JL Audio PS-SWMCP Bedienungsanleitung

JL Audio Lautsprecher PS-SWMCP

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für JL Audio PS-SWMCP (3 Seiten) in der Kategorie Lautsprecher. Dieser Bedienungsanleitung war für 39 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/3
Installation Instructions for all
PS-SWMCP
swivel fixtures for round pipes
P I PE M O UN T I N G FIX T URE S ( S W I V EL)
FOR PS650VeX™ ENCLOSED SPEAKER SYS TEMS
NOTE: The PS-SWMCP-B-2.000 Fixture and PS650-VeX-SG-TMB Enclosed Speaker
System are used in this manual for illustrative purposes only. The fixture installation
steps are the same for all PS650-VeX Enclosed Speaker Systems and all PS-SWMCP
swivel fixtures for round pipes.
LIMITED WARRANTY  MARINE PRODUCTS USA
JL AUDIO warrants this product to be free of defects in materials and workmanship for a period of two (2) years from the
original date of purchase.
This warranty is not transferable and applies only to the original purchaser from an authorized JLAUDIO dealer. Should service
be necessary under this warranty for any reason due to manufacturing defect or malfunction, JL AUDIO will (at its discretion),
repair or replace the defective product with new or remanufactured product at no charge. Damage caused by the following is not
covered under warranty: accident, misuse, abuse, product modification or neglect, failure to follow installation instructions,
unauthorized repair attempts, misrepresentations by the seller. This warranty does not cover incidental or consequential damages
and does not cover the cost of removing or reinstalling the unit(s). Cosmetic damage due to accident or normal wear and tear is not
covered under warranty.
Any applicable implied warranties are limited in duration to the period of the express warranty as provided herein beginning
with the date of the original purchase at retail, and no warranties, whether express or implied, shall apply to this product
thereafter. Some states do not al low limitations on impl ied warranties, therefore these exclusions may not apply to you. This
warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
For Service Information in the U.S.A. please call
JL Audio Customer Service: (954) 443-1100
9:00 AM – 5:30 PM (Eastern Time Zone)
JL Audio, Inc
10369 North Commerce Pkwy.
Miramar, FL 33025, USA
International Warranties:
Products purchased outside the United States of America are covered only
by that country’s distributor and not by JL Audio, Inc.
w w w . j l a u d i o . c o m
JL Audi o® and the JL Audi o logo are re gistered t rademar ks of JL Audi o, Inc. “Ahead of t he Curve” an d its respe ctive lo go is a trade mark of JL Audio, Inc.
©2016 JLAudio, Inc. • For more det ailed inf ormation please visit us online at w ww.jlaudio.com. Due to our policy of continuo us produc t develop ment, all sp ecifications are su bject to change witho ut notice.
SKU# 011498
Printed in U.S.A. • 092817
Mounting Fixture is made in the USA by Axia Alloys
Protected by US Patents #8,136,771 & #8,398,035
Included Hardware: BOM ID Quantity Description
1 4 Axia Alloys Strap Clamp
2 6 M6 x 16 mm Socket Cap Machine Screw
3 2 M4 x 4 mm Set Screw (pre-installed)
4 4 M6 Nylon Insert Locknut
5 2 Clamp Receiver
6 1 Loctite® Red read-Locking Compound
7 4 M6 Flat Washer
8 4 M6 x 45 mm Socket Cap Machine Screw
9 1 Plastic Strip
10* 2 Fixture Base
11* 1 Silicone Adhesive
12* 12 #8 Flat Washer
13* 12 #8 x 1-1/4” Pan Head Screw
* Included with VeX™ speaker enclosures.
(hardware pictured for one)
Note: Not all wires may be used in normal applications.
Wire Size Wire Color Use
16 AWG Red/Stripe Speaker Positive (+)
Black/Stripe Speaker Negative (–)
20 AWG
Red Not Used
Green Not Used
Blue LED Positive (+)
Yellow LED Negative (–)
Wire Size Wire Label Use
16 AWG “ ”+Speaker Positive (+)
N/A Speaker Negative (–)
For Premium Models:
For Standard Models:
Loosen the pre-installed M4 x 4 mm Set Screw in the
clamp receiver. Slide an M6 x 16 mm Machine Screw
through the center hole of the clamp receiver, into the
center hole in the xture base, and hand tighten.
1
If you wish to rotate the speaker’s grille/logo badge
alignment, remove the six #8 x 1-1/4” speaker mounting
screws and #8 Flat Washers.
9
Apply Loctite® red thread-locking compound to two M6
x 16 mm Machine Screws, slide them through the slots
in the clamp receiver, into the appropriate holes in the
xture base, and fully tighten.
5
Secure the clamps to the clamp receiver using a pair of
M6 x 45 mm Machine Screws, M6 Flat Washers, and M6
Locknuts as illustrated. e locknut should be installed
into the hex shaped recess on one end of each clamp.
Hand-tighten, allowing just enough freedom to rotate the
enclosure around the pipe.
3
Realign the clamps with the clamp receiver on the
enclosure, and secure them to the clamp receiver using a
pair of M6 x 45 mm Machine Screws, M6 Flat Washers,
and M6 Locknuts as illustrated, and fully tighten. Note:
e locknut should be installed into the hex shaped
recess on one end of each clamp.
7
Place the supplied plastic strip around the pipe to
prevent scratching. Push the clamps over the pipe
(remove the plastic strip). Align the clamps with the
clamp receiver on the enclosure.
2
Remove the center M6 x 16 mm Machine Screw from the
clamp receiver, apply Loctite® red thread-locking
compound, reinstall, and fully tighten.
6
Position the enclosure at the desired location, tightening
the M6 x 45 mm Machine Screws as necessary. Fully
tighten the pre-installed M4 x 4 mm Set Screw in the
clamp receiver to hold its position. Mark the location
of the clamps on the pipe, then remove the enclosure
from the pipe.
4
Rotate the speaker to the desired angle. Reinstall the
speaker and speaker mounting screws and washers.
Hand-tighten in a criss-cross pattern.
10
Remove adhesive backing and install the JL Audio logo
badge.
8
Remove the backing from the rear logo appliqué. With
the logo positioned at the desired angle, attach the
appliqué to the back of the enclosure.
11
Gently press on the appliqué from the center out to
remove any air pockets.
12
Clean the inside of the aluminum cap with acetone (not
included) prior to attaching it to the enclosure. Apply a
circular bead of silicone adhesive to the inside of the
aluminum logo cap, 1/2-inch (13 mm) from the outer edge.
13
Align the aluminum logo cap to the desired angle of
rotation, and press it onto the back of the enclosure.
Apply masking tape (not included) to hold the cap in
place until the silicone cures (at least 24 hours).
14
• For marine installations, do not connect the speaker’s LED lights to the vessel’s navigational lighting circuits.
• For short-circuit protection, install a supplied fuseholder onto EACH speaker’s BLUE (+12V) LED power connection lead.
• Connect all BLUE (+12V) leads together (parallel) and connect to a switched +12V supply. Connect all YELLOW (GND)
leads together and connect to a negative ground or to the NEGATIVE battery post.
• We recommend activating the speakers’ LEDs thru a lighting circuit that supplies +12V via an existing switch. If an
existing switched circuit is not available, you may install a dedicated toggle/rocker style switch that will supply positive
(+12V) power. Fuse this connection according to how many LED circuits you have (LED circuits x 150 mA).
[ D]GN
LED
[+12V]
Blue
Yellow
Blue
Yellow
Blue
Yellow
Blue
Yellow
LED
Fuse
Fuse
Fuse
Example: One speaker pair of
LED circuits connected in parallel.
Steps 11-12 are for Standard Models Only
Steps 13-14 are for Premium Models Only

Produktspezifikationen

Marke: JL Audio
Kategorie: Lautsprecher
Modell: PS-SWMCP

Brauchst du Hilfe?

Wenn Sie Hilfe mit JL Audio PS-SWMCP benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Lautsprecher JL Audio

JL Audio

JL Audio C5-570 Bedienungsanleitung

19 September 2024
JL Audio

JL Audio M3-770X Bedienungsanleitung

17 September 2024
JL Audio

JL Audio Evolution C2-570x Bedienungsanleitung

15 September 2024
JL Audio

JL Audio M103EWS-CG-WH-L Bedienungsanleitung

13 September 2024
JL Audio

JL Audio C6-650 Bedienungsanleitung

2 September 2024
JL Audio

JL Audio SA-TPOD-100-BK Bedienungsanleitung

28 August 2024
JL Audio

JL Audio C1-690 Bedienungsanleitung

14 August 2024
JL Audio

JL Audio C5075-CT Bedienungsanleitung

12 August 2024
JL Audio

JL Audio C2-570X Bedienungsanleitung

9 August 2024
JL Audio

JL Audio C1-650 Bedienungsanleitung

7 August 2024

Bedienungsanleitung Lautsprecher

Neueste Bedienungsanleitung für -Kategorien-

Sonance

Sonance Visual Performance VP65 SST Bedienungsanleitung

16 Oktober 2024
Bowers And Wilkins

Bowers And Wilkins CWM664 Bedienungsanleitung

16 Oktober 2024
Focal

Focal Chorus 826 V Bedienungsanleitung

16 Oktober 2024
KEF

KEF Ci200ER Bedienungsanleitung

16 Oktober 2024
Steren

Steren SPK-1100BL Bedienungsanleitung

16 Oktober 2024
Aiwa

Aiwa SP-A100 Bedienungsanleitung

16 Oktober 2024
Trust

Trust GXT 628 Bedienungsanleitung

15 Oktober 2024
Pyle

Pyle PBMSPG6 Bedienungsanleitung

15 Oktober 2024
Marshall

Marshall Tufton Bedienungsanleitung

15 Oktober 2024
Sunstech

Sunstech SPUBT780 Bedienungsanleitung

15 Oktober 2024