Keurig K-Latte Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Keurig K-Latte (7 Seiten) in der Kategorie Kaffeemaschine. Dieser Bedienungsanleitung war für 2 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/7
Use & Care Guide
10
8
6
oz
SHOT
oz
oz
LAT T E
Get the most from your
new Keurig® brewer
LID
WHISK
FROTHER
MAX
MIN
MAX
Remove pcking tpe from brewer nd frother,
nd plug into  grounded outlet. Lower the
frother bse on the side of the brewer.
Plce  lrge mug (10oz minimum) on the
drip try.
Remove the water reservoir lid, then lift the reservoir
straight up to remove it.
Rinse reservoir with fresh water and fill to the
MAX fill line.
Replace water reservoir, making sure the lock tabs
engage with the brewer. Replace lid.
NOTE: Do not use distilled water.
Press power button - the green power light will
illuminate.
The brewer will automatically begin heating the
water. This will take about 4 minutes. Once the
heating sound stops, the brewer is ready.
Remove the lid and whisk from inside the frother. Wash
the interior of the frother, lid, and whisk with warm,
soapy water. Dry all parts thoroughly using a soft, non-
abrasive cloth, then reassemble.
NOTE: Frother is not dishwasher safe. Do not submerge frother in water. Only
use non-abrasive cleaning materials to prevent damage to the inner surface
of the frother. Dry interior of frother and base with a soft cloth after cleaning.
Lift and lower the handle. Do not insert a K-Cup® pod.
The three brew buttons and SHOT button will blink.
Press the 6oz button to start a cleansing brew. Pour the
hot water into the sink.
The one-time setup process is now complete and you are
ready to brew!
NOTE:
Between brew cycles, the brewer may take about a minute to reheat.
1
4
3
2
5
Before You Brew
Add Water
10
8
6
oz
SHOT
oz
oz
LATTE
Plug & Place Rinse & Fill
Power On
Clean the Frother
Cleansing Brew
Add t e rWa
10
8
6
oz
SHOT
oz
oz
LATT E
10
8
6
oz
SH OT
oz
oz
LATTE
4
Add Water
10
8
6
oz
SHOT
oz
oz
LATTE
Place Mug & Pod
Place a mug on the drip tray. Lift the
handle and place any K-Cup® pod in the
K-Cup® pod holder. Lower the handle
completely to close the lid.
Do not remove the foil lid on the
K-Cup® pod.
12
Make Your First Latte
Fill Frother
Remove lid and add chilled milk to the MAX line
marked in the frother. Replace the lid and place
the frother on the frother base.
Press the power button on the frother.
The button will illuminate while heating –
approximately 3 minutes. Frothing is complete
when the button flashes and then turns off.
TIP: Having trouble frothing? We’re here to help.
Give us a call at 1-866-901-BREW (2739).
CAUTION:
Frother is not microwave or dishwasher safe.
NOTE: Do not under or overfill frother. Do not operate before adding milk.
10
8
6
oz
SHOT
oz
oz
LATT E
Add terWa
Remove the frother from the base. Remove
the lid and pour the frothed milk over your
shot of coffee.
NOTE: Clean frother immediately after use. For
cleaning instructions, see Caring for your Brewer
section in this guide.
The three brew buttons and SHOT button will blink.
Press the SHOT button. Brewing is complete when the
SHOT button is no longer illuminated. Lift the handle
and dispose of the used K-Cup® pod.
NOTE: After 60 seconds, the brew buttons will be disabled. To
re-activate, lift and lower the handle completely.
CAUTION: While brewing, there is extremely hot water in the
K-Cup pod holder. To avoid injury, do not lift the handle during the ®
brewing process.
34
Brew a Shot
Ad d te rWa
10
8
6
oz
SHOT
oz
oz
LAT T E
Create Your Latte
6
oz
1
Brew Your First Coffee
Place a mug on the drip tray plate. If
using a travel mug, remove the drip
tray and place the mug on the drip
tray base. Lift the handle and place a
K-Cup® pod in the K-Cup® pod holder.
Lower the handle completely to close
the lid.
Do not remove the foil lid on the
K-Cup® pod.
High Altitude Brewing: While holding the
brewer handle up, push down slowly on
the K-Cup® pod in the pod holder until the
bottom of the K-Cup® pod is punctured by
the exit needle.
Place Mug & Pod
Brewer Features
Frother froths milk to create your favorite latte.
SHOT button brews a shot of coffee to make delicious,
creamy lattes.
Auto Off automatically turns your brewer off 2 hours
after the last brew for energy savings.
10
8
6oz
SH OT
oz
oz
LATTE
Add terWa
2
Select your brew size. The button will remain
illuminated while brewing — about 1 minute.
Brewing is complete when the button is no
longer illuminated. Lift the handle and dispose
of the used K-Cup® pod.
The brewer will be ready to brew another cup
in about a minute.
NOTE: After 60 seconds, the brew buttons will be disabled. To re-
activate, lift and lower the handle completely.
CAUTION: While brewing, there is extremely hot water in the
K-Cup® pod holder. To avoid injury, do not lift the handle during the
brewing process.
Brew & Enjoy!
Add terWa
10
8
6
oz
SHOT
oz
oz
LATTE
Caring For Your Brewer
Regular cleaning keeps your brewer running smoothly. Always be sure to turn off and unplug your brewer before cleaning.
Add terW a
10
8
6
oz
SH OT
oz
oz
LATTE
Water Reservoir & Reservoir Lid
The water reservoir lid and water reservoir
should be cleaned periodically. Clean in a
dishwasher (top rack only) or hand wash. To
hand wash, use a damp, soapy, non-abrasive
cloth. Rinse the reservoir thoroughly after
cleaning. This will ensure that no cleaning
solutions remain in the area as they may
contaminate the water supply. After rinsing, fill
the reservoir with clean water and return it to
the brewer. Do not dry the inside of the water
reservoir with a cloth as lint may remain. If
needed, repeat above procedures.
NOTE: If you are using a water filter inside the water reservoir, remove it
before cleaning.
Frother
Clean immediately after each use and before
first use.
To Clean:
1. Remove frother from the base, remove
silicone ring from lid, and remove the whisk
from inside the frother.
2. Wash the silicone ring, lid, and whisk with
warm, soapy water.
3. Clean the interior of the frother with soap
and rinse with warm water. Use a soft, non-
abrasive cloth or sponge to prevent damaging
the inner coating.
4. Wipe the exterior with a soft, damp cloth.
5. Dry all parts thoroughly and reassemble for
next use.
NOTE: Frother is not dishwasher safe. Do not submerge frother in water. Only use
non-abrasive cleaning materials to prevent damage to the inner surface of the
frother.
Drip Tray
The drip tray can hold up to 8 ounces of overflow
and should be emptied and cleaned occasionally.
To remove, slide it toward you, keeping it level to
avoid spilling. Clean in dishwasher (top rack only)
or rinse and clean with a damp, soapy, lint-free,
non-abrasive cloth.
Brewer Exterior
Keep your Keurig® brewer looking its best by
cleaning the exterior from time to time. Just
clean with a damp, soapy, lint-free, non-
abrasive cloth. Never immerse the brewer in
water or other liquids.
LID
WHISK
FROTHER
Smart Start heats then brews in one simple process. No need
to wait for the brewer to heat before selecting brew size.
Power on your brewer, place mug, insert a K-Cup® pod, and
lower the handle. Then, select your brew size. The brewer will
heat, then automatically begin brewing.


Produktspezifikationen

Marke: Keurig
Kategorie: Kaffeemaschine
Modell: K-Latte

Brauchst du Hilfe?

Wenn Sie Hilfe mit Keurig K-Latte benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Kaffeemaschine Keurig

Bedienungsanleitung Kaffeemaschine

Neueste Bedienungsanleitung für -Kategorien-