Hotpoint TVM562G Bedienungsanleitung

Hotpoint Trockner TVM562G

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Hotpoint TVM562G (16 Seiten) in der Kategorie Trockner. Dieser Bedienungsanleitung war für 18 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/16

Instruction booklet

TUMBLE DRYER

Contents

English

TVM560

TVM562

!Keep this instruction booklet on hand in order to refer to it when necessary. Take it with you when you move, and

should you sell this appliance or pass it on to another party, make sure that this booklet is supplied along with the

dryer so that the new owner may be appliance works.informed about warnings and suggestions on how the

!Read these instructions carefully; the following pages contain important information on installation and suggestions

on how the appliance works.

Important

Information Installation Description

Start and

Programmes Laundry

Warnings and

Suggestions

Maintenance

and Care ServiceTroubleshooting

Important information, 2

Installation, 3-4

Where to put your dryer

Ventilation

Electrical connection

Levelling your dryer

Before you start using your dryer

Dryer description, 5

The front

The back

Control panel

Start and programmes, 6-7

Choosing a programme

Table of programmes

Laundry, 8-9

Sorting your laundry

Wash care labels

Special clothing items

Drying times

Warnings and Suggestions, 10

General safety

Disposal

Saving energy and respecting the environment

Maintenance and Care, 11

Switching off the electricity

Cleaning the filter after each cycle

Check the drum after each cycle

Cleaning the dryer

Troubleshooting, 12

Service, 13

Hotpoint Guarantee, 15

Hotpoint After Sales Service, 16

Important Information

!You MUST clean the fluff filter after EVERY drying

cycle.

Fluff Filter...

!Failure to clean the filter after EVERY drying cycle will affect the drying performance of your machine.

- It will take longer to dry and as a result will use more electricity during drying.

STEP 1.

Open the door of your

dryer.

STEP 2.

Pull out the filter (using

the two finger grips).

STEP 3.

Clean any fluff deposits

from the filter mesh.

For your Venting dryer to operate efficiently, you must follow the regular maintenance schedule shown below:

STEP 4.

Refit the filter.

- Make sure the arrows

are facing you.

STEP 5.

Make sure the filter is

pushed fully home.

- NEVER run the dryer

without the filter in position.

!You MUST clean fluff build up around the filter housing and the vent tube periodically, EVERY two or three months:

- Check the vent tube and any permanent venting fixture to make sure that there has been no accumulation

of fluff or lint, and remove it.

- Remove lint that collects around the filter and the outlet vents.

Important

Information Installation Description

Start and

Programmes Laundry

Warnings and

Suggestions

Maintenance

and Care ServiceTroubleshooting

Installation

Permanent venting

In conjunction with the vent tube we recommend

using a Wall/Window Vent Kit, available at a retail

location or the nearest Spare Parts Dealer.

Wall mounting

1. Leave an opening in

the wall to the left of the

dryers proposed position.

2. Keep the tube as short

and straight as possible

to prevent condensed

moisture from backing up

into the dryer.

3. Similarly, the duct in

the wall should slope

downwards towards the

outside.

Window mounting

1. With a stacked dryer

the hole in the window

should ideally be made

below the vent.

2. The tube should be

kept as short as possible.

Depending on how often you use your dryer, it is

essential that areas A and B are checked periodically

to remove lint or debris.

The vent tube adaptor must be fitted securely thus

preventing any humid air from being emitted back into

the room.

!The Dryer should not be pushed so far back that the

tube adaptor is pulled out of position or the tube is

squashed or bent.

!The tube should be kept clear of the air intake vent

and kinks or ‘U’ bends must be avoided as these will

obstruct the tube or trap condensation.

Where to put your dryer

●Place your dryer at a distance from gas ranges,

stoves, heaters, or cook tops because flames can

damage the appliance.

●If you are going to install the

appliance under a work

counter, be sure to leave a

10mm space between the

top and any other objects on

or above the machine and a

15mm space between the

sides and lateral furnishings

or walls. This is to ensure

proper air circulation. Make sure that the back

vents are not obstructed.

●Make sure you put your dryer in an environment

that is not damp and has proper air circulation

throughout, the dryer will not operate efficiently in

an enclosed space or cupboard.

!We do not recommend that the dryer is installed in a

cupboard but the dryer must never be installed

behind a lockable door, a sliding door or a door with a

hinge on the opposite side to that of the dryer door.

Ventilation

The Dryer dries your laundry by drawing in cool, clean

and relatively dry air, heating it, and then distributing it

through the clothes as they are gently tumbled. For

optimum performance, the moist air is then blown out

through a vent tube at the back of the dryer.

When the dryer is in use, there has to be adequate

ventilation to avoid the back flow of gases into the room

from appliances burning other fuels, including open fires.

Mobile venting

A vent tube must always be fitted when the dryer is

used in conjunction with Mobile Venting.

The tube must be fitted securely into the back of the

dryer (see Dryer Description). If possible, it is always

best to connect the tube to a permanent

outlet close to the dryer. If permanent installation is

not possible, the dryer will work just as well with the

tube passing through a partly-opened window.

!Ensure that the end of the tube is not directed

toward the air intake vent at the rear of the dryer.

!The vent tube should not exceed 2.4 metres in

length and should be kept free of any possible

accumulation of fluff, lint and water by shaking it out

frequently. Always ensure that the tube is not

squashed.

Minimum gap 10mm

Minimum gaps

15mm

Produktspezifikationen

Marke:	Hotpoint
Kategorie:	Trockner
Modell:	TVM562G
Breite:	595 mm
Tiefe:	550 mm
Produktfarbe:	Schwarz, Silber
Höhe:	850 mm
AC Eingangsspannung:	220 - 240 V
AC Eingangsfrequenz:	50 - 60 Hz
Geräteplatzierung:	Freistehend
Energieeffizienzklasse:	C
Ladetyp:	Frontlader
Nennkapazität:	6 kg
Türanschlag:	Links
Türöffnungswinkel:	180 °
Anzahl Trocknungsprogramme:	13