Hotpoint TCD970G Bedienungsanleitung

Hotpoint Trockner TCD970G

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Hotpoint TCD970G (20 Seiten) in der Kategorie Trockner. Dieser Bedienungsanleitung war für 24 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/20
Instruction booklet
TUMBLE DRYER
GB
English
!Keep this instruction booklet on hand in order to refer to it when necessary. Take it with you when you move, and
should you sell this appliance or pass it on to another party, make sure that this booklet is supplied along with the
dryer so that the new owner may be appliance works.informed about warnings and suggestions on how the
!Read these instructions carefully; the following pages contain important information on installation and suggestions
on how the appliance works.
This symbol reminds you to read this booklet.
1
Contents
TCD970
First time you turn on your dryer
you must select your preferred
language see page 6
Important information, 2-3
Installation, 4
Where to put your dryer
Ventilation
Electrical connection
Before you start using your dryer
Dryer description, 5
To open the door
The features
Control panel
The Display, 6-8
Start and programmes, 8-11
Choosing a programme
Special programmes
Programme option modifiers
Table of programmes
The controls
Laundry, 12-13
Sorting your laundry
Wash care labels
Special clothing items
Drying times
Warnings and Suggestions, 14
General safety
Disposal
Saving energy and respecting the environment
Maintenance and Care, 15
Switching off the electricity
Cleaning the filter after each cycle
Empty the water container after each cycle
Check the drum after each cycle
Cleaning the condenser unit
Cleaning the dryer
Troubleshooting, 16
Service, 17
Hotpoint Guarantee, 19
Hotpoint After Sales Service, 20
GB
Important
Information Installation Description The Display Start and
Programmes Laundry Warnings and
Suggestions Troubleshooting Service
Maintenance
and Care
2
GB
Important Information
!You MUST clean the fluff filter after EVERY drying
cycle.
Fluff Filter...
!Failure to clean the filter after EVERY drying cycle will affect the drying performance of your machine.
- It will take longer to dry and as a result will use more electricity during drying.
!You MUST empty the water container after EVERY
drying cycle.
Water Container...
Priming the Water Collection System
When your dryer is new, the water container will not collect water until the system is primed... this will take 1 or 2 drying
cycles. Once primed it will collect water during every drying cycle.
STEP 1.
Open the door of your
dryer.
STEP 2.
Pull out the filter (using
the two finger grips).
STEP 3.
Clean any fluff deposits
from the filter mesh.
STEP 4.
Refit the filter - NEVER
run the dryer without the
filter in position.
For your Condenser dryer to operate efficiently, you must follow the regular maintenance schedule shown below:
STEP 1.
Pull the water container
towards you and remove
it fully from the dryer.
STEP 2.
Empty all the water
collected in the water
container.
!Failure to empty the water container will result in:
- The machine will stop heating (so the load may still be wet at the end of the drying cycle).
- The ‘Empty Water’ message will tell you that the water container is full.
STEP 3.
Refit the water container,
ensuring that it is pushed
fully back into position.
!The ‘Empty Water’
message reminds you to
empty the water container
at the start and at the
end of each programme.
3
Important Information
Condenser Unit...
!You MUST clean the fluff from the condenser EVERY
month.
!Failure to clean the condenser could cause premature
failure of your dryer.
Check that:
- The positioning arrows are pointing upwards.
- The 3 clips are re-secured back into their ‘lock’ position.
STEP 3.
Flush the condenser, from
the rear with water, to
remove any fluff deposits.
STEP 4.
Refit the condenser unit
- ensure that the unit is
pushed in fully, all 3 clips
are re-secured and the
positiong arrows on the
front of the condenser are
pointing upwards.
Rotate 3 clips
STEP 1.
Open the condenser cover
- hold the handle and
pull towards you.
STEP 2.
Remove the condenser by
rotating the 3 clips then
pulling the condenser
towards you.
(There may be some water
in the tubes, this is normal).
GB
Important
Information Installation Description The Display Start and
Programmes Laundry Warnings and
Suggestions Troubleshooting Service
Maintenance
and Care


Produktspezifikationen

Marke: Hotpoint
Kategorie: Trockner
Modell: TCD970G
Display-Typ: LCD
Breite: 595 mm
Tiefe: 584 mm
Produktfarbe: Schwarz, Silber
Höhe: 850 mm
AC Eingangsspannung: 220 - 240 V
AC Eingangsfrequenz: 50 - 60 Hz
Geräteplatzierung: Freistehend
Energieeffizienzklasse: C
Trockenprogramme: Schnell
Startzeitvorwahl: Ja
Ladetyp: Frontlader
Nennkapazität: 7 kg
Türanschlag: Links
Türöffnungswinkel: 180 °
Anzahl Trocknungsprogramme: 31

Brauchst du Hilfe?

Wenn Sie Hilfe mit Hotpoint TCD970G benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Trockner Hotpoint

Bedienungsanleitung Trockner

Neueste Bedienungsanleitung für -Kategorien-