Fender Hot Rod DeVille 212 IV Bedienungsanleitung
Fender
Gitarrenverstärker
Hot Rod DeVille 212 IV
Lesen Sie kostenlos die đ deutsche Bedienungsanleitung fĂźr Fender Hot Rod DeVille 212 IV (24 Seiten) in der Kategorie Gitarrenverstärker. Dieser Bedienungsanleitung war fĂźr 22 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/24
OWNERâS MANUAL
MANUAL DE INSTRUCCIONES
MODE DâEMPLOI
MANUALE UTENTE
BEDIENUNGSHANDBUCH
MANUAL DO PROPRIETĂRIO
ăŞăźăăźăşăťăăăĽă˘ăŤ
2
ENGLISH
Working guitarists everywhere prize Hot Rod amps for their great volume, reliability, responsiveness to eîects pedals, and aîord-
ability. The Hot Rod Deluxe IV is a scorching 40-watt 1x12â tube combo decked out with power and performance to spare, great
features and a classic look.
The Hot Rod DeVille is the standard for gigging guitarists worldwide and the ideal amp for crafting your own signature sound. The
Hot Rod DeVille IV combo delivers the goods and then some, with 60 watts of tube power driving a scorching pair of 12â speak-
ers, hot-rodded performance to spare, great features and a classic look.
Features include:
⢠Modiîed preamp circuitry for increased note deînition in the overdrive channels
⢠Spring Reverb smoothness mod
⢠CelestionÂŽ 12â A-TYPE speakers
⢠Steel-reinforced strap handle
⢠Ivory pointer knobs
⢠Improved control panel texture and graphics
⢠Lightly aged silver grille cloth
⢠Pine cabinet for weight reduction
⢠Cover and two-button footswitch
MOR E
DR IVE
NO R MAL
BRIGHT
21
ON
OFF
ON
STANDBY
CHANNE L
SELECT
PRESENCEREVERBMASTERMIDDLEBASSTREBLEDRIVEVOLUME
INPUTS
POWER
AMP IN
PREAMP
OUT
FOOT
SWITCH
1
2
3
4
56 7 8
9
10
11
121
2
3
4
56 7 8
9
10
11
121
2
3
4
56 7 8
9
10
11
121
2
3
4
56 7 8
9
10
11
121
2
3
4
56 7 8
9
10
11
12 1
2
3
4
56 7 8
9
10
11
121
2
3
4
56 7 8
9
10
11
121
2
3
4
56 7 8
9
10
11
12
CONTROL PANEL
A. INPUT 1: Normal sensitivity input ideal for use with most
guitars. Either input jack can be used with any type of
guitar depending on the tonal character you prefer.
Experiment and use the input that sounds best to you.
B. INPUT 2: Lower sensitivity input (-îdB) provides cleaner
response with high-output and pre-amplified guitars.
You
can use input 1 and Input 2 simultaneously with two
guitars or a guitar and a microphone, for example. Input
sensitivities become equal when used simultaneously.
C. NORMAL/BRIGHT: Press in to boost high-frequency
tones of NORMAL channel.
D. VOLUME: Adjusts volume of NORMAL channel.
E. MORE DRIVE: Press in to boost gain and distortion of
the DRIVE channel.
F. DRIVE: Increase DRIVE setting to produce more
distortion and sustain. Use lower DRIVE settings to
produce cleaner sounds.
G. CHANNEL INDICATOR: NORMAL
channel (off),
DRIVE
channel (yellow), MORE
DRIVE
channel (red).
H. TREBLE: Adjusts high-frequency tone.
I. BASS: Adjusts low-frequency tone.
J. MIDDLE: Adjusts mid-frequency tone.
K. CHANNEL SELECT: NORMAL channel (out), DRIVE
channel (in).
L. MASTER: Use to adjust loudness of the DRIVE and MORE
DRIVE channels in conjunction with DRIVE (F).
M. REVERB: Adjusts level of the reverb effect.
N. PRESENCE: Adjusts tone at a point in the signal path
after the preamp circuitry to provide unique ultra high-
frequency tone shaping.
O. PREAMP OUT/POWER AMP IN: Multi-functional
input/output jacks that can be used in a variety of
configurations:
Effects Loop: Connect PREAMP OUT to the input of your
effects device and connect effects output to the POWER
AMP IN jack.
Multiple Hot Rod Amps: Connect PREAMP OUT on
primary unit to POWER AMP IN on auxiliary unit. The
primary unit is used to control all auxiliary units, except
HOT ROD DEVILLE⢠IV and HOT ROD DELUXE⢠IV
3
ENGLISH
CHASSIS REAR VIEW
for REVERB and PRESENCE, which remain active on each
auxiliary unit.
Recording/Sound Reinforcement: Connect PREAMP
OUT to input jack of sound equipment.
Use instrument (shielded) cables with TS (tip-sleeve)
plugs for connections. Both PREAMP OUT and POWER
AMP IN jacks are located before Reverb and Presence in
signal path.
P. FOOTSWITCH: Connect included footswitch here to
enable remote selection of NORMAL/DRIVE/MORE DRIVE
channels. CHANNEL SELECT (K) button on control panel
is disabled when footswitch is connected. Speaker cable
(unshielded) is superior to instrument cable (shielded)
for connecting footswitch.
Q. POWER INDICATOR: Illuminates when unit is on.
Unscrew red jewel to access bulb (type Tîî) for
replacement.
R. STANDBY: Use STANDBY instead of switching power off
during short breaks to avoid having to wait for tubes
to warm up when you want to start playing again.
Also, keep amplifier on STANDBY for first îî seconds
when you first switch power on to give tubes a gentle
warm up cycle. will extend lifespan of Using STANDBY
amplifierâs tubes by reducing shock of heat-up / cool-
down cycle on tube filaments.
S. POWER: Turns amplifier on and off.
T. POWER CORD: Connect to a grounded outlet in
accordance with the voltage and frequency ratings
specified on the rear panel of your amplifier.
U. FUSE: The fuse protects the unit from electrical faults.
Replace fuses only with the type and rating specified on
the fuse holder. If the unit repeatedly blows fuses, have the
unit tested at an authorized Fender Service Center.
V. MAIN SPEAKER JACK: One of the following speaker
configurations (internal or external) must always be
connected when the unit is ON to prevent damage to the
amplifier:
Deluxe IV DeVille IV
* Insert an open plug (without speakers connected) into Main
Speaker jack (V) for configuration three.
W. EXTERNAL SPEAKER JACK: This jack is wired in parallel with
the main speaker jack and must only be used with a speaker
load or an open plug connected to the main speaker jack, as
shown above in the MAIN SPEAKER JACK diagram.
X. TUBES: Your new Fender amplifier comes equipped
with the highest quality tubes available, sourced from
various manufacturers worldwide. Because of occasional
irregularities in supply, the specific tube type used in each
amplifier is subject to change without notice.
When replacing output tubes, please note the specific tube
markings on the original tubes factory supplied with your
amplifier. For example, îLî output tube types used by Fender
include, but are not limited to: îLîGC; îLîWXT; îLîC; îLîGE;
etc. The installation of a different type may require significant
adjustment by a qualified technician to avoid reduction in
performance and tube life.
Additionally, Fender tests and sorts many of our output
tubes based on their measured performance. The sorted
tubes are marked with a label on the base with coarse
ratings of blue, white and red plus fine ratings of î-îî.
If your amp came supplied with, for example, a pair of
matched GT-îLî-GE power tubes ranked at white-î, then
any pair of GT-îLî-GE power tubes marked with a course
rating of white will be a good replacement. If the tube
replacements are marked as white-î, they will be a perfect
direct replacement.
If you have questions or concerns, contact your Fender
dealer or authorized service center.
Y. PREAMP TUBE STABILIZER: A vibration-absorbing
stabilizer is installed around the preamp tubes to minimize
the tube microphonics that normally develop over
time. The stabilizer can be used with all preamp tubes
compatible with your Hot Rod amplifier.
1.
2.
3.*
1.
2.
3.*
2
Produktspezifikationen
| Marke: | Fender |
| Kategorie: | Gitarrenverstärker |
| Modell: | Hot Rod DeVille 212 IV |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Fender Hot Rod DeVille 212 IV benĂśtigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Gitarrenverstärker Fender
3 Oktober 2024
3 Oktober 2024
3 Oktober 2024
3 Oktober 2024
3 Oktober 2024
21 August 2024
21 August 2024
21 August 2024
21 August 2024
21 August 2024
Bedienungsanleitung Gitarrenverstärker
- Gitarrenverstärker Valeton
- Gitarrenverstärker Roland
- Gitarrenverstärker Vox
- Gitarrenverstärker Yamaha
- Gitarrenverstärker Marshall
- Gitarrenverstärker Peavey
- Gitarrenverstärker Behringer
- Gitarrenverstärker Boss
- Gitarrenverstärker Line 6
- Gitarrenverstärker Radial Engineering
- Gitarrenverstärker Hartke
- Gitarrenverstärker ART
- Gitarrenverstärker Orange
- Gitarrenverstärker Harley Benton
- Gitarrenverstärker Electro Harmonix
- Gitarrenverstärker Blackstar
- Gitarrenverstärker Bugera
- Gitarrenverstärker TC Electronic
- Gitarrenverstärker Palmer
- Gitarrenverstärker Ampeg
- Gitarrenverstärker Laney
- Gitarrenverstärker SPL
- Gitarrenverstärker Ashdown Engineering
- Gitarrenverstärker Suhr
- Gitarrenverstärker AER
- Gitarrenverstärker Markbass
- Gitarrenverstärker EBS
- Gitarrenverstärker Fishman
- Gitarrenverstärker Voodoo Lab
- Gitarrenverstärker GR Bass
- Gitarrenverstärker Two Notes
- Gitarrenverstärker Hughes & Kettner
- Gitarrenverstärker Dimavery
- Gitarrenverstärker AMT
- Gitarrenverstärker Budda
- Gitarrenverstärker Empress Effects
- Gitarrenverstärker DACS Audio
- Gitarrenverstärker Rivera
- Gitarrenverstärker DV Mark
Neueste Bedienungsanleitung fĂźr -Kategorien-
23 September 2024
19 September 2024
16 September 2024
6 September 2024
5 September 2024
5 September 2024
5 September 2024
5 September 2024
5 September 2024
5 September 2024