Hotpoint AQD970F 69 Bedienungsanleitung

Hotpoint Waschmaschine AQD970F 69

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Hotpoint AQD970F 69 (48 Seiten) in der Kategorie Waschmaschine. Dieser Bedienungsanleitung war für 28 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/48

English,1

! This symbol reminds you to read this instruction manual.

Contents

Installation, 2-3

Unpacking and levelling

Connecting the electricity and water supplies

Technical data

Description of the machine, 4-5

Control panel

How to run a wash cycle or a drying

cycle, 6

Wash cycles and options, 7

Table of wash cycles

Wash options

Detergents and laundry, 8

Detergent

Preparing the laundry

Washing recommendations

Load balancing system

Precautions and advice, 9

General safety

Disposal

Opening the porthole door manually

Care and maintenance, 10

Cutting off the water and electricity supplies

Cleaning the machine

Cleaning the detergent dispenser drawer

Caring for your appliance drum

Cleaning the pump

Checking the water inlet hose

Trouble shooting, 11

Assistance, 12

WASHER DRYER

AQUALTIS

AQD970F 69

Instructions for

installation and use

Italiano,13

Português,37

Español,25

! If the appliance is levelled correctly, it will be more stable

and much less likely to cause vibrations and noise while it

is operating, particularly during the spin cycle.

! If it is placed on carpet or a rug, adjust the feet in such a

way as to allow a sufficient ventilation space underneath

the wasdher-dryer.

Connecting the electricity and water

supplies

Connecting the water inlet hose

! Before connecting the inlet hose to the water supply, run

the water until it is perfectly clear.

1. Connect the inlet hose

to the machine by screwing

it onto the cold water inlet

of the appliance, which is

situated on the top right-

hand side of the rear part of

the appliance . (see figure)

2. Connect the inlet hose

by screwing it to a cold

water tap using a 3/4 gas

threaded connection (see

figure).

3. Make sure that the hose is not folded over or bent.

! The water pressure at the tap must fall within the values

indicated in the Technical data table (see next page).

! If the inlet hose is not long enough, contact a specialised

shop or an authorised technician.

! Never use second-hand or old inlet hoses; use the

products supplied with the machine.

! This instruction manual should be kept in a safe place for

future reference. If the wasdher-dryer is sold, given away or

moved, please ensure the manual is kept with the machine,

so that the new owner may benefit from the advice

contained within it.

! Read these instructions carefully: they contain vital

information relating to the safe installation and operation of

the appliance.

! Inside the pack containing this manual, you will also find

the guarantee and all the details necessary for installation.

Unpacking and levelling

Unpacking

1. Once you have removed all the packaging from the

wasdher-dryer, make sure it has not been damaged during

transportation.

If it has been damaged, contact the retailer and do not

proceed any further with the installation process.

2. Remove the 4 protective

screws (used during

transportation) and the

corresponding spacer,

located on the rear part of

the appliance ( ). see figure

3. Close off the holes using the plastic plugs supplied in the

pack.

4. Keep all the parts in a safe place; they will be needed

again if the wasdher-dryer is moved to another location, to

prevent the inside of the appliance being damaged.

! Packaging materials should not be used as toys for

children.

Levelling

1. Place the wasdher-dryer on a flat sturdy floor, without

resting it up against walls or cabinets.

2. If the floor is uneven, the

front feet of the machine

may be adjusted until

it reaches a horizontal

position (the angle of

inclination must not exceed

2 degrees).

Installation

65 - 100 cm

Connecting the drain hose

Connect the drain hose to

drain duct piping or a wall

drain located between 65

and 100 cm above the floor,

making sure it is not bent

at all.

Alternatively, rest the

drain hose on the side of

a washbasin or bathtub,

fastening the duct supplied

to the tap (see figure).

The free end of the hose

should not be underwater.

! We advise against the use of hose extensions; if it is

absolutely necessary, the extension must have the same

diameter as the original hose and must not exceed 150 cm

in length.

Electrical connections

Before plugging the appliance into the electricity socket,

make sure that:

• thesocketisearthedandcomplieswithallapplicable

laws;

• thesocketisabletowithstandthemaximumpowerload

of the appliance as indicated in the Technical data table

(see opposite);

• thepowersupplyvoltagefallswithinthevaluesindicated

in the Technical data table (see opposite);

• thesocketiscompatiblewiththeplugoftheappliance.

If this is not the case, have the socket or the plug

replaced.

! The appliace must only be installed indoor in a frost free

and dry room, to prevent it from electronic damage due to

frost or condensation.

! The mains socket must remain within easy reach after the

wasdher-dryer has been installed.

! Do not use extension cords or multiple sockets.

! The cable should not be bent or compressed.

! The power supply cable and plug must only be replaced

by authorised technicians.

Warning! The company shall not be held responsible in the

event that these regulations are not respected.

Technical data

Model AQD970F 69

Dimensions

width 59.5 cm

height 85 cm

depth 64.5 cm

Capacity from 1 to 9 kg for the wash programme

from 1 to 7 kg for the drying programme

Electrical

connections

please refer to the technical data plate

fixed to the machine

Water connections

maximum pressure 1 MPa (10 bar)

minimum pressure 0.05 MPa (0.5 bar)

drum capacity 71 litres

Spin speed up to 1600 rotations per minute

Energy rated

programmes

according to

regulation

EN 50229

Wash: programme ; temperature 60°C;

using a load of 9 kg.

Drying: the smaller load must be dried by

selecting the “EXTRA” dryness level. The

load must consist of 2 sheets, 1 pillowcase

and 1 hand towel;

the remainder of the load must be dried by

selecting the “EXTRA” dryness level.

This appliance conforms to the following

EC Directives:

- 2004/108/EC (Electromagnetic Compatibility)

- 2006/95/EC (Low Voltage)

- 2002/96/EC

Produktspezifikationen

Marke:	Hotpoint
Kategorie:	Waschmaschine
Modell:	AQD970F 69
Display-Typ:	LCD
Breite:	595 mm
Tiefe:	616 mm
Gewicht:	75000 g
Produktfarbe:	Silver,White
Höhe:	850 mm
AC Eingangsspannung:	220 - 240 V
AC Eingangsfrequenz:	50 Hz
Eingebautes Display:	Ja
Verpackungsbreite:	64000 mm
Verpackungstiefe:	69000 mm
Verpackungshöhe:	89000 mm
Paketgewicht:	77000 g
Geräteplatzierung:	Freistehend
Maximale Schleuderdrehzahl:	1600 RPM
Nennkapazität (Waschen & Trocknen):	7 kg
Nennkapazität (Waschen):	9 kg
Startzeitvorwahl:	Nein
Anpassbare Rotationsgeschwindigkeit:	Ja
Anti-Faltenfunktion:	Nein
Luftschallemmission (Waschen):	83 dB
Luftschallemmission (Trocknen):	59 dB
Energieeffizienzklasse (alt):	A
Ladetyp:	Frontlader
Wasserverbrauch pro Zyklus (Waschen & Trocknen):	108 l
Energieverbrauch Reinigung:	1.83 kWh
Wasserverbrauch pro Zyklus (Waschen):	- l
Energieverbrauch Waschen und Trocknen:	6.12 kWh
Türanschlag:	Rechts
Kindersicherung:	Nein
Waschwirkungsklasse:	A
Aquastop Funktion:	Nein
Trommelvolumen:	71 l
Zykluszeit Waschen:	171 min