Honeywell Homexpert THR830TUK Bedienungsanleitung

Honeywell Thermostat Homexpert THR830TUK

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Honeywell Homexpert THR830TUK (2 Seiten) in der Kategorie Thermostat. Dieser Bedienungsanleitung war für 7 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/2
User Manual
THR830TUK
Room Thermostat
50051981-001 Rev. A
...an explanation for householders
A room thermostat simply switches the heating system
on and off as necessary. It works by sensing the air
temperature, switching on the heating when the air
temperature falls below the thermostat setting, and
switching it off once this set temperature has been
reached. Turning a room thermostat to a higher setting
will not make the room heat up any faster. How quickly
the room heats up depends on the design of the
heating system, for example, the size of boiler and
radiators.
Neither does the setting affect how quickly the room
cools down. Turning a room thermostat to a lower
setting will result in the room being controlled at a lower
temperature, and saves energy.
The heating system will not work if a time switch or
programmer has switched it off.
The way to set and use your room thermostat is to find
the lowest temperature setting that you are comfortable
with, and then leave it alone to do its job. The best
way to do this is to set the room thermostat to a low
temperature – say 18°C – and then turn it up by one
degree each day until you are comfortable with the
temperature. You won’t have to adjust the thermostat
further. Any adjustment above this
setting will waste energy and cost
you more money.
If your heating system is a boiler
with radiators, there will usually
be only one room thermostat
to control the whole house. But you can have
different temperatures in individual rooms by installing
thermostatic radiator valves (TRVs) on individual
radiators. If you don’t have TRVs, you should choose
a temperature that is reasonable for the whole house.
If you do have TRVs, you can choose a slightly higher
setting to make sure that even the coldest room is
comfortable, then prevent any overheating in other
rooms by adjusting the TRVs.
Room thermostats need a free flow of air to sense the
temperature, so they must not be covered by curtains
or blocked by furniture. Nearby electric fires, televisions,
wall or table lamps may prevent the thermostat from
working properly.
What is a room thermostat?
Installation
NOTE: If you are not experienced in equipment installation, we recommend that these
procedures be done by a professional installer.
DISCONNECT ELECTRIC POWER BEFORE INSTALLATION: Can cause electrical shock or
equipment damage.
NO
NO OK
1.2 — 1.5 m
Install away from sources of hot or cold air
Wall mounting
Mounting on junction box Flush mounting on wall
Remove the thermostat from the wall bracket as shown at left. Install about 1.2 to 1.5
metres above the floor.
®
Wiring
1.0 - 2.5 mm²
8 mm max.
Wiring diagrams
Test system and finish installation
• AllwiringmustbeinaccordancewithIEERegulations.Thisthermostatisforxedwiringonly.
• Aswitch,havingcontactseparationofatleast3mminallpolesmustbeincorporatedinthexedwiringasa
means of disconnecting the supply.
• ThethermostatisaClassII(doubleinsulated)device.Aparkingterminalisprovidedforexternalearthwiring
continuity.
• Theheatingsystemmustincorporateafuseratedatnomorethan10Amps.Thecoolingsystemmust
incorporate a fuse rated at no more than 6 Amps.
• Thethermostathas4knockoutsonthecovertoaccommodatesurfacewiring.Makesurethecablecompletely
fills the knockout hole without leaving any gaps. Where used, mini-trunking must be fitted firmly against the
thermostat cover in such a way as to leave no gap.
1 Replace cover and secure with
screw as shown at left.
2 Check the power supply to make
sure the heating system is on.
3 Turn the control dial to raise
targettemperatureto30°C.If
the thermostat is wired properly,
the heating system should begin
running.
4 To stop the test, turn the control
dial to lower the target temperature
to an appropriate level. The heating
system should turn off.
Turn dial to 30°C to test
Replace and secure cover
Connect wiring from your heating or cooling
equipment to the thermostat as shown at left.
See wiring diagrams for details.
1 Make sure electrical power is off.
2 Strip insulation to expose about 6 mm of
bare wire.
3 Use a screwdriver to loosen terminal screw,
insert wire into slot, then tighten screw.
4 See below to test and finish installation
NOTE: All wiring must comply with IEE
regulations. Keep AC mains supply/load cables
separate from equipment wiring.
Honeywell
The Arnold Centre
Paycocke Road
Basildon,Essex
SS143EA
TechnicalHelpDesk:08456042893 50051981-001Rev.A
www.homexpertbyhoneywell.com © 2010 Honeywell International Inc
homexpert
tm
by Honeywell is a trademark of Honeywell International Inc. All rights reserved.
Heating application Cooling application
Honeywell warrants this product for 1 year from date
of purchase. We undertake to replace or repair at our
discretion, products should they become defective
within 1 year solely as a result of faulty materials and or
workmanship.
Understandably if the product has not been installed or
maintained in accordance with Honeywell’s instructions,
has not been used appropriately or if any attempt has
been made to rectify, dismantle or alter the product in
any way the warranty will be invalidated.
This product warranty states Honeywell’s entire liability.
It does not extend to cover consequential loss or
damage or installation costs arising from a defective
product.
If the product is defective, please return it together with
a proof of purchase or receipt to the place of purchase.
This does not affect your statutory rights.
If you require further information about this product,
call the homexpert
tm
by Honeywell technical helpline on
08456042893.
For a full list of terms and conditions please visit
www.homexpertbyhonyewell.com.
Limited warranty
HEATING LOAD
COOLING LOAD
N
N
LL
230v~
50-60 Hz
230v~
50-60 Hz

Produktspezifikationen

Marke: Honeywell
Kategorie: Thermostat
Modell: Homexpert THR830TUK

Brauchst du Hilfe?

Wenn Sie Hilfe mit Honeywell Homexpert THR830TUK benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Thermostat Honeywell

Honeywell

Honeywell Round on-off T87G1006 Bedienungsanleitung

5 Oktober 2024
Honeywell

Honeywell Day Night Round T8700A Bedienungsanleitung

4 Oktober 2024
Honeywell

Honeywell T822L1000/U Bedienungsanleitung

30 September 2024
Honeywell

Honeywell CT53K1006/E1 Bedienungsanleitung

27 September 2024
Honeywell

Honeywell TH6320WF2003/U Bedienungsanleitung

24 September 2024
Honeywell

Honeywell SMHOM8610KIT Bedienungsanleitung

15 September 2024
Honeywell

Honeywell Focus Pro Bedienungsanleitung

13 September 2024
Honeywell

Honeywell TH6220WF2006/U Bedienungsanleitung

13 September 2024
Honeywell

Honeywell T8775C1005/U Bedienungsanleitung

12 September 2024
Honeywell

Honeywell TH3110D1016/U Bedienungsanleitung

8 September 2024

Bedienungsanleitung Thermostat

Neueste Bedienungsanleitung für -Kategorien-

Siemens

Siemens RDG100T Bedienungsanleitung

16 Oktober 2024
Siemens

Siemens N2264 Bedienungsanleitung

7 Oktober 2024
Theben

Theben RAM 811 Top - 811 9 901 Bedienungsanleitung

5 Oktober 2024
Siemens

Siemens DESIGO RXA Bedienungsanleitung

5 Oktober 2024
Drayton

Drayton RTS10 Bedienungsanleitung

5 Oktober 2024
Busch-Jaeger

Busch-Jaeger 1097 U Bedienungsanleitung

3 Oktober 2024
Eberle

Eberle RTR-E 3545 Bedienungsanleitung

2 Oktober 2024
Eberle

Eberle RTR 9164 Bedienungsanleitung

2 Oktober 2024
JUNG

JUNG TRDCD231 Bedienungsanleitung

2 Oktober 2024
Oreg

Oreg AT90E Bedienungsanleitung

1 Oktober 2024