Fellowes Fortishred 2250C Bedienungsanleitung

Fellowes Aktenvernichter Fortishred 2250C

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Fellowes Fortishred 2250C (8 Seiten) in der Kategorie Aktenvernichter. Dieser Bedienungsanleitung war für 11 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/8
Quality Office Products Since 1917
FORTISHREDTM 2250C/2250S/2250M
Please read these instructions before use.
Do not discard: keep for future reference.
Veuillez lire ces instructions avant d’utiliser l’appareil.
Ne pas jeter : conserver an de consulter les directives
ultĂŠrieurement, en cas de besoin.
Lea estas instrucciones antes del uso.
No las deseche: consĂŠrvelas como referencia futura.
ENGLISH
Model 2250C/2250S/2250M
Will shred:
2250C and 2250S: Paper, staples, paper clips, credit cards, CD/DVDs and junk mail.
2250M: Paper, paper clips, staples and credit cards.
Will not shred: Adhesive labels, continuous form paper, transparencies, newspaper,
cardboard, laminates, file folders, X-rays or plastic other than noted above
Paper shred size:
Strip-Cut ........................................................................................... 5/32 in. (4mm)
Cross-Cut ........................................................ 5/32 in. x 1-9/16 in. (4mm x 40mm)
Micro-Cut .......................................................... 2/32 in. x 9/16 in. (2mm x 15mm)
*In order to perform at capacity, shredder must be plugged into a dedicated 15Amp,
120V outlet and oiled every 15-30 minutes of continuous use.
Maximum:
Paper entry width ............................................................................. 10.25”/260mm
* 8.5”x11”, 20lb., (75g) paper at 120V, 60 Hz, 5.6Amps; heavier paper, humidity or other
than rated voltage may reduce capacity.
KEY
H. Control Panel and LEDs
1. ON/OFF (blue)
R
2. Reverse (red)
3. Bin full (yellow)
4. Door open (red)
5. Safety Shield Open (red)
A. Safety Shield
B. Paper entry
C. Disconnect switch (open door)
D. Door
E. Basket (inside)
F. Casters
G. See safety instructions
• Operation, maintenance, and service requirements are covered in the instruction
manual. Read the entire instruction manual before operating shredders.
• Keep away from children and pets. Keep hands away from paper entry. Always set
to off or unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder
openings. If object enters top opening, switch to Reverse (R) to back out object.
• Never use aerosol products, petroleum based lubricants or other flammable
products on or near shredder. Do not use canned air on shredder.
• Do not use if damaged or defective. Do not disassemble shredder.
Do not place near or over heat source or water.
• Do not operate the machine without the safety shield closed (A).
• This shredder has a Disconnect Power Switch in the cabinet door. The door must
be fully closed to operate shredder. In case of emergency, open cabinet door. This
action will stop shredding immediately.
• Avoid touching exposed cutting blades under shredder head.
• Shredder must be plugged into a properly grounded wall outlet or socket of the
voltage and amperage designated on the label. The grounded outlet or socket
must be installed near the equipment and easily accessible. Energy converters,
transformers, or extension cords should not be used with this product.
• FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
• For indoor use only.
• Unplug shredder before cleaning or servicing.
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
A.
B.
G.
H.
F.
C.
D.
E.
2
CAPABILITIES
BASIC SHREDDING OPERATIONBASIC SET UP
ADVANCED PRODUCT FEATURES
3
PRODUCT MAINTENANCE
Ensure access to a
dedicated 15Amp,
120V outlet
R
41 3
R
2
Open the door
1 2 34
or
5
R
Place cutter head into
top of cabinet, use 2
people
Plug in and make
sure door is closed
Press ( ) ON to
activate
When finished
shredding set to
( ) OFF
Feed paper straight
into paper entry and
release
Do nothing and shredder
will automatically shut
off after 30 minutes of
inactivity
Make sure safety flap
is securely in place
SHREDDER SET-UP
All cross-cut and micro-cut shredders require oil for peak performance. If not
oiled, a machine may experience diminished sheet capacity, intrusive noise
when shredding and could ultimately stop running. To avoid these problems,
we recommend you oil your shredder each time you empty your waste bin or
every 15-30 minutes of continuous use.
OILING SHREDDER
R
R
3
2
*Apply oil
across entry
Press Reverse (R)
Set to Off ( )
and unplug
1
CLEANING AUTO-START INFRARED SENSORS
PAPER JAM
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
Paper detection sensors are designed for maintenance free operation. However, on rare
occasions the sensors may become blocked by paper dust causing the motor to run even if
there is no paper present (Note: two paper detection sensors are located in the center of the paper entry).
Turn off and unplug
shredder
Locate Auto-start
infared sensor
Clean any contamination
from the paper sensors
12 3 4
Use thin, long-handled
brush to clean sensors.
Make sure brush is clean
and dry
TO CLEAN THE SENSORS
TROUBLESHOOTING
TO SHRED
SilentShred™ Technology
SilentShred™ noise quality
shreds without noisy disruptions.
Paper Capacity Indicator: When flashing blue, too much paper is inserted. Shredder will
automatically stop and reverse paper. See Paper Jam section.
Bin Full Indicator: When illuminated, the shredder waste bin is full and needs to be emptied.
Use Fellowes waste bag 36054.
Safety Shield Indicator: When flashing alternatively with On/Off LED, safety shield is
open and shredding will stop. To resume shredding, make sure safety shield is closed.
Door Open Indicator: When flashing alternatively with On/Off LED, the door is open.
To resume shredding, make sure door is closed.
Overheat Indicator: When flashing alternatively with On/Off LED, shredder requires
a 10-15 minute cool down period. When is blue, resume shredding.
R
When flashing blue,
too much paper is
inserted. Shredder
will automatically stop
and reverse paper
24
Gently pull uncut paper
from paper entry
1
Shred 1 sheet of
paper to clear
cutters. Resume
normal shredding
R
3
If necessary, press
Reverse (R) to run
shredder in reverse
and then pull uncut
paper from shredder
Safety Shield
Electronically controlled shield stops
shredder when opened for advanced safety
Auto Shut Off
After 30 minutes of inactivity, shredder
automatically turns off for zero energy
consumption
*Only use a non-aerosol vegetable oil in long nozzle
container such as Fellowes 35250
30

Produktspezifikationen

Marke: Fellowes
Kategorie: Aktenvernichter
Modell: Fortishred 2250C

Brauchst du Hilfe?

Wenn Sie Hilfe mit Fellowes Fortishred 2250C benĂśtigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Aktenvernichter Fellowes

Fellowes

Fellowes Powershred 79Ci Bedienungsanleitung

16 Oktober 2024
Fellowes

Fellowes Powershred C-525 Bedienungsanleitung

8 Oktober 2024
Fellowes

Fellowes Powershred 225i Bedienungsanleitung

5 Oktober 2024
Fellowes

Fellowes MicroShred MS-450Cs Bedienungsanleitung

29 September 2024
Fellowes

Fellowes P-35C Powershred Bedienungsanleitung

24 September 2024
Fellowes

Fellowes Powershred 1200C Bedienungsanleitung

22 September 2024
Fellowes

Fellowes DS-12CS Bedienungsanleitung

17 September 2024
Fellowes

Fellowes Intellishred PS-79Ci Bedienungsanleitung

15 September 2024
Fellowes

Fellowes Powershred HS-1010 Bedienungsanleitung

13 September 2024
Fellowes

Fellowes C-480 Bedienungsanleitung

6 September 2024

Bedienungsanleitung Aktenvernichter

Neueste Bedienungsanleitung fĂźr -Kategorien-

IDEAL

IDEAL 2601 Bedienungsanleitung

15 Oktober 2024
Hama

Hama CCD 1018L Bedienungsanleitung

14 Oktober 2024
SEM

SEM 1324C/3 Bedienungsanleitung

13 Oktober 2024
Insignia

Insignia NS-PS10CC Bedienungsanleitung

13 Oktober 2024
Tracer

Tracer TRX-503 Bedienungsanleitung

13 Oktober 2024
Tracer

Tracer TRX-119 Bedienungsanleitung

11 Oktober 2024
Rexel

Rexel V20 Bedienungsanleitung

11 Oktober 2024
Hama

Hama CC 614L Bedienungsanleitung

6 Oktober 2024
Eliet

Eliet Minor Bedienungsanleitung

19 September 2024
Atika

Atika AMF2500W Bedienungsanleitung

19 September 2024