JBL GSF6 Bedienungsanleitung

JBL Lautsprecher GSF6

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für JBL GSF6 (6 Seiten) in der Kategorie Lautsprecher. Dieser Bedienungsanleitung war für 15 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/6
Installation Guide
GSF3 & GSF6 Landscape Speakers
CAUTION: Installation must be done by qualified persons using safe
installation standards.
The installer is responsible for proper selection and use of mounting hardware
and processes to install the speakers in a safe manner.
Wire Connection
• CABLE-- - - - The GSF speakers have a captive 1 meter long cable for bare wire connection via an external installer provided
weather proof- junction box.
o Polarity -- – . The red wire is + (positive) and the black wire is (negative)
o Wire Gauge – 1 The wire gauge is 18 AWG ( mm2).
o Wire Jacket – - The wire jacket is 5 mm (+0/ 05.mm) in diameter.
o Connecting -- Use proper wire nuts or other safe connectorsprofessional that are appropriate for the installation
conditions and that are sized properly for wire gauge(s) and number of wires to be connected together in the
connector.
o Routing – - - When using the ground stake or L bracket base, the cable can be routed through the base.
Black - = (negative)
Red = + (positive)
CABLE
Bare-Wire End of Cable
Setting TAP SELECTOR SWITCH
(TAP SELECTOR SWITCH is located on the bottom of the speaker enclosure)
• Rotate bottom- : panel TAP SELECTOR SWITCH to select between
o GSF3:
8 - ) Ω(ie, low impedance / direct
15W or 7.5W for either 70V or 100V distributed speaker system
3.75W for 70V distributed speaker system only
o GSF6:
8 - Ω(ie, low impedance / direct)
30W or 15W for either 70V or 100V distributed speaker system
7.5W for 70V distributed speaker system only
Installing GROUND OUDSPEAKER-STAKE BASE or L BRACKET BASE - to L
• The speaker comes with both a GROUND-STAKE BASE and an L-BRACKET BASE. Use whichever one applies to the installation
requirements of the project.
• At the bottom of the LOUDSPEAKER there is a SOCKET. Three come with the speaker (packaged in a separate - rhead set sc ews
pouch) for attaching the chosen base into the SOCKET.
o Screw Dimensions -- – , GSF3: M4 x 0.7 5mm with 3 mm hex drive
GSF6: M4 x 0.7 – 9 , mm with 3 mm hex drive
(GSF SPEAKER shown with L-BRACKET BASE)
(continued ↓)
ROTARY TAP SELECTOR SWITCH
• Use the included 3 mm hex wrench to tighten the 3 set screws to hold the chosen base securely.
• For GROUND-STAKE BASE, press base into the ground.
(GSF SPEAKER shown with included GROUND STAKE base)-
• For L BRACKET BASE, securely attached base to either horizontal surface (such as decking or railing) or vertical surface (such as t- he
side of a building or post). Use the proper attachment hardware for the material and characteristics of what it’s being attached to.
Aiming LOUDSPEAKER
• Loosen HINGE BOLT by using included 4 mm hex key. Aim loudspeaker, and then retighten.
• Aiming Speaker at Downward Angle Provides Best Drainage – The greatest water drainage and reliability can be achieved by
aiming the speaker at a slight downward aiming angle.
• Maximum Upward Aiming Angle of 30° -- For when aimed slightly upward, there is a drain hole at the bottom of the speaker
that helps to drain water from the front of the speaker’s driver °at aiming angles up to a maximum 30 . At upward aiming
angles potentially °greater than 30 , water can pool on the driver, causing damage.
Ingress Protection Rating
• IP66 -- The GSF speakers are rated IP66 ( per IEC529 highly protected against ingress from dust and water). However, the
speaker is not rated for submersion in water, so steps must be taken to ensure that no immersion situation occurs.
HINGE BOLT
(use included 4 mm hex key)
(Shown with included L-BRACKET base)
CAUTION WHEN RE-AIMING SPEAKER:
When ground stake is utilized, re aiming speaker - -
horizontally requires either: a) completely pull ing
stake from ground and re back into -pressing
ground at new aiming angle or b) loosening 3 set ,
screws, re- -aiming speaker, and re tightening set
screws. Trying to rotate speaker with stake in
ground could and set screws tightened result in
damage or breakage.
CAUTION WHEN ROTATING ON L- : BRACKET
When bracket rotating speakerL- is utilized, on L-
bracket otating requires loosening 3 set screws, r
speaker, and re tightening set screws. Trying to -
rotate speaker set screws tightened could with
result in damage or breakage.

Produktspezifikationen

Marke: JBL
Kategorie: Lautsprecher
Modell: GSF6

Brauchst du Hilfe?

Wenn Sie Hilfe mit JBL GSF6 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Lautsprecher JBL

JBL

JBL CS 360Xcite Bedienungsanleitung

6 Oktober 2024
JBL

JBL AM7215/95 Bedienungsanleitung

5 Oktober 2024
JBL

JBL Club 620F Bedienungsanleitung

4 Oktober 2024
JBL

JBL Stadium MB8030AM Bedienungsanleitung

3 Oktober 2024
JBL

JBL Control 24C Micro Bedienungsanleitung

2 Oktober 2024
JBL

JBL Arena 26Be Bedienungsanleitung

2 Oktober 2024
JBL

JBL Control 28T-60 Bedienungsanleitung

24 September 2024
JBL

JBL AM7215/26 Bedienungsanleitung

23 September 2024
JBL

JBL EON One Pro Bedienungsanleitung

16 September 2024
JBL

JBL SRX738F Bedienungsanleitung

16 September 2024

Bedienungsanleitung Lautsprecher

Neueste Bedienungsanleitung für -Kategorien-

Sonance

Sonance Visual Performance VP65 SST Bedienungsanleitung

16 Oktober 2024
Bowers And Wilkins

Bowers And Wilkins CWM664 Bedienungsanleitung

16 Oktober 2024
Focal

Focal Chorus 826 V Bedienungsanleitung

16 Oktober 2024
KEF

KEF Ci200ER Bedienungsanleitung

16 Oktober 2024
Steren

Steren SPK-1100BL Bedienungsanleitung

16 Oktober 2024
Aiwa

Aiwa SP-A100 Bedienungsanleitung

16 Oktober 2024
Trust

Trust GXT 628 Bedienungsanleitung

15 Oktober 2024
Pyle

Pyle PBMSPG6 Bedienungsanleitung

15 Oktober 2024
Marshall

Marshall Tufton Bedienungsanleitung

15 Oktober 2024
Sunstech

Sunstech SPUBT780 Bedienungsanleitung

15 Oktober 2024