Hotpoint HIO 3C26 W - CarePlus Bedienungsanleitung

Hotpoint SpĆ¼lmaschine HIO 3C26 W - CarePlus

Lesen Sie kostenlos die šŸ“– deutsche Bedienungsanleitung fĆ¼r Hotpoint HIO 3C26 W - CarePlus (8 Seiten) in der Kategorie SpĆ¼lmaschine. Dieser Bedienungsanleitung war fĆ¼r 6 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/8
1
EN
DAILY REFERENCE
GUIDE
Before using the appliance carefully read Health and Safety guide.
APPLIANCE
PRODUCT DESCRIPTION
CONTROL PANEL
0000 000 00000
Service:
1
2
3
4
5
6
10
12
7
11
9
8
1. Upper rack
2. Foldable ī€Ÿaps
3. Upper rack height adjuster
4. Upper spray arm
5. Lower rack
6. Cutlery basket
7. Lower spray arm
8. Filter Assembly
9. Salt reservoir
10. Detergent and Rinse Aid dispensers
11. Rating plate
12. Control panel
1. On-Oī€ž/Reset button with indicator light
2. Program selection button
3. Salt reī€ll indicator light
4. Rinse Aid reī€ll indicator light
5. Program number and remaining time indicator
6. Delay indicator light
7. Display
8. Zone Wash 3D indicator light
9. Delay button
10. Zone Wash 3D button
11. Tablet (Tab) button with indicator light
THANK YOU FOR BUYING A HOTPOINT PRODUCT.
In order to receive a more complete assistance,
please register your appliance on:
www.hotpoint.eu/register
You can download the Safety Instructions and the
Use and Care Guide, by visiting our website docs.
hotpoint.eu and following the Instructions on the
back of this booklet.
1 2 3 45 6 7 8 9 10 11
2
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the reta-
ining elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and
on the machineā€™s functional components.
ā€¢ī€ It is important that the salt reservoir be never empty.
ā€¢ī€ It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher (see Pro-
duct Description) and should be ī€lled when the SALT REFILL indicator
light in the control panel is lit .
1. Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2. Only the ī€rst time you do this: ī€ll the salt re-
servoir with water.
3. Position the funnel (see ī€Ÿgure) and ī€ll the salt
reservoir right up to its edge (approximately
1 kg); it is not unusual for a little water to leak
out.
4. Remove the funnel and wipe any salt residue
away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get
into the container during the wash program (this could damage the
water softener beyond repair).
Whenever you need to add salt, we recommend carrying out the
procedure before the washing cycle is started.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that
the water hardness setting is based on the actual water hardness in
your house. This information can be obtained from your local water
supplier.
The factory setting is for avarage (3) water hardness.
ā€¢ī€Switchī€onī€theī€applianceī€byī€pressingī€theī€ON/OFF button.
ā€¢ī€Switchī€oīƒ²ī€theī€applianceī€byī€pressingī€theī€ON/OFF button.
ā€¢ī€Holdī€downī€buttonī€P for 5 seconds, until you hear a beep.
ā€¢ī€Switchī€onī€theī€applianceī€byī€pressingī€theī€ON/OFF button.
ā€¢ī€Theī€currentī€selectionī€levelī€numberī€andī€theī€saltī€indicatorī€lightī€bothī€
ī€Ÿash.
ā€¢ī€Pressī€buttonī€P to select the desired hardness level (see WATER
HARDNESSī€TABLE).
ā€¢ī€Switchī€oīƒ²ī€theī€applianceī€byī€pressingī€theī€ON/OFF button.
Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been speciī€Ÿcally designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL indi-
cator light switches oī€ž.
If the salt container is not ī€Ÿlled, the water softener and the
heating element may be damaged as a result.
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser A should
be ī€lled when the RINSE AID REFILL indicator light in the control
panel is lit.
1. Open the dispenser B by pressing and pulling up the tab on the lid.
2. Pour in the rinse aid (max.110 ml), making sure it does not overī€Ÿow
from the dispenser. If this happens, clean the spill immediately with a
dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the appliance tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satisī€ed with the drying results, you can ad-
just the quantity of rinse aid used.
ā€¢ī€Switchī€theī€dishwasherī€onī€usingī€theī€ON/OFF button.
ā€¢ī€Switchī€itī€oīƒ²ī€usingī€theī€ON/OFF button.
ā€¢ī€Pressī€buttonī€P three times - a beep will be heard.
ā€¢ī€Switchī€itī€onī€usingī€theī€ON/OFF button.
ā€¢ī€Theī€currentī€selectionī€levelī€numberī€andī€rinseī€aidī€indicatorī€lightī€īƒøash.
ā€¢ī€Pressī€buttonī€P to select the level of rinse aid quantity to be
supplied.
ā€¢ī€Switchī€itī€oīƒ²ī€usingī€theī€ON/OFF button
Setting is complete!
If the rinse aid level is set to ZERO (ECO), no rinse aid will be supplied. The
LOW RINSE AID indicator light will not be lit if you run out of rinse aid.
A maximum of 4 levels can be set according to the dishwasher model. The
factory setting is for a medium level.
ā€¢ī€ If you see bluish streaks on the dishes, set a low number (1-2).
ā€¢ī€ If there are drops of water or limescale marks on the dishes, set a
mid-range number (3-4).
FILLING THE DETERGENT DISPENSER
A
B
To open the detergent dispenser
use the opening device A. Introduce
the detergent into the dry dispenser
B only. Place the amount of
detergent for pre-washing directly
inside the tub.
1. When measuring out the detergent re-
fer to the mentioned earlier information
to add the proper quantity. Inside the
dispenser B there are indications to help
the detergent dosing.
2. Remove detergent residues from the edges of the dispenser and
close the cover until it clicks.
3. Close the lid of the detergent dispenser by pulling it up until the
closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the program.
If all-in-one detergents are used, we recommend using the TABLET
button, because it adjusts the program so that the best washing and
drying results are always achieved.
Water Hardness Table
Level Ā°dH
German degrees
Ā°fH
French degrees
1 Soft 0 - 6 0 - 10
2 Medium 7 - 11 11 - 20
3 Average 12 - 17 21 - 30
4Hard 17 - 34 31 - 60
5 Very hard 35 - 50 61 - 90
M
A
X
A
B
35
25
EN
3
Program
Drying
Available
options *)
Detergent
container Duration
of wash
program
(h:min)**)
Water con-
sumption
(litres/cycle)
Energy con-
sumption
(kWh/cycle)
Tub B
1. Eco 50Ā° 3:10 9 0.93
2. Auto Intensive 65Ā° - 2:00 - 3:10 14 - 15.5 1.50 - 1.80
3. Auto Normal 55Ā° 1:30 - 2:30 14.5 - 16 1.15 - 1.30
4. Auto Fast 50Ā° - - 0:40 - 1:20 13 - 14.5 1.15 - 1.25
5. Express 30ā€™ 50Ā° - - 0:30 9 0.50
6. Good Night 50Ā° - 3:30 15 1.15
7. Sanitizing 65Ā° - 1:40 10 1.30
8. Soak - - - - 0:12 4.5 0.01
9. Self- Clean 65Ā° --0:50 8 0.80
ECO program data is measured under laboratory conditions according to European Standard EN 50242.
*) Not all options can be used simultaneously.
**) The duration of the program shown on the display or in the booklet is an estimate calculated on standard conditions. The actual time may vary
depending on many factors such as temperature and pressure of the incoming water, room temperature, amount of detergent, quantity and type of load,
load balancing, additional selected options and sensor calibration. The sensor calibration can increase program duration up to 20 min.
Standby consumption: Left-on mode consumption: 5 W - Oī€ž mode consumption: 0.5 W
Instructions on wash cycle selection.
ECO
Normally soiled crockery. Standard program, the most eī€œcient in
terms of its combined energy and water consumption.
AUTO INTENSIVE
Heavilyī€soiledī€dishesī€andī€pansī€(notī€toī€beī€usedī€forī€delicateī€items).
AUTO NORMAL
Automatic program for normally soiled pans and dishes.
AUTO FAST
Limited quantity of daily soiling (ideal for 4 place settings).
EXPRESS 30ā€™
Program to be used for lightly-soiled dishes with no dried food residu-
es. (Ideal for 2 place settings).
GOOD NIGHT
Suitable for night-time operation of the appliance. Optimum perfor-
mance ensured.
SANITIZING
Normally or heavily soiled crockery, with additional antibacterial wash.
SOAK
Crockery to be washed later. No detergent to be used with this
program.
SELF-CLEAN
Program to be used to perform maintenance of the dishwasher. It cle-
ans the interior of the appliance using hot water.
Notes:
Optimum performance levels when using the ā€œAuto Fastā€ and ā€œExpressā€
programs can be achieved by observing the maximum amounts of
speciī€ed place settings.
To reduce consumption even further, only run the dishwasher
when it is full.
PROGRAMS DESCRIPTION
PROGRAMS TABLE


Produktspezifikationen

Marke: Hotpoint
Kategorie: SpĆ¼lmaschine
Modell: HIO 3C26 W - CarePlus

Brauchst du Hilfe?

Wenn Sie Hilfe mit Hotpoint HIO 3C26 W - CarePlus benƶtigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung SpĆ¼lmaschine Hotpoint

Bedienungsanleitung SpĆ¼lmaschine

Neueste Bedienungsanleitung fĆ¼r -Kategorien-