Honeywell YTHX9421R7001WW/U Bedienungsanleitung

Honeywell Thermostat YTHX9421R7001WW/U

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Honeywell YTHX9421R7001WW/U (20 Seiten) in der Kategorie Thermostat. Dieser Bedienungsanleitung war für 12 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/20
69-2459EFS-09
C7189R1004,
Read before installing
Lire avant l’installation
Leer antes de instalar
C7189R
Wireless Indoor Sensor
Capteur d’intérieur sans fil
Sensor inalámbrico para interiores
Installation instructions
Notice d’installation
Instrucciones de instalacn
Installation Guide
ii
69-2459EFS—09
This sensor monitors temperature and humidity in any indoor location and transmits it
wirelessly to the thermostat.
You can set the system to monitor temperature at the thermostat, or at the sensor location,
or use an average of both to optimize comfort throughout the home. The thermostat can use
up to 6 wireless indoor sensors.
When multiple sensors are installed, the thermostat can monitor temperature and humidity
in separate locations. For example, one sensor can control humidification on the main level,
while another controls dehumidification in a crawl space. For more information, see the
instructions provided with the thermostat.
Note: The wireless indoor sensor is compatible only with RedLINK 2.0 thermostats.
Operating Ambient Temperature: 0 to 120° F (17.8 to 48.9° C)
For Optimal Battery Life: 35 to 114° F (1.7 to 45.6° C)
Operating Relative Humidity: 5% to 90% (non-condensing)
Physical Dimensions: 27/8 x 17/8 x 15/16 inches (74 x 48 x 24 mm)
The thermostat will display a warning to replace batteries in the indoor sensor about 2 months before power
is depleted. The sensor status light will begin flashing red about 2–3 weeks before power is depleted. During
normal operation, the status light remains off.
About your wireless indoor sensor
Wireless Indoor Sensor
169-2459EFS—09
MCR32933
MCR32934
MCR32935
Install 2 fresh AAA alkaline batteries.
Status light will briefly flash green. If it
flashes red, batteries are not good.
Install batteries and link sensor to thermostat
1
Install batteries, then enter Wireless Setup mode at the thermostat. Press and
release the CONNECT button to link the wireless sensor to the thermostat.
Press and release CONNECT. After
a short delay, the status light will
glow green for 15 seconds.
If the status light is red, the
sensor did not link with the
thermostat. See Note.
Verify the thermostat is in the Wireless Setup
mode and the indoor sensor is at least 2 feet
away from the EIM or thermostat.


Produktspezifikationen

Marke: Honeywell
Kategorie: Thermostat
Modell: YTHX9421R7001WW/U

Brauchst du Hilfe?

Wenn Sie Hilfe mit Honeywell YTHX9421R7001WW/U benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Thermostat Honeywell

Bedienungsanleitung Thermostat

Neueste Bedienungsanleitung für -Kategorien-