc
app
insta
very
the
Solo
reco
bas
reco
have
All s
the
2011 L7 Multilingual Rev B.indd 4-5
2011 L7 Multilingual Rev B.indd 4-5
2011 L7 Multilingual Rev B.indd 4-5
2011 L7 Multilingual Rev B.indd 4-52011 L7 Multilingual Rev B.indd 4-5


Produktspezifikationen

Marke: Kicker
Kategorie: Subwoofer
Modell: Solo-Baric S10L7

Brauchst du Hilfe?

Wenn Sie Hilfe mit Kicker Solo-Baric S10L7 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Subwoofer Kicker

Bedienungsanleitung Subwoofer

Neueste Bedienungsanleitung für -Kategorien-