Frigidaire FFRA0522U1 Bedienungsanleitung

Frigidaire Klimaanlage FFRA0522U1

Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Frigidaire FFRA0522U1 (4 Seiten) in der Kategorie Klimaanlage. Dieser Bedienungsanleitung war fĂĽr 3 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/4
READ BEFORE INSTALLING UNIT
BT Window Mounting (5,000 BTU)
1
Installation Instructions
Before installing, the top rail must be assembled on the unit.
Top Rail Hardware Qty.
4
1
Top Rail Drill (If pilot holes are needed)
7
1
Mounting Hardware Qty.
2
(For Vinyl-Clad windows)
NOTE:
the best way to store unit during winter, or when not
in use.
2
(For Wooden windows)
Top Rail
Fig. C
weather seals 5
window sash seal foam 1
be exposed:
Carefully read the installation manual before beginning.
INSTALLATION WARNINGS AND CAUTION
Fig. B
Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit over an extended
period of time.
66129926560
NOTE: Top Rail and Side Panels at each side are oset to provide the proper pitch to the rear. This is
necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any
reason, this pitch to the rear must be maintained!
Place unit on floor, a bench or a table. There is a Left and Right side Filler Panels - be sure to use the proper
panel for each side. When installed, the flange for securing the panel in place to the window sill will be facing
into the room.
A. Hold the side Panel in one hand and gently pull back the center to free the open end. See FIG. 1.
B. Slide the free end “ ” section of the panel directly into the cabinet as shown in FIG. 2. Slide the panel down. Be T
sure to leave enough space to slip the top and bottom of the frame into the rails on the cabinet.
LEFT + RIGHT FILLER PANEL ASSEMBLY
FIG. 2 FIG. 3FIG. 1
C. Once the panel has been installed on the side of the cabinet, make sure it sits securely inside the frame channel by
making slight adjustments. Slide the top and bottom ends of the frame into the top and bottom rails of the cabinet. See
FIG. 3.
D. Slide the panel all the way in and repeat on the other side.
2
Installation
“T” section Top Rail
Bottom Rail
Cut the seal foam(adherent type) into proper length. Then stick the seal foam at the lower part of the window frame.
Your air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches
(584 mm to 914 mm) (FIG. 4A & FIG. 4B)
Lower sash must open sufficiently to allow a clear vertical opening of 14.5 inches (368 mm ). Side louvers and the rear of
the air conditioner must have clear air space to allow enough airflow through the condenser, for heat removal. The rear
of the unit must be outdoors, not inside a building or garage.
SEAL FOAM
Fig. 4A
Wooden Windows
Fig. 4B
Vinyl-Clad Windows
INNER
WINDOW SILL INNER
WINDOW SILL
INTERIOR
WALL
If the air conditioner is blocked by Storm Window, add wood as
shown in FIG. 5, or remove storm window before air conditioner
is installed.
If Storm Window Frame must remain, be sure the drain holes or
slots are not caulked or painted shut. Accumulated Rain Water
or Condensation must be allowed to drain out.
Storm Window: FIG. 5
Board
thickness as
required, for
proper pitch to
rear, along
entire sill.
Fasten with
nails or screws.
Storm window
frame or other
obstruction.
SASH
1-1/2” min
(38 mm)
14.5" min
(368 mm)
14.5" min
(368 mm)
SEAL FOAM
Installation
Extend the side panels out against the window frame (FIG. 7A for wooden windows), (FIG. 7B for Vinyl-Clad
windows).
Place the frame lock between the frame extensions and the window sill as shown (FIG. 8A for wooden
windows), (FIG. 8B for Vinyl-Clad windows).
FIG. 8A
A: For wooden windows:
NOTE:
Before driving the screws, use a drill to drill 5 holes through the holes in the frame lock and frame extensions
B: For Vinyl-Clad windows:
FIG. 8B
3
FIG. 7BFIG. 7A
NOTE:To prevent
Drive locking screws:
Vinyl-Clad windows:Wooden windows:
Keep a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air
conditioner frame is against the window sill (FIG. 6A & FIG. 6B). Carefully close the window behind the top rail
of the unit.
OUTSIDEINSIDE
FIG. 6B
Vinyl-Clad WindowsWooden Windows
INSIDE OUTSIDE
FIG. 6A
window
frame

Produktspezifikationen

Marke: Frigidaire
Kategorie: Klimaanlage
Modell: FFRA0522U1

Brauchst du Hilfe?

Wenn Sie Hilfe mit Frigidaire FFRA0522U1 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Klimaanlage Frigidaire

Frigidaire

Frigidaire FFRA052WA1 Bedienungsanleitung

10 Oktober 2024
Frigidaire

Frigidaire CPA093DU1 Bedienungsanleitung

6 Oktober 2024
Frigidaire

Frigidaire FHTC142WA2 Bedienungsanleitung

4 Oktober 2024
Frigidaire

Frigidaire FAH125P2T Bedienungsanleitung

2 Oktober 2024
Frigidaire

Frigidaire FFRA121ZAE Bedienungsanleitung

29 September 2024
Frigidaire

Frigidaire FRA126CT1 Bedienungsanleitung

23 September 2024
Frigidaire

Frigidaire FHWW183WC2 Bedienungsanleitung

21 September 2024
Frigidaire

Frigidaire FFTH122WA2 Bedienungsanleitung

20 September 2024
Frigidaire

Frigidaire FFRA122WA1 Bedienungsanleitung

18 September 2024
Frigidaire

Frigidaire FFRE0633S1 Bedienungsanleitung

14 September 2024

Bedienungsanleitung Klimaanlage

Neueste Bedienungsanleitung fĂĽr -Kategorien-

MundoClima

MundoClima MUCSR-H3 Bedienungsanleitung

16 Oktober 2024
Duux

Duux DXMA10 North Bedienungsanleitung

16 Oktober 2024
Duux

Duux DXAC04 Bedienungsanleitung

16 Oktober 2024
LG

LG HS-H076QPA0 Bedienungsanleitung

16 Oktober 2024
Klarstein

Klarstein Vita Pure 2G Bedienungsanleitung

16 Oktober 2024
Einhell

Einhell BMK 2400E Bedienungsanleitung

15 Oktober 2024
Qlima

Qlima P 126 Bedienungsanleitung

15 Oktober 2024
Amana

Amana PTC093K35AXXX Bedienungsanleitung

15 Oktober 2024
Amana

Amana AMAP121AB-2 Bedienungsanleitung

15 Oktober 2024
Amana

Amana PTC173J35AXXX Bedienungsanleitung

15 Oktober 2024