GE GPF425B Bedienungsanleitung


Lesen Sie kostenlos die šŸ“– deutsche Bedienungsanleitung fĆ¼r GE GPF425B (8 Seiten) in der Kategorie SpĆ¼lmaschine. Dieser Bedienungsanleitung war fĆ¼r 5 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/8
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
IMPORTANT ā€“ Save these instruc-
tions for local inspectorā€™s use.
IMPORTANT ā€“ Observe all governing
codes and ordinances.
Note to Installer ā€“ Be sure to leave these
instructions with the Consumer.
Note to Consumer ā€“ Keep these instructions
with your Ownerā€™s Manual for future
reference.
Installation
Instructions
1/4" Custom Dishwasher
Door and Access Panel Kit
GPF425 Series Kit
GPF425A-Almond Trim Kit, GPF425B-Black Trim Kit,
GPF425C-Bisque Trim Kit, GPF425W-White Trim Kit
WARNING:
To prevent electric shock, disconnect electri-
cal power supply to dishwasher before
changing panels. Do not operate dishwasher
while changing panels or when lower access
panel assembly is removed.
TOOLS AND MATERIALS REQUIRED:
ā€¢ 1/4" socket driver
ā€¢ Phillips screwdriver
ā€¢ Electric drill
ā€¢ 1/8" drill bit
ā€¢ Masking tape
ā€¢ Safety glasses
ā€¢ Gloves to protect against sharp edges
KIT INCLUDES:
ā€¢ Left, right and bottom door trim
ā€¢ Top and bottom access panel trim
ā€¢ Color matched screws
STOP
INSTALLATION OPTIONS
This trim kit is designed to accommodate 1/4"
thick panels. A raised panel screwed or glued to
1/4" thick backing can be used. The raised
portion of the panel must be fabricated to
permit clearances for the trim on all sides.
ā€¢ ā€œXā€ Clearance shown at the bottom of the
raised panel must be maintained to prevent
the door from striking the access panel when
opened.
Appearance Total ā€œXā€
Panel Backing Thickness Clearance
3/4" 1/4" 1" 2"
1/2" 1/4" 3/4" 1-7/8"
A 3/4" thick custom panel may be installed by
routing the top and sides to 1/4" thickness. The
bottom edge, Dimension ā€œXā€, should be 1-1/2"
high and 1/4" thick.
IMPORTANT!
GPF100 Dishwasher Door Spring Kit
MUST BE installed when custom
door panels weigh 4 pounds or more.
18-7/8"
1/4" Min. Clearance
23-9/16"
Appearance
Panel
1/4"
Thick
Panel 1/8" Min.
Clearance
1/8" Min.
Clearance
X
Clearance
3-11/16"
1/4" Min. Clearance
All Sides
29-9/16"
Access Panel
2 REMOVE LOWER ACCESS
PANEL ASSEMBLY
ā€¢ Remove the two screws below the
access panel. Retain screws.
ā€¢ Loosen the two screws located
between the door and the access
panel. Do not attempt to remove
these screws. They are secured to
the access panel with washers.
ā€¢ Remove the access panel assembly
from the dishwasher.
ā€¢ Remove the toekick and set aside.
NOTE: Do not remove the insulation
behind the access panel or toekick.
1 CUT 1/4" THICK CUSTOM
PANELS TO SIZE
ā€¢ Cut door panel and access panel to the
dimensions shown.
NOTE: The trim provided will conceal the cut
edges of the panels.
2
1/4" Thick
Door Panel
23-9/16"
3-11/16"
19-3/4"
1/4" Thick Access Panel
Loosen 2 Screws
Escutcheon
Door
Panel
Access Panel
Toekick
3 INSTALL DOOR PANEL TRIM
AND CUSTOM PANEL
ā€¢ Remove the protective plastic covering from
side trim pieces.
ā€¢ Slide ā€œZā€ shaped trim under the escutcheon.
ā€¢ Place bottom trim against the bottom of the
door panel and drive center screw, then left
and right screws.
ā€¢ Slide custom door panel under the ā€œZā€ trim
and bottom trim.
ā€¢ The notch on the side trim pieces goes
towards the front. Slide side trim up and
under the escutcheon and over the edge
of the custom panel.
ā€¢ Center punch and drill holes through the
holes in the side trim and into the dishwasher
door.
ā€¢ Secure the trim to the door with color
matched screws provided. Remove tape.
ā€¢ Use masking tape to hold trim tightly
against the custom panel.
A
B
C
D
F
E
3
ā€œZā€ Trim
Tape Trim
to Custom
Panel on
Each Side
Drill Holes
and Install
Screws


Produktspezifikationen

Marke: GE
Kategorie: SpĆ¼lmaschine
Modell: GPF425B

Brauchst du Hilfe?

Wenn Sie Hilfe mit GE GPF425B benƶtigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung SpĆ¼lmaschine GE

Bedienungsanleitung SpĆ¼lmaschine

Neueste Bedienungsanleitung fĆ¼r -Kategorien-