Indesit IWME 147 Bedienungsanleitung

Indesit Waschmaschine IWME 147

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Indesit IWME 147 (20 Seiten) in der Kategorie Waschmaschine. Dieser Bedienungsanleitung war für 16 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/20

English,1

Contents

Installation, 2-3-4-5-6-7

Unpacking and levelling

Electric and water connections

The first wash cycle

Technical details

Instructions for the fitter

Care and maintenance, 8

Cutting off the water or electricity supply

Cleaning your appliance

Cleaning the detergent dispenser

Caring for your appliance door and drum

Cleaning the pump

Checking the water inlet hose

Precautions and advice, 9

General safety

Disposal

Saving energy and respecting the environment

Washing machine description, 10-11

Control panel

Leds

Starting and Programmes, 12

Briefly: how to start a programme

Programme table

Personalisations, 13

Setting the temperature

Setting the spin speed

Functions

Detergents and laundry, 14

Detergent dispenser

Bleach cycle

Preparing your laundry

Special items

Troubleshooting, 15-16

Assistance, 17-18

WASHING MACHINE

IWME 147

Instructions for use

Installation

! Keep this instruction manual in a safe place for

future reference. Should the appliance be sold, tran-

sferred or moved, make sure the instruction manual

accompanies the washing machine to inform the

new owner as to its operation and features.

! Read these instructions carefully: they contain

vital information on installation, use and safety.

Unpacking and levelling

Unpacking

1. Unpack the washing machine.

2. Check whether the washing machine has

been damaged during transport. If this is the

case, do not install it and contact your retailer.

3. Remove the 4 pro-

tective screws and the

rubber bush with the

respective spacer, si-

tuated on the rear of the

appliance (see also the

installation leaflet).

NB:The plastic spacers

may fall down inside the

machine once the bolt

has been removed, and

will not interfere with the operation of the machine.

4. Seal the gaps using the plastic plugs provided.

5. Keep all the parts: you will need them again

if the washing machine needs to be moved to

another location.

! Packaging materials are not children’s toys.

Levelling

Your machine may make a considerable

amount of noise if the two front feet have not

been adjusted correctly.

1. Install the washing machine on a flat sturdy

floor, without resting it up against walls, furniture

cabinets or other.

2. If the floor is not

perfectly level, com-

pensate for any une-

venness by tightening

or loosening the adju-

stable front feet (see

figure); the angle of

inclination, measu-

red according to the

worktop, must not

exceed 2°.

Levelling your appliance correctly will provide it with

stability and avoid any vibrations, noise and shifting

during operation. If it is placed on a fitted or loose

carpet, adjust the feet in such a way as to allow

enough room for ventilation beneath the washing

machine.

Electric and water connections

Connecting the water inlet hose

1. Connect the supply

pipe by screwing it

to a cold water tab

using a ¾ gas threa-

ded connection (see

figure).

Before performing the

connection, allow the

water to run freely until

it is perfectly clear.

2. Connect the other

end of the water inlet

hose to the washing

machine,

screwing it onto the

appliance’s cold wa-

ter inlet, situated on

the top right-hand

side on the rear of the

appliance (see figure).

3. Make sure there are no kinks or bends in

the hose.

! The water pressure at the tap must be within the

values indicated in the Technical details table

(on the next page).

! If the water inlet hose is not long enough,

contact a specialist store or an authorised

serviceman.

! Ensure that the supply taps are allowing water

through. Old taps may seize in the closed

position and thus prevent water reaching the

machine.

Connecting the drain hose

Connect the drain

hose, without ben-

ding it, to a draining

duct or a wall drain

situated between 65

and 100 cm from the

floor;

The drain hose may

be con nect e d to

an under-sink trap.

Before connecting

the drain hose from

the machine ensure

that any blanks or

removable ends have

been taken off the

spigot.

If it is place over

the edge of a basin

or sink be sure the

free end of the hose

should not be under-

water.

! We advise against the use of hose extensions;

in case of absolute need, the extension must

have the same diameter as the original hose

and must not exceed 150 cm in length.

Ensure that if the drain hose is pushed into a

standpipe, that the end does not go down more

than 15cms (6 inches). If the hose is pushed

down too far, this may cause the machine to

self -syphon ie. continuously empty as it is filling.

Electric connection

Before plugging the appliance into the mains

socket, make sure that:

• the socket is earthed and in compliance with

the applicable law;

• the socket is able to sustain the appliance’s

maximum power load indicated in the Tech-

nical details table ;(see page 5)

• the supply voltage is included within the va-

lues indicated on the Technical details table

(see page 5);

• the socket is compatible with the washing

machine’s plug. If this is not the case, repla-

ce the socket or the plug.

Your appliance is now supplied with a 13 amp

fused plug it can be plugged into a 13 amp

socket for immediate use. Before using the

appliance please read the instructions below.

WARNING - THIS APPLIANCE MUST BE EAR-

THED. THE FOLLOWING OPERATIONS SHOULD

BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.

Replacing the fuse:

When replacing a faulty fuse, a 13 amp ASTA

approved fuse to BS 1362 should always be

used, and the fuse cover re-fitted. If the fuse

cover is lost, the plug must not be used until a

replacement is obtained.

Replacement fuse covers:

If a replacement fuse cover is fitted, it must be of

the correct colour as indicated by the coloured

marking or the colour that is embossed in words

on the base of the plug. Replacements can be

obtained directly from your nearest Service Depot.

Removing the plug:

If your appliance has a non-rewireable moulded

plug and you should wish to re-route the mains

cable through partitions, units etc., please en-

sure that either:

the plug is replaced by a fused 13 ampere

re-wearable plug bearing the BSI mark of

approval.

or:

the mains cable is wired directly into a 13

amp cable outlet, controlled by a switch, (in

compliance with BS 5733) which is accessible

without moving the appliance.

Disposing of the plug:

Ensure that before disposing of the plug itself,

you make the pins unusable so that it cannot

be accidentally inserted into a socket.

Instructions for connecting cable to an alternative

plug:

Important: the wires in the mains lead are co-

loured in accordance with the following code:

Green & Yellow Earth

Blue Neutral

Brown Live

65 - 100 cm

Where it connects to

the waste water pipe

cut end off spigot or

remove the blanking cap

Produktspezifikationen

Marke:	Indesit
Kategorie:	Waschmaschine
Modell:	IWME 147
Display-Typ:	LED
Timer:	Ja
Breite:	595 mm
Tiefe:	550 mm
Gewicht:	68000 g
Produktfarbe:	Weiß
Höhe:	820 mm
Eingebautes Display:	Ja
Verpackungsbreite:	650 mm
Verpackungstiefe:	595 mm
Verpackungshöhe:	890 mm
Geräteplatzierung:	Integriert
Stromverbrauch (Standby):	8 W
Waschprogramme:	Hygiene/anti-allergy, Black, Easy care, Shoes, Delicate/silk
Maximale Schleuderdrehzahl:	1400 RPM
Startzeitvorwahl:	Ja
Luftschallemission (Schleudern):	81 dB
Luftschallemmission (Waschen):	54 dB
Energieeffizienzklasse (alt):	A+
Jährlicher Energieverbrauch Waschen:	212 kWh
Ladetyp:	Frontlader
Energieverbrauch Reinigung:	1.26 kWh
Nennkapazität:	7 kg
Türanschlag:	Links
Türfarbe:	Weiß
Einschalteverzögerung (max.):	24 h
Wasserverbrauch pro Zyklus:	- l
Jährlicher Wasserverbrauch Waschen:	9039 l
Waschwirkungsklasse:	A
Schleuder-Klasse:	B
Rückstandsfeuchtigkeit:	53 %
Anzahl Waschprogramme:	16
Benutzerdefinierte Panel-Bereitschaft:	Ja
Zykluszeit (max.):	193 min
Stromverbrauch (aus):	0.5 W
Türverkleidung enthalten:	Nein
Trommelvolumen:	52 l
Überlaufschutz:	Ja