Euromaid WM55 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Euromaid WM55 (16 Seiten) in der Kategorie Waschmaschine. Dieser Bedienungsanleitung war für 3 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/16
MODEL
WM55
5.5kg
Front Loader
Washing Machine
Manual
Installation and Operation
2 - EN
1 Warnings
General Safety
• Never place your machine on a carpet
covered floor. Otherwise, lack of airflow
from below of your machine may cause
electrical parts to overheat. This may cause
problems with your washing machine.
• If the power cable or mains plug is
damaged you must call Authorized Service
for repair.
• Fit the drain hose into the discharge
housing securely to prevent any water
leakage and to allow machine to take in
and discharge water as required. It is very
important that the water intake and drain
hoses are not folded, squeezed, or broken
when the appliance is pushed into place
after it is installed or cleaned.
• Your washing machine is designed to
continue operating when the power
restores after a power interruption. The
machine will resume its program when the
power restores. Press the “Start/Pause/
Cancel” button for 3 seconds to cancel the
program (See, Canceling a Program)
• There may be some water in your machine
when you receive it. This is from the quality
control process and is normal. It is not
harmful to your machine.
• Some problems you may encounter may
be caused by the infrastructure. Press
“Start/Pause/Cancel” button for 3 seconds
to cancel the program set in your machine
before calling the authorized service.
First Use
• Carry out your first washing process
without loading your machine and with
detergent under “Cottons 90°C” program.
• Ensure that the cold and hot water
connections are made correctly when
installing your machine.
• If the current fuse or circuit breaker is less
than 16 Amperes, please have a qualied
electrician install a 16 Ampere fuse or
circuit breaker.
• While using with or without a transformer,
do not neglect to have the grounding
installation laid by a qualied electrician.
Our company shall not be liable for any
damages that may arise when the machine
is used on a line without grounding.
• Keep the packaging materials out of reach
of children or dispose them by classifying
according to waste directives.
Intended use
• This product has been designed for home
use.
• The appliance may only be used for
washing and rinsing of textiles that are
marked accordingly.
Safety instructions
• This appliance must be connected to
an earthed outlet protected by a fuse of
suitable capacity.
• The supply and draining hoses must
always be securely fastened and remain in
an undamaged state.
• Fit the draining hose to a washbasin or
bathtub securely before starting up your
machine. There may be a risk of being
scalded due to high washing temperatures!
• Never open the loading door or remove the
lter while there is still water in the drum.
• Unplug the machine when it is not in use.
• Never wash down the appliance with a
water hose! There is the risk of electric
shock!
• Never touch the plug with wet hands. Do
not operate the machine if the power cord
or plug is damaged.
• For malfunctions that cannot be solved by
information in the operating manual:
• Turn off the machine, unplug it, turn off
the water tap and contact an authorized
service agent. You may refer to your local
agent or solid waste collection center in
your municipality to learn how to dispose of
your machine.
If there are children in your
house...
• Keep children away from the machine
when it is operating. Do not let them
tamper with the machine.
• Close the loading door when you leave the
area where the machine is located.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,or lack
of experience and knowledge,unless they
have been given supervises or instruction
concerning use of the appliance by a person
responsible for their safety.
3 - EN
2 Installation
Removing packaging
reinforcement
Tilt the machine to remove the packaging
reinforcement. Remove the packaging
reinforcement by pulling the ribbon.
Opening the transportation locks
Transportation safety bolts must be
removed before operating the washing
machine! Otherwise, the machine will be
damaged!
1. Loosen all the bolts with a spanner until
they rotate freely (“C”)
2. Remove transportation safety bolts by
turning them gently.
3. Fit the covers (supplied in the bag with the
Operation Manual) into the holes on the
rear panel. (“P”)
Keep the transportation safety bolts in
a safe place to reuse when the washing
machine needs to be moved again in the
future.
Never move the appliance without the
transportation safety bolts properly xed in
place!
Adjusting the feet
Do not use any tools to loosen the lock
nuts. Otherwise, they can be damaged.
1. Manually (by hand) loosen the lock nuts on
the feet.
2. Adjust them until the machine stands level
and rmly.
3. Important: Tighten all lock nuts up again.
Connecting to the water supply.
Important:
• The water supply pressure required to run
the machine must be 1-10 bar (0,1 – 1
MPa).
• Connect the special hoses supplied with
the machine to the water intake valves on
the machine.
• If you are going to use your double water-
inlet machine as a single (cold) water-inlet
unit, you must install the stopper*, supplied
with your machine to the hot water valve.
• If you want to use both water inlets of the
product, you can connect the hot water
hose after removing the stopper and
gasket group from the hot water valve.
* Applies for the products supplied with a blind
stopper group.
• Models with a single water inlet should not
be connected to the hot water tap.
When returning the appliance to its place after
maintenance or cleaning, care should be taken
not to fold, squeeze or block the hoses.
Connecting to the drain
The water discharge hose can be attached to
the edge of a washbasin or bathtub. The drain
hose should be rmly tted into the drain as to
not get out of its housing.
Important:
• The end of the drain hose must be directly
connected to the wastewater drain or to
the washbasin.
• The hose should be attached to a height of
at least 60 cm, and 90 cm at most.
• In case the hose is elevated after laying it
on the floor level or close to the ground
(less than 40 cm above the ground), water
discharge becomes more difcult and the
laundry may come out wet.
• The hose should be pushed into the
drainage for more than 15 cm. If it is too
long you may have it shortened.
• The maximum length of the combined
hoses must not be longer than 3.2 m.
90
60


Produktspezifikationen

Marke: Euromaid
Kategorie: Waschmaschine
Modell: WM55

Brauchst du Hilfe?

Wenn Sie Hilfe mit Euromaid WM55 benĂśtigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Waschmaschine Euromaid

Bedienungsanleitung Waschmaschine

Neueste Bedienungsanleitung fĂźr -Kategorien-