Frigidaire PLCF489CC Bedienungsanleitung

Frigidaire Herde PLCF489CC

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Frigidaire PLCF489CC (24 Seiten) in der Kategorie Herde. Dieser Bedienungsanleitung war für 14 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/24

40" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS

(Models with Electric Ovens and Gas Cooktop)

If the information in this manual is not followed exactly, a fire or explosion may result

causing property damage, personal injury or death.

FOR YOUR SAFETY:

— Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or

any other appliance.

— WHAT TO DO IF YOU SMELL GAS:

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any phone in your building.

• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's

instructions.

• If you cannot reach your gas supplier, call the fire department.

— Installation and service must be performed by a qualified installer, service agency or the gas

supplier.

P/N 318201755 (0410) Rev. B

English - pages 1-11

Español - páginas 12-22

Wiring Diagram - page 23-24

NOTE: 24" (61 cm) minimum clearance between the

cooktop and the bottom of the cabinet when the bottom

of wood or metal cabinet is protected by not less than

1/4" (0.64 cm) flame retardant millboard covered with not

less than No. 28 MSG sheet metal, 0.015" (0.4 mm)

stainless steel, 0.024" (0.6 mm) aluminum, or 0.020" (0.5

mm) copper.

30" (76.2 cm) minimum clearance when the cabinet is

unprotected.

Do not pinch the power supply cord between the range

and the wall.

Do not seal the range to the side cabinets.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

OBSERVE ALL GOVERNING CODES AND ORDINANCES.

A. HEIGHT B. WITDH C. DEPTH TO FRONT D. DEPTH WITH E. MINIMUM F. HEIGHT OF

OF RANGE DOOR OPEN CUTOUT WIDTH COUNTERTOP

46 3/4" (118.7 cm) 40 1/8" (101.9 cm) 25 7/8" (65.7 cm) 43 3/4" (111.1 cm) 40 1/4" (102.2 cm) 36" (91.4 cm) standard

35 3/8" (90 cm) min.

13" Min.

(33 cm Min.)

24" Min.

(61 cm Min.)

24 1/2" Max.

(62.2 cm Max.)

40 1/8" Min.

(101.9 cm Min.)

See

note

Grounded

Wall Outlet

WALL

2 1/2" Min.

(6.4 cm Min.)

Both sides,

if there is a wall

18" Min.

(45.7 cm Min.)

36" (91.4 cm)

with feet

extended

28 1/8" (71.4 cm) with

handle

Printed in United States

40" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS

(Models with Electric Ovens and Gas Cooktop)

Important Notes to the Installer

1. Read all instructions contained in these installation

instructions before installing range.

2. Remove all packing material from the oven

compartments before connecting the electrical supply

to the range (see "Preparation", page 8).

3. Install the 4 shipping bolts from range

packaging as range leveling legs (see "Leveling the

Range", page 8).

4. Two anti-tip brackets MUST be removed from

lower back of range and MUST be installed (see

"Anti-tip Bracket Installation", page 10).

5. Observe all governing codes and ordinances.

6. Be sure to leave these instructions with the consumer.

Important Note to the Consumer

Keep these instructions with your owner's guide for future

reference.

IMPORTANT SAFETY

INSTRUCTIONS

Installation of this range must conform with local codes

or, in the absence of local codes, with the National Fuel

Gas Code ANSI Z223.1-latest edition.

This range has been designed certified by the American

Gas Association. As with any appliance using gas and

generating heat, there are certain safety precautions you

should follow. You will find them in the Use and Care

Guide, read it carefully.

• Be sure your range is installed and grounded

properly by a qualified installer or service

technician.

• This range must be electrically grounded in

accordance with local codes or, in their absence,

with the National Electrical Code ANSI/NFPA No.

70—latest edition (See grounding Instructions on

page 4).

• The installation of appliances designed for

manufactured (mobile) home installation must conform

with Manufactured Home Construction

and Safety Standard, title 24CFR, part 3280 [Formerly

the Federal Standard for Mobile Home Construction

and Safety, title 24, HUD (part 280)] or when such

standard is not applicable, the Standard for

Manufactured Home Installation 1982 (Manufactured

Home Sites, Communities and Setups), ANSI Z225.1/

NFPA 501A-latest edition, or with local codes.

• Make sure the wall coverings around the range

can withstand the heat generated by the range.

• Before installing the range in an area covered

with linoleum or any other synthetic floor

covering, make sure the floor covering can

withstand heat at least 90°F/32°C above room

temperature without shrinking, warping or

discoloring. Do not install the range over carpeting

unless you place an insulating pad or sheet of 1/4" (6.4

mm) thick plywood between the range and carpeting.

• Do not obstruct the flow of combustion air at the

oven vent nor around the base or beneath the

lower front panel of the range. Avoid touching the

vent openings or nearby surfaces as they may become

hot while the oven is in operation. This range requires

fresh air for proper burner combustion.

Never leave children alone or

unattended in the area where an appliance is in use.

As children grow, teach them the proper, safe use of all

appliances. Never leave the oven door open when the

range is unattended.

Stepping, leaning or sitting on the

door(s) or drawer of this range can result in serious

injuries and can also cause damage to the range.

• Do not store items of interest to children in the

cabinets above the range. Children could be seriously

burned climbing on the range to reach items.

• To eliminate the need to reach over the surface

units, cabinet storage space above the units

should be avoided.

• Adjust surface burner flame size so it does not

extend beyond the edge of the cooking utensil.

Excessive flame is hazardous.

•Do not use the oven as a storage space. This

creates a potentially hazardous situation.

• Never use your range for warming or heating the

room. Prolonged use of the range without adequate

ventilation can be dangerous.

• Do not store or use gasoline or other flammable

vapors and liquids near this or any other

appliance. Explosions or fires could result.

•In the event of an electrical power outage, the surface

burners can be lit manually. To light a surface burner,

hold a lit match to the burner head and slowly turn the

Surface Control knob to Lite. Use caution when lighting

surface burners manually.

• Reset all controls to the "off" position after using

a programmable timing operation.

reduce the risk of tipping

of the range, the range

must be secured by

properly installed anti-tip

bracket (s) provided with

the range. To check if the

bracket (s) is installed

properly, remove the

lower panel or storage

•All ranges

can tip.

• Injury to

persons

could result.

• Install anti-tip

device

40" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS

(Models with Electric Ovens and Gas Cooktop)

Power Supply Cord Kit

The user is responsible for connecting the power supply

cord to the connection block located behind the back

panel access cover.

This appliance may be connected by means of

permanent "hard wiring" (flexible armored or

nonmetallic shielded copper cable), or by means of a

power supply cord kit. Use only a power supply cord kit

rated at 125/250 volts minimum, 40 amperes minimum

and marked for use with ranges. See chart (below) for

cord kit connection opening size and rating information.

Cord must have either 3 or 4 conductors.

For mobile homes, new installations, recreational

vehicles, or areas where local codes do not permit

grounding through neutral, a 4 conductor power supply

cord kit rated at 125/250 volts minimum, 40 amperes

and marked for use with ranges should be used (see

Figure 4).

Terminals on end of wires must either be closed loop or

open-end spade lugs with upturned ends. Cord must

have strain relief clamp.

Risk of fire or electrical shock exists if

an incorrect size range cord kit is used, if the

Installation Instructions are not followed, or if the

strain relief bracket is discarded.

NOTE: Dual-fuel range is shipped from factory with

1 1/8" dia. hole as shown in figure 3. If a larger hole

is required, punch out the knockout.

Three Conductor Wire Connection to Range

(The 3-conductor cord or cable must be replaced with a

4-conductor cord or cable where grounding through the

neutral conductor is prohibited in new installations,

mobile homes, recreational vehicles or in other areas

where local codes do not permit neutral grounding)

If local codes permit connection of the frame grounding

conductor to the neutral wire of the copper power supply

cord (see Figure 3):

1. Remove the 3 screws at the lower end of the rear

wire cover, then bend the lower end of the rear wire

cover (access

cover) upward

to expose range

terminal

connection

block (see

Figure 2).

Figure 1

3-Wire Power

Supply Cord Kit

3-Wire Wall

Receptacle

Electrical Connection to the Range

This appliance is manufactured with the neutral terminal

connected to the range.

While connecting range, do not

loosen the nuts which secure the terminal block to

the range. Electrical failure or loss of electrical

connection may occur.

Note: Refer to the wiring diagram at the end of this

manual.

Electrical Shock Hazard

• Electrical ground is required on this appliance.

• Do not connect to the electrical supply until

appliance is permanently grounded.

• Disconnect power to the circuit breaker or fuse

box before making the electrical connection.

• This appliance must be connected to a

grounded, metallic, permanent wiring system,

or a grounding connector should be connected

to the grounding terminal or wire lead on the

appliance.

• Do not use the gas supply line for grounding

the appliance.

Failure to do any of the above could result in a

fire, personal injury or electrical shock.

Range Connection Opening Size Chart

Refer to chart below for proper range connection opening size

and power supply cord kit ampere rating information. See serial

plate on range for kilowatt rating data.

Minimum

Cord kit

Ampere

Rating

40 Amp

50 Amp

Range Kilowatt Rating

(See Serial Plate on Range)

120/240 Volts 120/208 Volts

0 -16.5 kW 0 -12.5 kW

16.6-22.5 kW 12.6-18.5 kW

Diameter (inches) of Range

Connection Opening

Direct

Cord Kit Connection

1-3/8 in. 1-1/8 in.

1-3/8 in. 1-3/8 in.

Figure 2

Rear wire

access cover

Pressure

regulator location

Produktspezifikationen

Marke:	Frigidaire
Kategorie:	Herde
Modell:	PLCF489CC

Brauchst du Hilfe?

Wenn Sie Hilfe mit Frigidaire PLCF489CC benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten

Ihren Namen*

Deine E-Mail*

Schreiben Sie hier Ihre Frage

Bedienungsanleitung Herde Frigidaire

Frigidaire GLEFZ389HC Bedienungsanleitung

28 Mai 2024

Frigidaire FFEF3016UB Bedienungsanleitung

27 Mai 2024

Frigidaire GCCE3049AS Bedienungsanleitung

27 Mai 2024

Frigidaire GLEC30S8EB Bedienungsanleitung

24 Mai 2024

Frigidaire FFGS3025PS Bedienungsanleitung

22 Mai 2024

Frigidaire FFGH3054UW Bedienungsanleitung

21 Mai 2024

Frigidaire GLGC36S8CS Bedienungsanleitung

14 Mai 2024

Frigidaire FCFE3062AS Bedienungsanleitung

11 Mai 2024

Frigidaire FFES3015LS Bedienungsanleitung

10 Mai 2024

Frigidaire FGF316DQ Bedienungsanleitung

6 Mai 2024

Bedienungsanleitung Herde

Neueste Bedienungsanleitung für -Kategorien-

Nemco 9130A Bedienungsanleitung

18 August 2024

Meireles MI 1600 Bedienungsanleitung

12 August 2024

BEKO HIGG 64123 SB Bedienungsanleitung

5 August 2024

NABO KFC 6060 Bedienungsanleitung

28 Juni 2024

NABO KFI 6010 Bedienungsanleitung

28 Juni 2024

NABO KFC 3000 Bedienungsanleitung

28 Juni 2024

NABO HS 4062 Bedienungsanleitung

28 Juni 2024

AEG TI64IB10IZ Bedienungsanleitung

27 Juni 2024

BORA M Pure Bedienungsanleitung

27 Juni 2024

BORA Basic Bedienungsanleitung

27 Juni 2024