GE Café CWL112P4RW5 Bedienungsanleitung

GE magnetron Café CWL112P4RW5

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für GE Café CWL112P4RW5 (16 Seiten) in der Kategorie magnetron. Dieser Bedienungsanleitung war für 20 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/16
Installation
Instructions
CWL112P2RS1
CWL112P4RW5
CWL112P3RD5
For a full manual in English and Spanish visit
Para un manual completo en inglés y español
cafeappliances.com/literature
Thank You! ... for your purchase of a Café brand appliance.
Register Your Appliance: Register your new appliance online at your convenience!
cafeappliances.com/register
Timely product registration will allow for enhanced communication and prompt service under the terms of your warranty,
should the need arise. You may also mail in the pre-printed registration card included in the packing material.
Drawer Microwave
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT Save these instructions for local inspector’s use.
IMPORTANT Observe all governing codes and ordinances.
Note to Installer Be sure to leave these instructions with the Consumer.
Note to Consumer Keep these instructions
with your Owner’s Manual for future reference.
Skill Level Installation of this appliance requires basic mechanical and electrical skills.
Proper installation is the responsibility of the installer. Product failure due to improper installation is not covered
under the warranty. See Owner’s Manual for warranty information.
IMPOR NTTA Use this oven only for its intended purpose. Never use the oven for warming or heating a room.
Prolonged use of the oven without proper ventilation can be hazardous.
WARNING If the information in this manual is not followed exactly, a fire or electrical shock may result that
could cause property damage, personal injury or death.
WARNING To reduce the risk of tipping, the Drawer Microwave must be secured by a properly installed Anti-
Tip block.
This Drawer Microwave must be electrically grounded in accordance with local codes.
Make sure the wall coverings and the cabinets around the Drawer Microwave can withstand the heat generated by
the Drawer Microwave.
WARNING Never leave children alone or unattended in the area where a Drawer Microwave is in use.
Never leave the drawer open when the microwave is unattended.
READ AND SAVE THESE INSTRUCTIONS
31-7000166 Rev. 1 10-21 GEA
IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
231-7000166 Rev. 1
Installation Instructions
WARNING Stepping, leaning or sitting on the drawer may result in serious injuries and can also cause
damage to the Drawer Microwave.
Do not use the Drawer Microwave as a storage space. This creates a potentially hazardous situation.
Check that the time-of-day is in the display. If not, touch to prevent unintended use.Stop/Clear
UNPACK DRAWER MICROWAVE
Remove all packing materials from inside the Drawer Microwave.
DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the top of the Drawer Microwave.
Remove the feature sticker, if there is one. Check the drawer for any damage, such as misaligned or bent drawer,
damaged drawer seals and sealing surfaces, broken or loose Drawer Microwave guides and dents inside the
cavity or on the front side of the drawer. If there is any damage, do not operate the Drawer Microwave and contact
your dealer.
Sealing Surface
Waveguide Cover
Sealing Surface
Oven Cavity
CLEARANCES AND DIMENSIONS
Dimensions that are shown in Figure 1 must be used for Standard Installation. Given dimensions provide minimum
clearance. Locate electrical outlet in the shaded area in the upper left-hand corner of the cutout. See Figure 4.
Contact surface must be solid and level. Pay special attention to the floor on which the Drawer Microwave will sit.
The floor of the opening should be constructed of plywood strong enough to support the weight of the oven (about
100 pounds).
Check location where the Drawer Microwave will be installed for proper electrical supply.
Your oven can be built into a cabinet or wall by itself or under a gas, under an electric wall oven, or under selected
cook top models.
Be sure that the clearance of the floor between the wall oven and the drawer microwave is a minimum of 2-inches.
The microwave interior will easily accommodate a 9” x 13” oblong dish or a bag of microwave popcorn.
The oven can also be mounted flush. Please see instructions for flush mounting included with the Flush Mount
Deflector vent.
31-7000166 Rev.1 3
Installation Instructions
24” DRAWER MICROWAVE MEASUREMENTS
Figures 1 and 2 contain many drawer microwave measurements for reference when planning the drawer location.
This drawer microwave can be installed below any electric or gas wall oven or under selected cook
top models.
Can also be installed using an electrical outlet in an adjacent cabinet within the areas where the provided electrical
cord can reach. Power cord access hole in cabinet should be a minimum of 1 1/2” diameter hole and deburred of
all sharp edges.
IMPOR NTTA
Always allow sufficient power cord length to the electrical outlet to prevent tension.
Always check electrical codes for requirements.
Preferred electrical
outlet location* 6”
5”
4”


overlap

overlap

min
Anti-Tip
Block


bottom of
anti-tip
block
36”
countertop
height
24”
cabinet min.


Floor
must
support
100 lbs

overlap

overlap

Figure 1






thickness
15” auto
drawer
opening
Figure 2
ANTI-TIP BLOCK
NORMAL INSTALLATION STEPS
Anti -Tip BLOCK Installation Instructions
To reduce the risk of tipping of the drawer, the Anti-Tip block must be properly
installed located 14 13/16-inches above the floor on which the Drawer
Microwave will sit. The anti-tip block must be provided and pre-installed by the
purchaser of the product or builder before install can be done. The anti-tip block
is not provided by installer. See Figures 1 and 2. The Anti-Tip block prevents
serious injury that might result from spilled
hot liquids.
If the Drawer Microwave is ever moved to a different location, the Anti-Tip block
must also be moved and installed. When installed to the wall, make sure that
the screws completely penetrate the dry wall and are secured in wood or metal
so that the block is totally stable. When fastening, be sure that the screws do
not penetrate electrical wiring or plumbing.

6”
Anti-Tip
block
Figure 3


Produktspezifikationen

Marke: GE
Kategorie: magnetron
Modell: Café CWL112P4RW5

Brauchst du Hilfe?

Wenn Sie Hilfe mit GE Café CWL112P4RW5 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung magnetron GE

Bedienungsanleitung magnetron

Neueste Bedienungsanleitung für -Kategorien-