GE GPF525W Bedienungsanleitung


Lesen Sie kostenlos die šŸ“– deutsche Bedienungsanleitung fĆ¼r GE GPF525W (4 Seiten) in der Kategorie SpĆ¼lmaschine. Dieser Bedienungsanleitung war fĆ¼r 19 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
GE Consumer & Industrial
Appliances
Installation Instructions
Dishwasher 1/4" Custom Panel Trim Kit
GPF525 Series
GPF525B-Black Trim Kit, GPF525C-Bisque Trim Kit, GPF525W-White Trim Kit
IMPORTANT ā€“ Save these instructions for local
inspectorā€™s use.
IMPORTANT ā€“ Observe all governing codes and
ordinances
Note to Installer ā€“ Be sure to leave these instructions with
the Consumer.
Note to Consumer ā€“ Keep these instructions with your
Ownerā€™s Manual for future reference.
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
ī™˜ī™œī™ī™–ī™˜ī™ī™ī™£ī™˜ī™žī™ī˜ī™ī™£ī˜ī™¦ī™žī™”ī™š
WARNING:
To prevent electric shock, disconnect electrical power
supply to dishwasher before changing panels. Do not
operate dishwasher while changing panels or when
toekick assembly is removed.
TOOLS AND MATERIALS REQUIRED:
ā€¢ 1/4" socket driver
ā€¢ Phillips screwdriver
ā€¢ Electric drill
ā€¢ 1/8" drill bit
ā€¢ Masking tape
ā€¢ Safety Glasses
ā€¢ Gloves to protect against sharp edges
KIT INCLUDES:
ā€¢ Installation Instructions
ā€¢ Left, right, top and bottom door trim
ā€¢ 8 ā€“ 18 x 5/16" color-matched screws
IMPORTANT!
The factory supplied door springs must
be replaced with two WD03X10012 door
springs if the custom panel weighs more
than 3.5 pounds. Order these springs at
GE.COM or call 1-800-626-2002. Refer to
Step 4 for more information
STEP 1: CUT 1/4" THICK CUSTOM PANELS TO SIZE
ā€¢ Cut door panel to the dimensions shown.
NOTE: The trim provided will conceal the cut edges of the
panels.
STEP 2: REMOVE TOEKICK ASSEMBLY
ā€¢ Make sure electrical power to the dishwasher is turned off.
ā€¢ Remove the two toekick panel screws and toekick panel. Set
them aside for use in Step 6.
NOTE: Do not remove the insulation behind the toekick.
2
ī˜ ī˜žī˜£ī˜‘ī˜ī™ƒī™—ī™˜ī™’ī™š
ī˜³ī™žī™žī™”ī˜ī˜æī™ī™ī™”ī™›
ī˜”ī˜¢ī˜œī˜ ī˜žī˜”ī˜‘
ī˜”ī˜¤ī˜œī˜ ī˜žī˜£ī˜‘
ī˜³ī™žī™žī™”
ī˜»ī™žī™žī™¢ī™”ī™ī˜ī˜”ī˜ī™‚ī™’ī™”ī™”ī™¦ī™¢
ī˜³ī™žī™žī™”
ī˜æī™ī™ī™”ī™›
ī˜“ī™¢ī™’ī™¤ī™£ī™’ī™—ī™”ī™žī™
ī™ƒī™žī™”ī™šī™˜ī™’ī™š
INSTALLATION OPTIONS
This trim kit is designed to accommodate 1/4" thick panels.
A raised panel screwed or glued to 1/4" thick backing can be
used. The raised portion of the panel must be fabricated to
permit clearances for the trim on all sides.
A 3/4ā€ thick custom panel may be installed by routing the top
and sides to 1/4" thickness.
ī˜”ī˜¤ī˜œī˜ ī˜žī˜£ī˜‘
ī˜ ī˜žī˜£ī˜‘ī˜ī˜¼ī™˜ī™ī˜ī˜ī˜²ī™›ī™”ī™ī™”ī™ī™ī™’ī™”
ī˜”ī˜¢ī˜œī˜ ī˜žī˜”ī˜‘
ī˜°ī™Ÿī™Ÿī™”ī™ī™”ī™ī™ī™’ī™”
ī˜æī™ī™ī™”ī™›
ī˜ ī˜žī˜£ī˜‘
ī™ƒī™—ī™˜ī™’ī™š
ī˜æī™ī™ī™”ī™›
ī˜ ī˜žī˜£ī˜‘ī˜ī˜¼ī™˜ī™ī˜ī˜
ī˜²ī™›ī™”ī™ī™”ī™ī™ī™’ī™”
ī˜ ī˜žī˜£ī˜‘ī˜ī˜¼ī™˜ī™ī˜ī˜
ī˜²ī™›ī™”ī™ī™”ī™ī™ī™’ī™”
ī˜ ī˜žī˜£ī˜‘ī˜ī˜¼ī™˜ī™ī˜
ī˜²ī™›ī™”ī™ī™”ī™ī™ī™’ī™”ī˜
3
STEP 3: INSTALL DOOR PANEL TRIM AND CUSTOM PANEL
A
B
C
ā€¢ Place bottom trim against the bottom of the door panel and
drive center screw, then left and right screws. Use the
8 - 18 x 5/16" color-matched screws provided.
ā€¢ Slide ā€œZā€ shaped trim under the escutcheon.
ā€¢ Slide custom door panel under the ā€œZā€ trim
and bottom trim.
ā€¢ The notch on the side trim pieces goes towards the front.
Slide side trim up and under the escutcheon and over the
edge of the custom panel.
D
E
ā€¢ Use masking tape to hold trim tightly against the custom
panel.
F
ā€¢ Use the holes in the side trim pieces to locate, center punch,
and then drill 1/8" holes in the dishwasher panel. Use care
when performing this operation to prevent damage to the
side trim.
ā€¢ Fasten the trim to the dishwasher door panel with the
8 - 18 x 5/16" color-matched screws.
ā€¢ Remove tape.
ī˜“ī™¢ī™’ī™¤ī™£ī™’ī™—ī™”ī™žī™
ī™¼ī™‰ī™½ī˜ī™ƒī™”ī™˜ī™œ
ī˜“ī™¢ī™’ī™¤ī™£ī™’ī™—ī™”ī™žī™
ī˜“ī™¢ī™’ī™¤ī™£ī™’ī™—ī™”ī™žī™
ī˜“ī™¢ī™’ī™¤ī™£ī™’ī™—ī™”ī™žī™
ī™ƒī™ī™Ÿī™”ī˜ī™ƒī™”ī™˜ī™œ
ī™ƒī™žī˜ī˜²ī™¤ī™¢ī™£ī™žī™œ
ī˜æī™ī™ī™”ī™›ī˜ī™žī™
ī˜“ī™ī™’ī™—ī˜ī™‚ī™˜ī™“ī™”
ī˜“ī™¢ī™’ī™¤ī™£ī™’ī™—ī™”ī™žī™


Produktspezifikationen

Marke: GE
Kategorie: SpĆ¼lmaschine
Modell: GPF525W

Brauchst du Hilfe?

Wenn Sie Hilfe mit GE GPF525W benƶtigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung SpĆ¼lmaschine GE

Bedienungsanleitung SpĆ¼lmaschine

Neueste Bedienungsanleitung fĆ¼r -Kategorien-