Fisher & Paykel OB24SDPTDX2 Bedienungsanleitung

Fisher & Paykel Ofen OB24SDPTDX2

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Fisher & Paykel OB24SDPTDX2 (10 Seiten) in der Kategorie Ofen. Dieser Bedienungsanleitung war für 6 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/10

OB24SDPT models

BUILT-IN OVEN

INSTALL ATI O N GU I D E

US CA

591 944 B 09.2 2

! WARNING!

Electric Shock Hazard

Failure to follow this advice may result in

electric shock or death.

• Before carrying out any work on the

electrical section of the appliance, it must be

disconnected from the mains electricity supply.

• Connection to a good ground wiring system is

absolutely essential and mandatory.

• Alterations to the domestic wiring system

must only be made by a qualified electrician

! WARNING!

Fire Hazard

Failure to follow this advice may result in

overheating, burning, and injury.

• Do not use adapters, reducers, or branching

devices to connect this appliance to the mains

power supply.

! WARNING!

Cut Hazard

Failure to use caution could result in injury.

• Take care: some edges are sharp.

IMPORTANT!

SAVE THESE INSTRUCTIONS

The models shown in this installation guide may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please go

to our website www.fisherpaykel.com or contact your local Fisher & Paykel dealer.

WARNING!

To avoid hazard, follow these instructions carefully before installing or using this appliance.

zPlease make this information available to the person installing the appliance doing so could —

reduce your installation costs.

zSave these instructions for the local inspectors use.

zThis oven is to be installed and connected to the electricity supply only by an authorized person.

zIf the installation requires alterations to the domestic electrical system, call a qualified electrician.

The electrician should also check that the socket cable section is suitable for the electricity drawn

by the oven.

zThe oven must be grounded.

zInstallation must comply with your local building and electricity regulations.

zThis appliance must be installed and connected to the mains power supply only by a suitably

qualified person according to these installation instructions and in compliance with any applicable

local building and electricity regulations. Failure to install the appliance correctly could invalidate

any warranty or liability claims.

zIf the power supply cable is damaged, it must be replaced by the manufacturer, its service agent

or similarly qualified person in order to avoid a hazard.

zA circuit breaker is recommended.

zDo not use adaptors, reducers or branching devices to connect the oven to the mains electricity

supply, as they can cause overheating and burning.

zMake sure the cavity is completely sealed with no gaps. This is to ensure the oven cooling system

functions correctly.

zThe appliance must not be installed behind a decorative door in order to avoid overheating.

zPlease take extra care not to damage the lower trim of the oven during installation. The trim is

important for correct air circulation and allows the door to open and close without obstruction.

The manufacturer does not accept any responsibility for damage resulting from incorrect

installation.

Electrical requirements

zConnect oven with copper wire only.

zDo not cut the conduit.

zA U.L. listed conduit connector must be provided at the junction box.

zDo not ground to a gas pipe.

zDo not have a fuse in the grounding or neutral circuit.

zFuse both sides of the line.

zA time delay fuse or circuit breaker is recommended. If using a time delay fuse, then fuse both

sides of the line.

zFlexible armored cable from the appliance should be connected directly to the junction box.

zConnect directly to the fused disconnect (or circuit breaker box) through flexible, armored or

non-metallic sheathed, copper cable (with grounding wire).

zIf codes permit and a separate grounding wire is used, it is recommended that a qualified

electrician determine that the grounding path and wire gauge are in accordance with local codes.

SAFETY AND WARNINGS

Screws (2) Metal side shelves

fixing nut (2)

Ensure that:

zthe countertop and oven cavity are square and level, and are the required dimensions

zthe installation will comply with all clearance requirements and applicable standards and regulations

zthe isolating switch will be easily accessible to the customer with the oven installed

zthe electrician provides sufficient free length of power supply cable to reach from the bottom rear of the cavity to at least 1.5 metres in front of the bottom edge of the opening

zthe cable may enter the cavity from the side, top or bottom, but top entry must be at the rear of the cavity

zthe oven connection socket (if fitted) is outside the cavity if the oven is flush to the rear wall

zthe oven will rest on a surface that can support its weight

zthe height from the floor suits the customer

zyou consult local building authorities and by-laws if in doubt regarding installation

IMPORTANT!

Some environmental factors and cooking habits can cause condensation in and around the oven during use. To protect surrounding cabinetry from possible damage caused by frequent or

excessive condensation, we recommend moisture-proofing the oven cavity.

Ensure that:

zthe oven door can open fully without obstruction

zthe oven is not sealed into the cabinetry with silicone or glue. This makes future servicing difficult. Fisher & Paykel will not cover the costs of removing the oven, or of damage caused by this

removal

zthe power supply cable does not touch any hot metal parts

zthe isolating switch is easily accessible to the customer with the oven installed

zyou complete the ‘Final checklist’ at the end of the installation

If, after following the guidance given, correct performance cannot be achieved, please contact your nearest Fisher & Paykel trained and supported service technician, Customer Care, or contact

us through our website fisherpaykel.com

PARTS SUPPLIED

PRIOR TO INSTALLATION

AFTER INSTALLATION