Indesit K3G21SXIR Bedienungsanleitung

Indesit Herde K3G21SXIR

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Indesit K3G21SXIR (12 Seiten) in der Kategorie Herde. Dieser Bedienungsanleitung war für 24 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/12

K3G2/G

K3G21/G

K3G21S/IR

K3G2S/G

Contents

Installation, 2-6

Positioning and levelling

Electrical connections

Gas connection

Adapting to different types of gas

Technical data

Table of burner and nozzle specifications

Description of the appliance, 7

Overall view

Control panel

Start-up and use, 8-10

Using the hob

Using the oven

Analogue timer

Oven cooking advice table

Precautions and tips, 11

General safety

Disposal

Respecting and conserving the environment

Maintenance and care, 12

Switching the appliance off

Cleaning the appliance

Gas tap maintenance

Replacing the oven light bulb

Assistance

Operating Instructions

C K ROO E

E g n lish, 1

 Before operating your new appliance please read

this instruction booklet carefully. It contains

important information concerning the safe installation

and operation of the appliance.

 Please keep these operating instructions for future

reference. Make sure that the instructions are kept

with the appliance if it is sold, given away or moved.

 The appliance must be installed by a qualified

professional according to the instructions provided.

 Any necessary adjustment or maintenance must be

performed after the cooker has been disconnected

from the electricity supply.

Positioning

! This unit may be installed and used only in

permanently ventilated rooms according to the

British Standards Codes Of Practice: B.S. 6172/B.S.

5440, Par. 2 and B.S. 6891 Current Editions. The

following requirements must be observed:

a )The cooker should not be installed in a bed sitting

room with a volume of less than 20m3. If it is

installed in a room of volume less than 5m3 an air

vent of effective area of 110cm2 is required, if it is

installed in a room of volume between 5m3

and

10m3 a supplementary airvent area of 50cm2 is

required, if the volume exceeds 11m3 no airvent is

required. However, if the room has a door or a

window which opens directly to the outside no air

vent is required even when the volume is between

5m3 and 11m3.

b )During prolonged use of the appliance you may

consider it necessary to open a window to the

outside to improve ventilation.

c )If there are other fuel burning appliances in the

same room, B.S.5440 Part 2 Current Edition,

should, be consulted to determine the requisite air

vent requirements.

L ve elling

If it is necessary to level the

appliance, screw the

adjustable feet into the places

provided on each corner of the

base of the cooker (see

figure).

The legs* fit into the slots on

the underside of the base of

the cooker.

Installation the of coo erk

The appliance can be installed next to furniture units

which are no taller than the top of the cooker hob.

The wall in direct contact with the back panel of the

cooker must be made of non-flammable material.

During operation the back panel of the cooker could

reach a temperature of 50°C above room

temperature. For proper installation of the cooker,

the following precautions must be taken:

a )The appliance can be placed in a kitchen, dining

room or bedsit, but not in a bathroom.

b )All furniture around the appliance must be placed

at least 200 mm from the top of the cooker,

should the surface of the appliance be higher than

the worktop of this furniture. Curtains should not

be placed behind the cooker or less than 200 mm

away from the sides of the appliance.

c )Any hoods must be installed according to the

requirements in the installation manual for the

hoods themselves.

d )If the cooker is installed beneath a wall cabinet,

the latter must be situated at a minimum of 420

mm above the hob. The minimum distance

between the worktop and kitchen units made of

combustible material is 700 mm (Fig. A).

e )The wall in direct contact with the back panel of

the cooker must be made of non-flammable

materials.

f ) The cooker is fitted with a safety chain that must

be attached to a hook, secured to the wall behind

the appliance.

 Some models can have their gas connection

inverted. It is important to make sure the safety

chain is always situated on the side which

corresponds to the hose holder (Fig. B).

Fig. A Fig. B

Installation

HOOD

420

Min.

min.

650

mm. with hood

min.

700

mm. without hood

mm.

600

Min. mm.

420

Min. mm.

Gas connection

T he cooker should be connected to the gas-supply

by a corgi registered installer. During installation of

this product it is essential to fit an approved gas tap

to isolate the supply from the appliance for the

convenience of any subsequent removal or

servicing. Connection of the appliance to the gas

mains or liquid gas must be carried out according to

the prescribed regulation in force, and only after it is

ascertained that it is adaptable to the type of gas to

be used. If not, follow the instructions indicated in

the paragraph headed Adaptation to different gas

types. On some models the gas supply can be

connected on the left or on the right, as necessary;

to change the

connection, reverse the

position of the hose

holder with that of the

cap and replace the

gasket (supplied with

the appliance). In the

case of connection to

liquid gas, by tank, use

pressure regulators that

conform to the

regulation in force. The gas supply must be

connected to the left of the appliance. Be sure that

the hose does not pass through the rear of the

cooker touching hot parts.

 Make sure the supply pressure conforms with the

values shown in the table entitled Caracteristics of

the burners and nozzles. When the cooker is

installed between cabinets (recessed), the

gas connection must be effected by an

approved flexible hose with bayonet fitting

(BS 669 Current Edition). The gas inlet for

the cookers is a threaded G 1/2 gas female

f i t ti n g .

C g h gonnectin t e as supply

To make the connection, a flexible hose should be

used corresponding to the current gas regulations

which are:

 the hose must never be at any point in its lenght

in contact with the hot parts of the cooker;

 the hose must never be longer than 1,5 metre;

 the hose must not be subject to any tension or

torsional stress and it must not have any

excessively narrow curves or bottlenecks;

 the hose must be easy to inspect along its entire

length to check its condition;

* Only available in certain models

 the hose must always be in good condition, never

attempt to repair.

 The installation must comply with gas safety

(installation and use) regulations 1984. In all cases

for the above, by low, a qualified, corgi approved

engineer must be called for installation.

Electrial connection

Power supply voltage and frequency: 230-240V a.c.

50/60 Hz.

! The supply cable must be positioned so that it

never reaches at any point a temperature 50°C

higher than the room temperature. The cable must

be routed away from the rear vents. Should you

require it, you may use a longer cable, however, you

must ensure that the cable supplied with the

appliance is replaced by one of the same

specifications in accordance with current standards

and legislation.

Your appliance is supplied with a 13 amp fused plug

that can be plugged into a 13 amp socket for

immediate use. Before using the appliance please

read the instructions below.

WAR I G - N N THIS APPL UIANCEM ST BE

E EARTH D.

THE FO O I G R S S O D BLL W N OPEATION H UL E

C D O B I I D CARRIE UT Y A QUAL F E LE E TRICIAN.

Replacing h t e fuse:

When replacing a faulty fuse, a 13 amp ASTA

approved fuse to BS 1362 should always be used,

and the fuse cover re-fitted. If the fuse cover is lost,

the plug must not be used until a replacement is

obtained.

R replacem ent fuse vco e s:

If a replacement fuse cover is fitted, it must be of

the correct colour as indicated by the coloured

marking or the colour that is embossed in words on

the base of the plug. Replacements can be obtained

directly from your nearest Service Depot.

R g he o m vin t e plug:

If your appliance has a non-rewireable moulded plug

and you should wish to remove it to add a cable

extension or to re-route the mains cable through

partitions, units etc., please ensure that either:

 the plug is replaced by a fused 13 amp re-

wireable plug bearing the BSI mark of approval.

or:

700 mm

HOT PARTS

Produktspezifikationen

Marke:	Indesit
Kategorie:	Herde
Modell:	K3G21SXIR
Timer:	Ja
Breite:	500 mm
Tiefe:	600 mm
Produkttyp:	Freistehender Herd
Produktfarbe:	Edelstahl
Steuerung:	Drehregler
Höhe:	900 mm
Kochfeldtyp:	Gaskochfeld
Anzahl Herdplatten/Kochzonen:	4 Zone(n)
Garraumvolumen Gesamteinheit:	58 l
Timer-Typ:	Digital
Stromquelle Ofen:	Gas
Zündsicherung:	Ja
Elektrische Zündung:	Ja
Ofen enthalten:	Ja