Garmin Edge 305 Bedienungsanleitung

Garmin Navigator Edge 305

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Garmin Edge 305 (1 Seiten) in der Kategorie Navigator. Dieser Bedienungsanleitung war für 34 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/1

2. Attach the bike mount securely using two cable ties.

Make sure the cable ties are threaded through both parts Note:

of the bike mount.

3. Align the Edge with the bike mount so that the unit is vertical.

4. Slide the unit left until it snaps into place.

To release the unit:

Press down on the release lever, and slide the unit to the right.

➊

Charge the Battery

1. On the back of the Edge, pull up the weather cap from the

mini-USB port. Make sure that this area is completely dry to

prevent corrosion.

2. Plug the mini-USB end of the charger into the mini-USB port on

the unit.

3. Plug the A/C charger into a standard wall outlet. Charge the

Edge for at least 3 hours before using. When the battery is

completely charged, it can run for approximately 12 hours

before recharging.

➌

Conﬁgure the Edge

When you ﬁrst turn on your Edge, the following setup screens appear.

Follow the on-screen instructions.

To conﬁgure your Edge:

➋

Mount the Edge

You can install the bike mount to the stem or handlebars. The stem

installation (shown here) provides a more sturdy location. Make sure

that the Edge is facing up for the best GPS reception.

To install the Edge on your bike stem:

1. Place the wedge on the bike stem, and then place the bike

mount on the wedge. Make sure the release lever is on the left.

For horizontal bars: Separate and remove the top part of the

mount, turn it 90 degrees, and replace. Continue with step 2.

For bars with a diameter less than 1 in (25.4 mm): Place

the additional rubber pad under the bike mount to increase the

diameter of the bar. The rubber pad also keeps the mount from

slipping. Continue with step 2.

Getting Started

power

• Press and hold to turn unit on/off.

• Press to turn backlight on/off.

mode

• Press to switch modes.

• Press to return to the previous page.

reset/lap

• Press and hold to reset the timer.

• Press to create a new lap.

start/stop

Press to start/stop the timer.

up/down

• Press to highlight options.

• Press to scroll through menus and data ﬁelds.

• Press to adjust contrast when on the Satellite page.

enter

Press to select options and to acknowledge messages.

Note: If the Edge locks up, press mode reset/lap and simultaneously

to reset the unit.











































































3 4

mini-USB port under

weather cap

➍

Acquire Satellites

Acquiring satellite signals may take 30–60 seconds. For

troubleshooting information, refer to the owner’s manual.

To acquire satellite signals:

Go outdoors to an open area. Press and hold the

Power button to turn on the Edge.

On the Satellite page, the available satellites are

ﬂashing while the Edge searches for satellite

signals. Acquired satellites and each corresponding

bar below change to solid. The GPS accuracy

appears at the top of the page.

Wait while the Edge searches for satellites. For best

reception, make sure the Edge is facing up. Stand

still in an open area, and do not begin moving until

the Satellite page disappears. After the Satellite

page disappears, you can begin your ride.

Screens 4 and 5

apply to Edge 305

only.

123

release lever wedge

(optional)

bike mount



release lever

cable ties

Produktspezifikationen

Marke:	Garmin
Kategorie:	Navigator
Modell:	Edge 305
Akku-/Batteriebetriebsdauer:	12 h
Breite:	44 mm
Tiefe:	23 mm
Gewicht:	88 g
Höhe:	94 mm
Display-Auflösung:	128 x 160 Pixel