Fisher & Paykel OB60SMPTDG1 Bedienungsanleitung

Fisher & Paykel Ofen OB60SMPTDG1

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Fisher & Paykel OB60SMPTDG1 (13 Seiten) in der Kategorie Ofen. Dieser Bedienungsanleitung war für 10 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/13
MINIMAL
OB60SMPTDG1, OB60SMPTNG1, OB60SMPTDB1,
OB60SMPTNB1, OB60SM16PLG1 & OB60SM16PLB1
CONTEMPORARY
OB60SDPTDX2, OB60SD16PLX1, OB60SD13PLX1,
OB60SD11PLX1 & OB60SD9PLX1
BUILT-IN OVEN
INSTALLATION GUI D E
NZ AU UK IE
2
! WARNING!
Electric Shock Hazard
Failure to follow this advice may result in
electric shock or death.
Before carrying out any work on the
electrical section of the appliance, it must
be disconnected from the mains electricity
supply.
Connection to a good earth wiring system is
absolutely essential and mandatory.
Alterations to the domestic wiring system
must only be made by a qualified electrician.
! WARNING!
Fire Hazard
Failure to follow this advice may result in
overheating, burning, and injury.
Do not use adapters, reducers, or branching
devices to connect this appliance to the
mains power supply.
! WARNING!
Cut Hazard
Failure to use caution could result in injury.
Take care: some edges are sharp.
IMPORTANT!
SAVE THESE INSTRUCTIONS
The models shown in this installation guide may not be available in all markets and are subject to
change at any time. For current details about model and specification availability in your country,
please go to our website www.fisherpaykel.com or contact your local Fisher & Paykel dealer.
WARNING!
To avoid hazard, follow these instructions carefully before installing or using this appliance.
Please make this information available to the person installing the appliance—doing so could
reduce your installation costs.
This appliance must be installed and connected to the mains power supply only by a
suitably qualified person according to these installation instructions and in compliance
with any applicable local building and electricity regulations. Failure to install the appliance
correctly could invalidate any warranty or liability claims.
If the power supply cable is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified person in order to avoid a hazard.
Isolating switch: make sure this oven is connected to a circuit which incorporates an
isolating switch providing full disconnection from the power supply in accordance with the
wiring rules.
The oven must be earthed.
Do not use adaptors, reducers or branching devices to connect the oven to the mains
electricity supply, as they can cause overheating and burning.
The appliance must not be installed behind a decorative door in order to avoid overheating.
Please take extra care not to damage the lower trim of the oven during installation. The
trim is important for correct air circulation and allows the door to open and close without
obstruction. The manufacturer does not accept any responsibility for damage resulting from
incorrect installation.
SAFETY AND WARNINGS
PRIOR TO INSTALLATION INSTALLATION MILESTONES
AFTER INSTALLATION
Ensure that:
The countertop and oven cavity are square and level, and are the required dimensions.
The installation will comply with all clearance requirements and applicable standards and
regulations.
The isolating switch will be easily accessible to the customer with the oven installed.
The electrician provides sufficient free length of power supply cable to reach from the
bottom rear of the cavity to at least 1.5 metres in front of the bottom edge of the opening.
The cable may enter the cavity from the side, top or bottom, but top entry must be at the
rear of the cavity.
The oven connection socket (if fitted) is outside the cavity if the oven is flush to the rear
wall.
The oven will rest on a surface that can support its weight.
The height from the floor suits the customer.
You consult local building authorities and by-laws if in doubt regarding installation.
IMPORTANT!
Some environmental factors and cooking habits can cause condensation in and around the
oven during use. To protect surrounding cabinetry from possible damage caused by frequent
or excessive condensation, we recommend moisture-proofing the oven cavity.
These milestones represent areas throughout
that are pivotal to an optimal installation
outcome. These steps require additional
installer attention and should be quality
checked once completed.
Ensure both hinges are fully locked before shutting the door.
Align oven with surrounding cabinetry and appliances.
Milestone indicator
MILESTONE LINKS
zThe oven door can open fully without obstruction.
zThe power supply cable does not touch any hot metal parts.
zThe isolating switch is easily accessible to the customer with the oven installed.
zYou complete the ‘Final checklist’ at the end of the installation.
zIf, after following the instructions given, correct performance cannot be achieved, please
contact your nearest Fisher & Paykel Authorised Service Centre, Customer Care, or contact us
through our local website listed at the end of this document.
3


Produktspezifikationen

Marke: Fisher & Paykel
Kategorie: Ofen
Modell: OB60SMPTDG1

Brauchst du Hilfe?

Wenn Sie Hilfe mit Fisher & Paykel OB60SMPTDG1 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Ofen Fisher & Paykel

Bedienungsanleitung Ofen

Neueste Bedienungsanleitung für -Kategorien-