Hotpoint TCL770G Bedienungsanleitung

Hotpoint Trockner TCL770G

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Hotpoint TCL770G (16 Seiten) in der Kategorie Trockner. Dieser Bedienungsanleitung war für 36 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/16

Instruction booklet

TUMBLE DRYER

Contents

Important information, 2-3

Installation, 4

Where to put your dryer

Ventilation

Door reversal instructions

Water drain

Electrical connection

Before you start using your dryer

Dryer description, 5

To open the door

The features

Control panel

Start and programmes, 6-8

Choosing a programme

Laundry, 9-10

Sorting your laundry

Wash care labels

Special clothing items

Drying times

Warnings and Suggestions, 11

General safety

Disposal

Saving energy and respecting the environment

Maintenance and Care, 12

Switching off the electricity

Cleaning the filter after each cycle

Check the drum after each cycle

Empty the water container after each cycle

Cleaning the condenser unit

Cleaning the dryer

Troubleshooting, 13

Service, 14

Hotpoint Guarantee, 15

Hotpoint After Sales Service, 16

English

TCL770

!Keep this instruction booklet on hand in order to refer to it when necessary. Take it with you when you move, and

should you sell this appliance or pass it on to another party, make sure that this booklet is supplied along with the

dryer so that the new owner may be appliance works.informed about warnings and suggestions on how the

!Read these instructions carefully; the following pages contain important information on installation and suggestions

on how the appliance works.

This symbol reminds you to read this booklet.

Important

Information Installation Description

Start and

Programmes Laundry

Warnings and

Suggestions

Maintenance

and Care ServiceTroubleshooting

Important Information

!You MUST clean the fluff filter after EVERY drying

cycle.

Fluff Filter...

!Failure to clean the filter after EVERY drying cycle will affect the drying performance of your machine.

- It will take longer to dry and as a result will use more electricity during drying.

!You MUST empty the water container after EVERY

drying cycle.

Water Container...

Priming the Water Collection System

When your dryer is new, the water container will not collect water until the system is primed... this will take 1 or 2 drying

cycles. Once primed it will collect water during every drying cycle.

STEP 1.

Open the door of your

dryer.

STEP 2.

Pull out the filter (using

the two finger grips).

STEP 3.

Clean any fluff deposits

from the filter mesh.

STEP 4.

Refit the filter - NEVER

run the dryer without the

filter in position.

For your Condenser dryer to operate efficiently, you must follow the regular maintenance schedule shown below:

STEP 1.

Pull the water container

towards you and remove

it fully from the dryer.

STEP 2.

Empty all the water

collected in the water

container.

!Failure to empty the water container will result in:

- The machine will stop heating (so the load may still be wet at the end of the drying cycle).

- The ‘Empty Water’ light will flash to tell you that the water container is full.

STEP 3.

Refit the water container,

ensuring that it is pushed

fully back into position.

!The ‘Empty Water’ light

stays on - To remind you to

empty the water container

at the start and at the

end of each programme.

Important

Information Installation Description

Start and

Programmes Laundry

Warnings and

Suggestions

Maintenance

and Care ServiceTroubleshooting

Important Information

Condenser Unit...

!You MUST clean the fluff from the condenser EVERY

month.

!Failure to clean the condenser could cause premature

failure of your dryer.

●Check that:

- The positioning arrows are pointing upwards.

- The 3 clips are re-secured back into their ‘lock’ position.

STEP 3.

Flush the condenser, from

the rear with water, to

remove any fluff deposits.

STEP 4.

Refit the condenser unit

- ensure that the unit is

pushed in fully, all 3 clips

are re-secured and the

positiong arrows on the

front of the condenser are

pointing upwards.

Rotate 3 clips

STEP 1.

Open the condenser cover

- hold the handle and

pull towards you.

STEP 2.

Remove the condenser by

rotating the 3 clips then

pulling the condenser

towards you.

(There may be some water

in the tubes, this is normal).

Produktspezifikationen

Marke:	Hotpoint
Kategorie:	Trockner
Modell:	TCL770G
Breite:	595 mm
Tiefe:	584 mm
Produktfarbe:	Schwarz, Silber
Höhe:	850 mm
AC Eingangsspannung:	220 - 240 V
AC Eingangsfrequenz:	50 - 60 Hz
Geräteplatzierung:	Freistehend
Energieeffizienzklasse:	C
Startzeitvorwahl:	Ja
Ladetyp:	Frontlader
Nennkapazität:	7 kg
Türanschlag:	Links