GE Profile JP930KCCC Bedienungsanleitung

GE Herde Profile JP930KCCC

Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr GE Profile JP930KCCC (8 Seiten) in der Kategorie Herde. Dieser Bedienungsanleitung war fĂĽr 26 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/8
1
TOOLS YOU WILL NEED
MATERIALS YOU WILL NEED
229C4053P529-1
31-10545-1 05-03 JR
Installation
30″Electric Cooktop
Instructions
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
• IMPORTANT —Save these
instructions for local inspector’s use.
• IMPORTANT —Observe all
governing codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these
instructions for future reference.
• Product failure due to improper installation
is not covered under the Warranty.
WARNING — This appliance must
be properly grounded.
•ATTENTION INSTALLER —
ALL COOKTOPS MUST BE HARD WIRED
(DIRECT WIRED) INTO AN APPROVED
JUNCTION BOX. A “PLUG AND
RECEPTACLE” IS NOT PERMITTED ON
THESE PRODUCTS.
• Proper installation is the responsibility
of the installer and product failure due to
improper installation is NOT covered under
warranty.
PARTS INCLUDED
Wire Nuts
Junction Box
Saber Saw
Pencil
Safety Glasses
1/8″Drill Bit & Electric
or Hand Drill
Ruler or Straightedge
Phillips Head
Screwdriver
JP340, JP350, JP930, JP931, JP938, JP939
“If you have questions, call 800.GE.CARES or visit our website at:
www.GEAppliances.com”
2 Hold Down
Brackets
4 Screws Foam Tape
2
Installation Instructions
FOR YOUR SAFETY
• For Personal Safety, remove house fuse
or open circuit breaker before beginning
installation. Failure to do so could result
in serious injury or death.
• Be sure your cooktop is installed properly
by a qualified installer or service technician.
• To eliminate the risk of burns or fire due
to reaching over heated surface elements,
cabinet storage located above the surface
units should be avoided. If cabinet storage
space is to be provided, the risk can be
reduced by installing a range hood that
projects horizontally a minimum of 5″
beyond the bottom of the cabinets. Cabinet
installation above the cooktop may be no
deeper than 13″.
• Make sure the cabinets and wall coverings
around the cooktop can withstand the
temperatures (up to 200°F) generated
by the cooktop.
• The cooktop should be easy to reach and
lighted with natural light during the day.
• Always disconnect the electrical service to
the cooktop before repairing or servicing
the cooktop. This can be done by
disconnecting the fuse or circuit breaker.
Failure to do this could result in a
dangerous or fatal shock. Know where your
main disconnect switch is located. If you do
not know, have your electrician show you.
IMPORTANT SAFETY INSTRUCTIONS
ELECTRICAL REQUIREMENTS
This appliance must be supplied with the
proper voltage and frequency, and connected
to an individual, properly grounded branch
circuit, protected by a circuit breaker or a
time delay fuse as noted on rating plate.
We recommend you have the electrical wiring
and hookup of your cooktop connected by a
qualified electrician. After installation, have
the electrician show you where your main
cooktop disconnect is located.
Wiring must conform to National Electrical
Code. You can get a copy of the National
Electrical Code, ANSI/NFPA No. 70-Latest
Edition, by writing:
National Fire Protection Association
Batterymarch Park
Quincy, MA 02269
The cooktop conduit wiring is approved for
copper wire connection only, and if you have
aluminum house wiring, you must use
special UL approved connectors for joining
copper to aluminum.
You must use a two-wire, three conductor
208/240 VAC, 60 Hertz electrical system. A
white (neutral) wire is not needed for this
unit. The cooktop must be installed in a
circuit that does not exceed 125 VAC nominal
to ground.
Refer to the rating plate on your cooktop for
the KW rating for your cooktop.
ON
HO T
3
Installation Instructions
WARNING – The electrical power
to the cooktop supply line must be shut off
while connections are being made. Failure to
do so could result in serious injury or death.
When preparing cooktop opening, make
sure the inside of the cabinet and the
cooktop do not interfere with each other.
(See section on preparing the opening.)
Remove packaging materials and
literature package from the cooktop
before beginning installation.
2
1
PRE-INSTALLATION CHECKLIST
Remove Installation Instructions from
literature pack and read them carefully
before you begin.
Be sure to place all literature, Owner’s
Manual, Installations, etc. in a safe place
for future reference.
Make sure you have all the tools and
materials you need before starting the
installation of the cooktop.
Your home must provide the adequate
electrical service needed to safely and
properly use your cooktop. (Refer to
section on electrical requirements.)
When installing your cooktop in your
home, make sure all local codes and
ordinances are followed exactly as
stated.
Make sure the wall coverings, countertop
and cabinets around the cooktop can
withstand heat (up to 200°F) generated
by the cooktop.
7
6
5
4
3
Cooktop
Literature
Package
Styrofoam
Packaging
Bef ore yo u be gin- Read thes e inst ructio ns c omple te ly and care f ully.
I PORT A T - Sa ve t hese instruc tions f or local i nspe ctor' s use .M N
I PORT A T - OBSE RVE ALL G OVERNING CODES AND ORDIANCES.M N
ot e to Insta ller- Be sure to leav e the se instruct ions wi th t he consume r.N
OW E R- Ke ep the se ins tructio ns f or f uture re fe rence .N
ot e- T his a pplia nce mus t be pro per ly g rounde d ( if app licabl e ).N
Bef ore yo u be gin- Read thes e inst ructio ns c omple te ly and care f ully.
I PORT A T - Sa ve t hese instruc tions f or local i nspe ctor' s use .M N
I PORT A T - OBSE RVE ALL G OVERNING CODES AND ORDIANCES.M N
ot e to Insta ller- Be sure to leav e the se instruct ions wi th t he consume r.N
OW E R- Ke ep the se ins tructio ns f or f uture re fe rence .N
ot e- T his a pplia nce mus t be pro per ly g rounde d ( if app licabl e ).N

Produktspezifikationen

Marke: GE
Kategorie: Herde
Modell: Profile JP930KCCC

Brauchst du Hilfe?

Wenn Sie Hilfe mit GE Profile JP930KCCC benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Herde GE

GE

GE Profile PLD621DWBB Bedienungsanleitung

27 Juni 2024
GE

GE Profile PLD621EWSB Bedienungsanleitung

27 Juni 2024
GE

GE GRF400SVWW Bedienungsanleitung

27 Juni 2024
GE

GE GGS500PVSS Bedienungsanleitung

27 Juni 2024
GE

GE Profile PLD621RWSS Bedienungsanleitung

27 Juni 2024
GE

GE GRF500PVES Bedienungsanleitung

27 Juni 2024
GE

GE GGF600AVSS Bedienungsanleitung

27 Juni 2024
GE

GE GRF500PVWW Bedienungsanleitung

27 Juni 2024
GE

GE GGS600AVES Bedienungsanleitung

27 Juni 2024
GE

GE GGF600AVES Bedienungsanleitung

27 Juni 2024

Bedienungsanleitung Herde

Neueste Bedienungsanleitung fĂĽr -Kategorien-

Nemco

Nemco 9130A Bedienungsanleitung

18 August 2024
Meireles

Meireles MI 1600 Bedienungsanleitung

12 August 2024
BEKO

BEKO HIGG 64123 SB Bedienungsanleitung

5 August 2024
NABO

NABO KFC 6060 Bedienungsanleitung

28 Juni 2024
NABO

NABO KFI 6010 Bedienungsanleitung

28 Juni 2024
NABO

NABO KFC 3000 Bedienungsanleitung

28 Juni 2024
NABO

NABO HS 4062 Bedienungsanleitung

28 Juni 2024
AEG

AEG TI64IB10IZ Bedienungsanleitung

27 Juni 2024
BORA

BORA M Pure Bedienungsanleitung

27 Juni 2024
BORA

BORA Basic Bedienungsanleitung

27 Juni 2024