Hotpoint TCL770P Bedienungsanleitung

Hotpoint Wäschetrockner TCL770P

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Hotpoint TCL770P (16 Seiten) in der Kategorie Wäschetrockner. Dieser Bedienungsanleitung war für 14 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/16
Instruction booklet
TUMBLE DRYER
Contents
Important information, 2-3
Installation, 4
Where to put your dryer
Ventilation
Door reversal instructions
Water drain
Electrical connection
Before you start using your dryer
Dryer description, 5
To open the door
The features
Control panel
Start and programmes, 6-8
Choosing a programme
Laundry, 9-10
Sorting your laundry
Wash care labels
Special clothing items
Drying times
Warnings and Suggestions, 11
General safety
Disposal
Saving energy and respecting the environment
Maintenance and Care, 12
Switching off the electricity
Cleaning the filter after each cycle
Check the drum after each cycle
Empty the water container after each cycle
Cleaning the condenser unit
Cleaning the dryer
Troubleshooting, 13
Service, 14
Hotpoint Guarantee, 15
Hotpoint After Sales Service, 16
GB
English
TCL770
!Keep this instruction booklet on hand in order to refer to it when necessary. Take it with you when you move, and
should you sell this appliance or pass it on to another party, make sure that this booklet is supplied along with the
dryer so that the new owner may be appliance works.informed about warnings and suggestions on how the
!Read these instructions carefully; the following pages contain important information on installation and suggestions
on how the appliance works.
This symbol reminds you to read this booklet.
1
Important
Information Installation Description
Start and
Programmes Laundry
Warnings and
Suggestions
Maintenance
and Care ServiceTroubleshooting
GB
2
GB
Important Information
!You MUST clean the fluff filter after EVERY drying
cycle.
Fluff Filter...
!Failure to clean the filter after EVERY drying cycle will affect the drying performance of your machine.
- It will take longer to dry and as a result will use more electricity during drying.
!You MUST empty the water container after EVERY
drying cycle.
Water Container...
Priming the Water Collection System
When your dryer is new, the water container will not collect water until the system is primed... this will take 1 or 2 drying
cycles. Once primed it will collect water during every drying cycle.
STEP 1.
Open the door of your
dryer.
STEP 2.
Pull out the filter (using
the two finger grips).
STEP 3.
Clean any fluff deposits
from the filter mesh.
STEP 4.
Refit the filter - NEVER
run the dryer without the
filter in position.
For your Condenser dryer to operate efficiently, you must follow the regular maintenance schedule shown below:
STEP 1.
Pull the water container
towards you and remove
it fully from the dryer.
STEP 2.
Empty all the water
collected in the water
container.
!Failure to empty the water container will result in:
- The machine will stop heating (so the load may still be wet at the end of the drying cycle).
- The ‘Empty Water’ light will flash to tell you that the water container is full.
STEP 3.
Refit the water container,
ensuring that it is pushed
fully back into position.
!The ‘Empty Water’ light
stays on - To remind you to
empty the water container
at the start and at the
end of each programme.
3
Important
Information Installation Description
Start and
Programmes Laundry
Warnings and
Suggestions
Maintenance
and Care ServiceTroubleshooting
GB
Important Information
Condenser Unit...
!You MUST clean the fluff from the condenser EVERY
month.
!Failure to clean the condenser could cause premature
failure of your dryer.
●Check that:
- The positioning arrows are pointing upwards.
- The 3 clips are re-secured back into their ‘lock’ position.
STEP 3.
Flush the condenser, from
the rear with water, to
remove any fluff deposits.
STEP 4.
Refit the condenser unit
- ensure that the unit is
pushed in fully, all 3 clips
are re-secured and the
positiong arrows on the
front of the condenser are
pointing upwards.
Rotate 3 clips
STEP 1.
Open the condenser cover
- hold the handle and
pull towards you.
STEP 2.
Remove the condenser by
rotating the 3 clips then
pulling the condenser
towards you.
(There may be some water
in the tubes, this is normal).

Produktspezifikationen

Marke: Hotpoint
Kategorie: Wäschetrockner
Modell: TCL770P

Brauchst du Hilfe?

Wenn Sie Hilfe mit Hotpoint TCL770P benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Wäschetrockner Hotpoint

Hotpoint

Hotpoint FTVFG 65B GG (UK) Bedienungsanleitung

11 Oktober 2024
Hotpoint

Hotpoint TVF760A Bedienungsanleitung

2 Oktober 2024
Hotpoint

Hotpoint FTCL 871 GP (UK) Bedienungsanleitung

2 Oktober 2024
Hotpoint

Hotpoint NVL333EBCC Bedienungsanleitung

30 September 2024
Hotpoint

Hotpoint TCHL 870 BP.9 (UK) Bedienungsanleitung

13 September 2024
Hotpoint

Hotpoint NLL113EYWO Bedienungsanleitung

1 September 2024
Hotpoint

Hotpoint NV4D 01 P (UK) Bedienungsanleitung

28 August 2024
Hotpoint

Hotpoint H8 D94WB EU Bedienungsanleitung

28 August 2024
Hotpoint

Hotpoint H8 D94WB IT Bedienungsanleitung

28 August 2024
Hotpoint

Hotpoint H3 D81B UK Bedienungsanleitung

22 August 2024

Bedienungsanleitung Wäschetrockner

Neueste Bedienungsanleitung für -Kategorien-

GE

GE Profile PFD95GSPTDS Bedienungsanleitung

16 Oktober 2024
Maytag

Maytag MGD7100DC Maxima Bedienungsanleitung

16 Oktober 2024
Bosch

Bosch WTA4000 Bedienungsanleitung

16 Oktober 2024
Bauknecht

Bauknecht TRKP 7950 Bedienungsanleitung

16 Oktober 2024
Hoover

Hoover DX C9DKG-80 Bedienungsanleitung

16 Oktober 2024
Teka

Teka THPD80 Bedienungsanleitung

16 Oktober 2024
BEKO

BEKO B3T41242 Bedienungsanleitung

16 Oktober 2024
BEKO

BEKO BM5T49243W Bedienungsanleitung

16 Oktober 2024
BEKO

BEKO B3T67110 Bedienungsanleitung

16 Oktober 2024
BEKO

BEKO BM3T48249W Bedienungsanleitung

16 Oktober 2024