Electrolux EFT9516X Bedienungsanleitung

Electrolux Dunstabzugshaube EFT9516X

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Electrolux EFT9516X (11 Seiten) in der Kategorie Dunstabzugshaube. Dieser Bedienungsanleitung war für 15 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/11
USER MANUAL : COOKER HOOD
EFT7516K
EFT7516X
EFT9516K
EFT9516X
Description................................................1
Installation ................................................1
Installation Ducting Version ... ....................1
Installation Filtering Version .. ....................2
Operation ................................................. 3
Warning ....................................................3
Wiring Diagram .........................................4
Diagram ....................................................4
Warranty Condition ...................................8
CONTENTS
DESCRIPTION
The hood may be installed in the filtering or the ducting version.
Ducting version (Fig.1): The hood aspirates the kitchen air saturated with fumes and odour,
passes it through the grease filters and expels it to the outside through an outlet pipe. With
this version the charcoal filters are not required.
Decide from the outset on the type of installation (filtering or ducting). For greater efficiency,
we recommend you install the hood in the ducting version (if possible).
Filtering version (Fig.2): The hood aspirates the kitchen air saturated with fumes and odour.
Purifies it through the grease filters and charcoal filters and returns clean air into the room.
For constant efficiency, the charcoal filters must be replaced periodically.
INSTALLATION
-Before beginning installation, to better handle the hood, we advise removing the grease
filters.
-To remove the grease filter/s (Fig.3), in line with the handle, push the stop inwards and pull the
filter down.
INSTALLATION IN DUCTING VERSION:
-Before fixing, the outlet pipe for air evacuation to the outside must be installed. Use an outlet
pope with: - minimum indispensable length; -Minimum possible bends (maximum angle of
bend:90°); -certified material (according to the state); _ an as smooth as possible inside. It is
also advisable to avoid any drastic changes in pipe cross-section (recommended diameter:
155mm).
-Decide on the position of the hole for the air outlet: The hole may be in the wall or the ceiling,
according to your requirements, but must be in vertical line with your hood. Bear in mind that
the hood just expel air through the top opening A (Fig.4).
-Mounting the air outlet adapter to the top opening A by securing two screws. Bear in mind that
the opening B(Fig.4) must be closed by two ventilation cover with 4 screws(Fig.5) then insert
the nameplate into the ventilation covers(Fig.6).
-Drill the hole in the wall for the air outlet (163 mm diameter) referring to Fig.7 where the
measurements for the various possibilities are indicated.
-Prepare a suitable power supply. For the electrical connection, follow all the other instructions
on the other instructions on the page 3.
-Proceed with fixing the hood: Based on your requirements, you can fit the hood on the wall or
on a wall unit of your kitchen. IMPORTANT: Respect the distance between the hob and lower
part of the hood which must be at least 650 cm.
-Fixing to the wall:
Before fixing the hood to the wall, mount two mounting brackets to the hood
from two side with 4 screws provided(Fig.8) and drill a hole of 163mm diameter in the wall unit
(Fig.7). In any case, check the position of the power outlet and consider where the power
cable will run, since a hole might have to be made in the wall unit to accommodate it. Draw a
line on the wall in vertical line with your hob. Mark the2 holes to be drilled in the wall,
respecting the distances indicated in Fig. 7; Make the 2 holes and fit the 2 screw anchors
provided then without screwing that 2 of screws down completely. Hang the hood on the 2
screws; tighten the 2 screws completely. Now proceed with connecting a flexible tube to the
hood outlet adapter tight well by mounting 2 screws. Tube is not provided. Make the electrical
connection.
Page1

Produktspezifikationen

Marke: Electrolux
Kategorie: Dunstabzugshaube
Modell: EFT9516X

Brauchst du Hilfe?

Wenn Sie Hilfe mit Electrolux EFT9516X benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Dunstabzugshaube Electrolux

Electrolux

Electrolux EFP6500XA Bedienungsanleitung

6 September 2024
Electrolux

Electrolux DMSL8335UO Bedienungsanleitung

3 September 2024
Electrolux

Electrolux DMSL8330AO Bedienungsanleitung

3 September 2024
Electrolux

Electrolux LFT416K Bedienungsanleitung

3 September 2024
Electrolux

Electrolux LFE116W Bedienungsanleitung

2 September 2024
Electrolux

Electrolux AFF9671MK Bedienungsanleitung

31 August 2024
Electrolux

Electrolux EFG50300W Bedienungsanleitung

23 August 2024
Electrolux

Electrolux EFC60151W Bedienungsanleitung

23 August 2024
Electrolux

Electrolux EFC90990X Bedienungsanleitung

23 August 2024
Electrolux

Electrolux EFP60520G Bedienungsanleitung

23 August 2024

Bedienungsanleitung Dunstabzugshaube

Neueste Bedienungsanleitung für -Kategorien-

Pelgrim

Pelgrim ISW990 Bedienungsanleitung

16 Oktober 2024
Amana

Amana UVL6048JSS Bedienungsanleitung

16 Oktober 2024
Maytag

Maytag UVL6048JSS Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia CHS46GTW Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia CHS46GW Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia CHS46GB Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia CHS46B Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia CHS45X Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia CHS45W Bedienungsanleitung

16 Oktober 2024
Freggia

Freggia CHS45B Bedienungsanleitung

16 Oktober 2024