Frigidaire FHWH084WB1 Bedienungsanleitung

Frigidaire Klimaanlage FHWH084WB1

Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Frigidaire FHWH084WB1 (20 Seiten) in der Kategorie Klimaanlage. Dieser Bedienungsanleitung war fĂĽr 3 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/20
Fig. C
Fig. B
READ BEFORE INSTALLING UNIT
Compact Window Mounting (8,000~12,000 BTU)
Installation Instructions
Before installing, the top rail must be assembled on the unit.
Top Rail Hardware Qty.
4
1
Top Rail
The top rail on your unit may already be installed. If not,
follow the steps below.
Drill (If pilot holes are needed)
N
O
TE
:
the best way to store unit during winter, or when not
in use.
7
1
Mounting Hardware Qty.
2
s)
2
( or Wooden windows)
weather stripping
(10”X3/4”X1/12”) 5
window sash seal foam 1
Top Rail
The unit is for window mounting only.
INSTALLATION WARNINGS AND CAUTION
Pay attention to danger and safety notices.
be exposed:
Carefully inspect location where air conditioner will be inst
period of time.
Handle air conditioner with care.
Carefully read the installation manual before beginning.
16120300A29476
Side louvers and the rear of the air conditioner must have clear air space to allow enough airflow through the
The appliance with electric heater shall have at least 1 meter space to the combustible materials.
condenser, for heat removal. The rear of the unit must be outdoors, not inside a building or garage. There should be
at least 11.8
inches (300mm) clearance around the unit. See FIG. 4C & FIG. 4D.
Indoor side
Outdoor side
11.8" min
(300 mm)
11.8" min
(300 mm)
11.8" min
(300 mm)
11.8" min
(300 mm)
11.8" min
(300 mm)
11.8" min
(300 mm)
11.8" min (300 mm) 11.8" min (300 mm)
11.8" min (300 mm)
FIG. 4D
FIG. 4C
11.8" min (300 mm)
Outdoor side Indoor side
NOTE: Top Rail and Side Panels at each side are offset to provide the proper pitch to the rear of (5/16”).
This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels
for any reason, this pitch to the rear must be maintained!
Place unit on floor, a bench or a table. There is a Left and Right side Filler Panels - be sure to use the proper
panel for each side. When installed, the flange for securing the panel in place to the window sill will be facing
into the room.
A. Hold the side Panel in one hand and gently pull back the center to free the open end. See FIG. 1.
B. Slide the free end “ ” section of the panel directly into the cabinet as shown in FIG. 2. Slide the panel down. Be
sure to leave enough space to slip the top and bottom of the frame into the rails on the cabinet.
LEFT + RIGHT FILLER PANEL ASSEMBLY
FIG. 1
C. Once the panel has been installed on the side of the cabinet, make sure it sits securely inside the frame channel by
making slight adjustments. Slide the top and bottom ends of the frame into the top and bottom rails of the cabinet. See
FIG. 3.
D. Slide the panel all the way in and repeat on the other side.
2
Installation
Top Rail
Bottom Rail
Your air conditioner is designed to install in standard double hung windows with opening widths of 25 to 36 inches
(635mm to 914 mm) (FIG. 4A & FIG. 4B)
Lower sash must open sufficiently to allow a clear vertical opening of 15-1/2 inches (394 mm ).
Fig. 4A
394 mm
Wooden Windows
Fig. 4B
394 mm
Vinyl-Clad Windows
INNER
WINDOW SILL INNER
WINDOW SILL
INTERIOR
WALL
T
“ ” section
T
FIG. 2 FIG. 3
25" to 36"
635mm to 914mm
25" to 36"
635mm to 914mm
Installation
3


Produktspezifikationen

Marke: Frigidaire
Kategorie: Klimaanlage
Modell: FHWH084WB1

Brauchst du Hilfe?

Wenn Sie Hilfe mit Frigidaire FHWH084WB1 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Klimaanlage Frigidaire

Bedienungsanleitung Klimaanlage

Neueste Bedienungsanleitung fĂĽr -Kategorien-