Elektrobock PT 712 Bedienungsanleitung
Elektrobock
Thermostaat
PT 712
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Elektrobock PT 712 (8 Seiten) in der Kategorie Thermostaat. Dieser Bedienungsanleitung war für 8 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/8
MADE IN CZECH REPUBLIC
•including external sensor
•backup in case of voltage failure > 100 hours
•direct installation on junction box
•well-arranged backlit display
VENUS switch design
N L COM NO N L COM NO
L'
2
DESCRIPTION
PT712-EI is a digital thermostat with a room and fl oor sensor, specially designed for electric fl oor heating
control. The internal-external sensor combination enables the regulation of:
1) fl oor temperature (external sensor) - suitable, for instance, for bathrooms where a warm fl oor is
desirable, irrespective of the room temperature;
2) room temperature (internal sensor) - when comfortable room temperature is required;
3) combined (both sensors) - the internal sensor scans the room temperature, while the
external one monitors the maximum fl oor temperature;
comfortable room temperature is required, however, with
simultaneous monitoring of the fl oor temperat (suitable for wooden
and laminated fl oors).
Another advantage is simple installation in the KU/KP68 junction boxes by means of the PLUG-IN
system, as well as the possibility of setting 2 weekly programs with 6 temperature changes per day.
INSTALLATION AND LOCATION
Install the thermostat in a suitable place (minimum height of 1.2-1.5 m above the fl oor) where its operation
will not be affected by direct hot/cold air fl ow, sunshine or other disturbing infl uences. Do not mount the
thermostat on an exterior wall either. In rooms with increased humidity (bathroom, kitchen), observe valid
standards and install the thermostat as far from the bathtub, shower, basin or sink as possible.
The external fl oor sensor (type CT04-10k, CYXY 2 x 0.5 mm, 10 k:, lenght 3 m, PVC plastic case)
must be located in a fl exible plastic tube embedded in the fl oor, as near to the surface as possible. The
tube must be sealed and protected against in-leak of building materials so that the fl oor sensor can be
replaced easily, if need be. It must not run parallel with power conductors! It can be extended to
a maximum length of 30 metres. The installation can only be done by a properly qualifi ed person!
Disconnect power supply before installation!
1) Switch off the main circuit breaker.
2) Check that the junction box is placed parallel with the wall.
3) Separate the power part of the thermostat from its microprocessor (main) part; see Fig. 1.
4) Pull the connecting terminals out of the thermostat rear part, see Fig. 2.
5) Connect conductors to the terminals acc. to the wiring diagram below, see Fig. 3.
6) Insert the terminals into the thermostat terminals and fasten the power part to the junction
box, see Fig. 4 and 5.
7) Insert the main part connector into the power part and push it; the metal springs must
fi t in the given holes, see Fig. 6 and 7.
8) Switch on the main circuit breaker; the thermostat is ready for operation. LCD backlight becomes active only
after charging the backup battery (up to 24 hours).
9) Set the constant 4 (page 6) according to the load, this could cause an inaccurate display of the current
temperature.
Note: We recommend you test correct connection after installation, see the TEST function (page 7).
Wiring diagram: Fig. 1
When using the low tariff
L‘ = disconnected phase
power part main part
PULLPULL
connecting
terminals
HEATING
HEATING
NTC 10k NTC 10k
* P= max. 2760 W
MENU
3
DESCRIPTION OF LCD AND CONTROL BUTTONS
1, Current date (in the Prog mode, selection of number of days for
programming)
2, Operating modes: OFF/PROG/AUTO/MANU/case=HOLIDAY
3, Current room temperature
4, Indication of room temp. measurement by the exter. sensor.
5, Heating on indication
6, Button lock indication
7, CLOC mode indication (current date and time setting)
8, Required temperature and current time display / listing of operating
modes (this line is explained in detail with every mode)
9, Battery supply indication (in case of 230V/50Hz voltage failure,
it is functional only after 1 day of operation, when the backup
battery is charged!)
10, Indication of setting the external sensor as the fl oor one
11, Anti-freeze temperature of 3 °C
MENU button:
short press = opens the main menu and
confi rmation (ENTER)
long press (approx. 3 sec.) = back from the
main menu
/ button:
basic mode = opens info
main menu =browse and set current values
simultaneous press of the MENU and
buttons (in basic mode) = key lock
simultaneous press of the MENU and
buttons (in basic mode) = key unlock
simultaneous press of the MENU and /
buttons (in main menu) = return to basic mode
Note: The LCD backlight is activated by pres-
sing any button!
Fig. 2 Fig. 3 Fig. 4
Fig. 5 Fig. 6 Fig. 7
NL
NO COM
PULL out the connecting terminals. Connect according to the wiring diagram.
PUSH the connecting
terminals in.
Screw the power part to
the junction box.
Connector and holes
for metal springs.
PUSH the
main part
onto the
power part.
9
Produktspezifikationen
Marke: | Elektrobock |
Kategorie: | Thermostaat |
Modell: | PT 712 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Elektrobock PT 712 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Thermostaat Elektrobock
1 September 2024
26 August 2024
26 August 2024
17 August 2024
12 August 2024
6 August 2024
1 August 2024
1 August 2024
30 Juli 2024
25 Juli 2024
Bedienungsanleitung Thermostaat
- Thermostaat Basetech
- Thermostaat SilverCrest
- Thermostaat Cotech
- Thermostaat Bosch
- Thermostaat AEG
- Thermostaat Siemens
- Thermostaat ATAG
- Thermostaat EMOS
- Thermostaat Gira
- Thermostaat HomeMatic
- Thermostaat Renkforce
- Thermostaat Schneider
- Thermostaat GE
- Thermostaat King
- Thermostaat Avidsen
- Thermostaat Elro
- Thermostaat Tesla
- Thermostaat Max
- Thermostaat Vaillant
- Thermostaat Honeywell
- Thermostaat Remko
- Thermostaat Junkers
- Thermostaat De Dietrich
- Thermostaat Netatmo
- Thermostaat Theben
- Thermostaat Tado
- Thermostaat Remeha
- Thermostaat Saunier Duval
- Thermostaat Truma
- Thermostaat Viessmann
- Thermostaat Xavax
- Thermostaat Hager
- Thermostaat Dimplex
- Thermostaat Buderus
- Thermostaat JUNG
- Thermostaat Hunter
- Thermostaat Wolf
- Thermostaat Nest
- Thermostaat Magnum
- Thermostaat HQ
- Thermostaat Itho Daalderop
- Thermostaat Carrier
- Thermostaat Tylö
- Thermostaat Busch-Jaeger
- Thermostaat Sygonix
- Thermostaat Orbis
- Thermostaat Econo-heat
- Thermostaat EQ-3
- Thermostaat Eberle
- Thermostaat Bulex
- Thermostaat Danfoss
- Thermostaat Delta Dore
- Thermostaat Fantini Cosmi
- Thermostaat Grässlin
- Thermostaat Oventrop
- Thermostaat Salus
- Thermostaat Seitron
- Thermostaat Mikoterm
- Thermostaat Ferroli
- Thermostaat Daikin
- Thermostaat Vemer
- Thermostaat EnerGenie
- Thermostaat Oregon Scientific
- Thermostaat Finder
- Thermostaat Homematic IP
- Thermostaat EQ3
- Thermostaat Elgato
- Thermostaat Elco
- Thermostaat Drayton
- Thermostaat Drayton Erie
- Thermostaat EasyTemp
- Thermostaat Eliwell
- Thermostaat Emerson
- Thermostaat Emmeti
- Thermostaat Enda
- Thermostaat Eneco
- Thermostaat Eqiva
- Thermostaat Essent
- Thermostaat Eurotronic
- Thermostaat Extraflame
- Thermostaat Frico
- Thermostaat Helios (Amfra)
- Thermostaat Hornbach
- Thermostaat Hugo Muller
- Thermostaat ICY
- Thermostaat IR-V
- Thermostaat Itho
- Thermostaat Johnson Control
- Thermostaat Niko
- Thermostaat Nobo
- Thermostaat Otio
- Thermostaat Plieger
- Thermostaat Plugwise
- Thermostaat Radson
- Thermostaat THERMAFLEX
- Thermostaat Thermy
- Thermostaat Hive
- Thermostaat UPM
- Thermostaat VDH
- Thermostaat Watts
- Thermostaat Worcester-Bosch
- Thermostaat Heatit
- Thermostaat POER
- Thermostaat H-Tronic
- Thermostaat PECO
- Thermostaat Emko
- Thermostaat Fibaro
- Thermostaat Heatmiser
- Thermostaat Crestron
- Thermostaat ORNO
- Thermostaat Optima
- Thermostaat HomePilot
- Thermostaat Ouellet
- Thermostaat Maico
- Thermostaat Tellur
- Thermostaat STI
- Thermostaat Tru Components
- Thermostaat Qubino
- Thermostaat Amfra
- Thermostaat Aube
- Thermostaat AWB
- Thermostaat Wattio
- Thermostaat Brink
- Thermostaat 2Heat
- Thermostaat Bryant
- Thermostaat Veria
- Thermostaat Innogy
- Thermostaat ELKO
- Thermostaat MundoControl
- Thermostaat Bearware
- Thermostaat GENERAL Life
Neueste Bedienungsanleitung für -Kategorien-
16 September 2024
16 September 2024
16 September 2024
16 September 2024
16 September 2024
16 September 2024
15 September 2024
13 September 2024
13 September 2024
13 September 2024