Indesit WIDXXL 146 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Indesit WIDXXL 146 (72 Seiten) in der Kategorie Wäschetrockner. Dieser Bedienungsanleitung war für 3 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/72
1
GB
Instruction booklet
WASHER DRYER
WIDXXL 146
English
GB
Contents
Installation, 2-3
Unpacking, 2
Remove the transit fixings, 2
Levelling, 2
Water connection, 2
Drainage & connections, 3
The first wash cycle, 3
Technical Details, 3
Washer Dryer description, 4-5
Control panel, 4
LEDs, 5
Starting and programmes, 6
Briefly: starting a programme, 6
Programme table, 6
Personalisation, 7
Setting the temperature, 7
Setting the drying cycle, 7
Options, 7
Table of drying times, 7
Detergents and laundry, 8
Detergent dispenser, 8
Preparing your laundry, 8
Precautions and advice, 9
General safety, 9
Saving energy and respecting the environment, 9
Disposal, 9
Care and Maintenance, 10
Switching off the water or electricity supply, 10
Cleaning, 10
Caring for your appliance door and drum, 10
Checking the water inlet hose, 10
Troubleshooting, 11
Service, 12
Before calling for assistance, 12
Spare Parts, 12
Tr7003gb_WIDXXL146.p65 27/01/06, 8.301
2
GB
! Keep this instruction manual in a safe place for
future reference. Should the appliance be sold,
transferred or moved, make sure the instruction
manual accompanies the washer dryer to inform the
new owner as to its operation and features.
! Read these instructions carefully: they contain vital
information on installation, use and safety.
Unpacking
1. Unpack the machine.
2. Check whether the machine has been damaged
during transport. If this is the case, do not install it and
contact your retailer.
Remove the transit fixings
IMPORTANT: Follow these instructions to remove the
TWO transit fixings.
Situated on either side of the
rear panel, BOTH transit boltsBOTH transit bolts
BOTH transit boltsBOTH transit bolts
BOTH transit bolts
MUST be rMUST be r
MUST be rMUST be r
MUST be removed beforemoved befor
emoved beforemoved befor
emoved before usee use
e usee use
e use.
! Failure to do so may cause
damage to your machine.
It is important the transit bolt
and spacer (see pic) come out
intact.
1. Unscrew the bolt using a
13mm spanner.
2. STOP when 3 threads can be
seen.
3. Hold, slide sideways and pull
to remove.
4. For safety, insert one of the
two plastic covers (supplied
with your machine) over the
hole.
! Repeat steps 1 to 4 to remove
the second transit bolt.
! Packaging materials are not
children’s toys.
Levelling
Your machine will be noisy if the two front feet are not
adjusted so that the machine stands firm and level.
! The machine should be levelled from side to side and
from front to back.
1. Move your machine into its final location.
- Take care not to trap or kink the hoses.
2. Turn one or both front feet
anti-clockwise by hand until the
feet cannot be turned any
more.
When adjusting the feet, use a
spirit level to check the machine
stands level, from side to side
and from front to back.
- The spring on each foot will stop them coming
loose.
! If it is placed on a fitted or loose carpet, adjust the
feet in such a way as to allow enough room for
ventilation beneath the machine.
Water connection
Connecting the water inlet hose.
Remember that this is a cold-fill machine.
! Check that seal is in place
inside the hose end cap.
Before making the water connections to gas ¾
thread, allow the water to run freely from the supply
tap until it is perfectly clear.
Screw the inlet end with the
blue cap onto the cold water
supply tap.
Turn the taps on and check for leaks: tighten if
necessary.
! Make sure there are no kinks or bends in the
hose.
! The water pressure at the tap must be within the
values indicated in the Technical details table (next
page).
! If the water inlet hose is not long enough, contact a
specialist store or an authorised serviceman.
! Always use new hoses.
! Check the water hose at least once a year, replace
any that are cracked as worn hoses could split under
water pressure.
Installation
Tr7003gb_WIDXXL146.p65 27/01/06, 8.302
3
GB
Drainage connections
A. Connect the drain
hose, without kinking it,
to a draining duct or a
wall drain fixed at a
height between 65 and
100cm from the floor.
B. Alternatively, place it
over the edge of a
basin, sink or tub,
fastening the hose
supplied to the tap.
! The free end of the hose should not be under
water.
! We advise against the use of hose extensions. In
case of absolute need, the extension must have the
same diameter as the original hose and must not
exceed 150cm in length.
Electrical connections
Before plugging the appliance into the mains socket,
make sure that:
the socket is earthed and in compliance with the
applicable law.
the socket is able to sustain the appliances
maximum power load indicated in the Technical
Details table (on the right).
the supply voltage is included within the values
indicated in the Technical Details table (on the
right).
the socket is compatible with the machine’s plug.
If this is not the case, replace the socket or the
plug.
! The machine should not be installed in an outdoor
environment, not even when the area is sheltered,
because it may be very dangerous to leave it
exposed to rain and thunderstorms.
! When the machine is installed, the mains socket
must be within easy reach and should be connected
to a suitable electrical supply.
! Do not use extensions or multiple sockets.
! The power supply cable must never be bent or
dangerously compressed.
! The power supply cable must only be replaced by
an authorised serviceman.
! The company denies all liability if and when these
norms are not respected.
The first wash cycle
Once the appliance has been installed and before
you use it for the first time, run a wash cycle without
detergent and no laundry, setting the 90°C
programme without a pre-wash cycle.
B
A
Tr7003gb_WIDXXL146.p65 27/01/06, 8.303
TECHNICAL DETAILS
Model WIDXXL 146
Dimensions 59.5 cm wide
85 cm high
52.5 cm deep
Capacity from 1 to 7 kg
Electric
connections
voltage 220 - 240 volts 50 Hz
Absorbed power 1700 - 2100 W
Water
connection
maximum pressure 1 MPa (10 bar)
minimum pressure 0,05 MPa (0,5 bar)
drum capacity 54 litres
Spin speed up to 1400 rpm
Control
programmes
according to
the IEC456
directive
programme 2*
Wash run with a 7 kg load
Dry run with 5 kg and 2 kg loads
*set wash temperature to 60°C
This appliance is compliant with the
following European Community
directives:
- 72/23/CEE of 19/02/73 (Low Voltage)
and subsequent amendments
- 89/336/CEE of 03/05/89
(Electromagnetic Compatibility) and
subsequent amendments


Produktspezifikationen

Marke: Indesit
Kategorie: Wäschetrockner
Modell: WIDXXL 146

Brauchst du Hilfe?

Wenn Sie Hilfe mit Indesit WIDXXL 146 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Wäschetrockner Indesit

Bedienungsanleitung Wäschetrockner

Neueste Bedienungsanleitung für -Kategorien-