Indesit I2 D81B UK Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Indesit I2 D81B UK (4 Seiten) in der Kategorie Wäschetrockner. Dieser Bedienungsanleitung war für 11 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
CONTROL PANEL
DAILY USE
Doing this will keep your machine working at its BEST:
- remember to empty your water tank after each drying cycle.
- remember to clean your condenser unit regularly (monthly).
- remember to clean your lter after each drying cycle.
Refer to the Care & Maintenance section.
1. Plug the dryer into the power supply socket.
2. Open the door and load garments; always refer to instructions on
clothing labels and the max loads indicated in the drying time table.
Empty pockets. Make sure garments do not get caught between the
door and/or the door lter.
3. Close the door.
4. Turn the “Drying Time" selection knob until the indicator is
pointing towards the most suitable drying time for the type of
fabric in that load.
Note: do not attempt to turn the knob anticlockwise.
5. If necessary, set the temperature using the "High Heat" button.
6. Press the "Start" button to begin drying.
7. A nal COOL TUMBLE phase (i.e. the fabrics are cooled) activates
during the last few minutes of the drying cycle; always allow this
phase to nish.
8. The cycle ends when the selection knob reaches the "0" zero
position and the drum stops.
9. Open the door, remove the laundry.
10. Disconnect the dryer from the power supply.
11. Clean the lter and replace it.
12. Empty the water tank and put it back in its slot.
OPENING THE DOOR DURING THE CYCLE
Laundry can be checked while the drying cycle runs and any
garments already dry can be removed, while drying continues for
the remaining items. After closing the door, press the "Start" button
to resume machine operation.
DESCRIPTION OF CONTROL PANEL
1. "Start" button.
Press to begin drying.
2. "Drying Time" selection knob.
This is used to set the drying time: turn the knob in a clockwise
direction until the indicator is set to the desired drying time. The
0 position switches o the dryer.
3. "Emptying Water Tank" indicator light.
To indicate when the water tank needs emptying.
Lighting up when the container is full, the door is closed and the
"Start" button has been pressed.
After emptying, reposition it correctly and the light will take
around 30 seconds to switch o after restarting the drying cycle
with the "Start" button.
IMPORTANT: If the container becomes full during the cycle, the
dryer will automatically stop and clothes will not be dried. To
avoid this empty the tank after or before starting a cycle.
4. "High Heat" button.
To be used to increase the heat on drying cycles.
CARE LABEL
Always check the care labels, especially when placing garments
in the tumble dryer for the  rst time. Below are the most
commonly used symbols:
May be tumble dried.
Do not tumble dry.
Tumble dry – high heat.
Tumble dry – low heat.
FIRST TIME USE
Remove all the tapes used to hold items on the machine.
Before you use it, clean the inside of the drum to remove any
dust that could have accumulated during transport. Slight odour
or vapour may be found if you open the door during its rst use,
this is normal and should only last a few minutes.
Make sure that the water tank is correctly inserted. Make sure
that the drain hose on the back of the dryer is properly
connected, either to the dryer’s water tank or to your domestic
drainage system.
The dryer must be installed in a room with a temperature
ranging between 5°C and 35°C to ensure proper operation.
THANK YOU FOR BUYING AN INDESIT PRODUCT.
In order to receive a more complete assistance,
please register your product on
www.indesit.eu/register
EN
Quick guide
Before using the appliance read the Safety Instructions carefully.
42 1
3
High Heat
This button selects the drying temperature. When the button
is out low heat is selected and when it is pushed in high heat is
selected.
Drying Times
The drying time depends on the size of the load and on the type
of fabric it contains (see the table below).
A cool tumble cycle runs during thenal 10 minutes of the cycle.
High Heat Cotton is the most ecient setting in terms of
energy consumption (EU 392/2012). To reach maximum eciency,
selectthe highest temperature option.
Drying Times table
Maximum load sizes: 7 kg Maximum load sizes: 8 kg
DRYING TIMES AND OPTIONS
Drying times are approximate and may vary depending on the
following:
Amount of water retained after the spin cycle: towels and
delicate items can retain a lot of water (if laundry retains
a large amount of water, use a longer cycle than the one
recommended).
Fabrics: items of the same fabric, but with dierent texture and
thickness may have dierent drying times.
Amount of laundry: single items and small loads take less time
to dry.
Ironing: If you will be ironing laundry, remove while slightly
damp for better results. Items not being ironed can be left
longer.
Temperature of the room: the lower the temperature of the
room, the longer it will take for the dryer to dry clothing.
Bulky items: Bulky items require special care. We recommend
removing several times the items during the drying cycle to
shake them out.
Warning: do not over-dry items.
All fabrics contain natural dampness which helps to keep them
soft and uy.
Power consumption
o-mode (Po) - Watts 0.06
left-on mode (Pl) - Watts 0.06
Drying Cycles kg kWh Minutes
High Heat Cotton* 7 4.25 129
High Heat Cotton 3.5 2.31 72
Low Heat Synthetics 3 1.32 75
*This is the reference setting used for the energy
label and is suitable for drying normal wet cotton
laundry.
Power consumption
o-mode (Po) - Watts 0.06
left-on mode (Pl) - Watts 0.06
Drying Cycles kg kWh Minutes
High Heat Cotton* 8 4.75 143
High Heat Cotton 4 2.57 81
Low Heat Synthetics 3 1.32 75
*This is the reference setting used for the energy
label and is suitable for drying normal wet cotton
laundry.
Fabric
Load
1 kg 2 kg 3 kg 4 kg 5 kg 6 kg 7 kg 8 kg
Cotton –
high heat
30 or 40
minutes 40 or 55
minutes 55 or 70
minutes 70 or 80
minutes 80 or 90
minutes 95 or 120
minutes 120 or 140
minutes 140 or 150
minutes
Synthetics
low heat
40 or 50
minutes 50 or 70
minutes 70 or 90
minutes - - - - -
Delicates –
low heat
40 or 60
minutes 55 or 75
minutes - - - - - -
Refer to the rating label located on the rear of the dryer for maximum load capacity.
Refresh
A short cycle suitable for refreshingbres and garments through
the emission of fresh air. It lasts about 10 minutes.
As this is not a drying cycle, it is not to be used for garments that
are still wet.
It can be used on any load size but is more eective on smaller
loads.
"Turn and Go" cotton full load 180 min.
A cycle suitable for a full cotton load. It sets up the right timing in
just one turn of a dial.
EN
Quick guide
CARE AND MAINTENANCE
WARNING: unplug the dryer during the cleaning and
maintenance procedures.
Emptying the water tank after each cycle (see Fig. A).
Pull the container out of the dryer and empty it into a sink or
other suitable drain, then place it back properly. Do not use the
dryer without having inserted the container back in place.
Cleaning the door lter after each cycle (see Fig. B).
Pull the lter out and clean it by removing the lint from the lter
surface under running water or using a vacuum cleaner. For optimal
performance, dry up the lter before inserting it back in place.
Do not use the dryer without having reinserted the lter in place.
Remove the door lter as described below:
1. Open the door and pull upwards.
2. Open the lter and remove lint from all its parts. Replace the
lter correctly making sure it is fully seated.
The lter is an essential part for drying. It is intended to
collect the lint formed during the drying process. If the
lter is clogged, the air ow inside the dryer can become
seriously aected: this will increase the drying time and
energy consumption, and could damage the dryer.
Cleaning the condenser unit (see Fig. C).
Remove the condenser unit regularly (monthly) and clean o
any u deposits from the plates by running cold water along its
rear end.
Removing the condenser:
1. Open the condenser cover, unlock the three catches by
turning them 90° anticlockwise.
2. Pull on the grip to remove the condenser.
3. Clean the surface of the seals.
4. Replace the unit with the arrows pointing upwards, while
making sure that the catches are securely xed.
Cleaning the tumble dryer
The external metal, plastic and rubber parts can be cleaned
with a damp cloth.
Clean the front air intake grille regularly (every 6 months)
with a vacuum cleaner to remove any lint, u or dust
deposits. Furthermore, remove any lint deposits from the
front part of the condenser and from the lter area, using a
vacuum cleaner every so often.
Do not use solvents or abrasives.
TRANSPORT AND HANDLING
Never lift the dryer by holding on to its top side.
1. Unplug the dryer
2. Remove the water from the water tank completely.
3. Make sure that door and water tank are properly closed.
4. If the drain hose is connected to your drainage system, re-
connect it to the back of the dryer (see "Installation" section in
the Safety Instructions).
PRODUCT DESCRIPTION
1. Water tank
2. Air intake
3. Door lter
4. Condenser unit
5. Condenser cover
A B
C
1
3
2
4
5


Produktspezifikationen

Marke: Indesit
Kategorie: Wäschetrockner
Modell: I2 D81B UK

Brauchst du Hilfe?

Wenn Sie Hilfe mit Indesit I2 D81B UK benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Wäschetrockner Indesit

Bedienungsanleitung Wäschetrockner

Neueste Bedienungsanleitung für -Kategorien-