Electro Harmonix Ripped Speaker Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Electro Harmonix Ripped Speaker (5 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war fĂĽr 4 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/5
RIPPED SPEAKER
FUZZ PEDAL
Congratulations your purchase the Ripped Speaker, entirely analog on of an
emulator the earliest type guitar distortion! At fuzz settings, Ripped of of low The
Speaker capable reproducing a pristine, slightly cracked tone similar a is of to
maxed out, low watt amplifier in a 1950s blues club. With the fuzz knob dialed up,
the pedal attains a searing, fully saturated tone which can tear that same room in
half. Finally, adjusting the RIP knob, the Ripped Speaker can travel from full by
harmonic expressiveness a sputtering gate for shrunken, choked tones a to in
more modern character. Ripped Speaker features true bypass. The
TRIVIA: The story intentionally damaging amplifiers achieve desirable new of to
tones originates from accident which occurred the early 1950s an in to
guitarist/singer, Ike Turner. While unloading gear before a show, band Turner’s
dropped one their amps from the tour-van the sidewalk doing so, of on to and in
perforated the speaker. They realize what occurred until plugging didn’t had in to
play, but ultimately Turner decided he liked the sound, so the amp was later used
in recording sessions.
C ONTROLS
FUZZ Knob Controls the amount input gain that goes into the fuzz circuit. —of
Turn FUZZ clockwise from light heavy fuzz. to go to
RIP Knob RIP knob a bias control that ies the amount clipping —The is var of at
either the top bottom the signal waveform. least compressed and open or of The
sound with RIP noon. As you turn RIP either direction from noon, the is set to in
character the altered: becoming choked gated, creating interesting of fuzz is or
textures sputtering effects. and
TONE Knob — Controls active tilt-shift type further shape your an EQ to fuzz
tone. Set TONE noon the flat. As you turn TONE counterclockwise, to and EQ is
the frequency response darker with more pronounced less highs. gets lows and
Clockwise yields a brighter tone with more highs rolled back . and lows
VOL Knob Adjusts the output volume the Ripped Speaker. —of
FOOTSWITCH LEDand footswitch toggles the Ripped Speaker between —The
effect true bypass mode. LED lights when the effect engaged. and The is
C & P ONNECTIONS OWER
INPUT Jack This jack the input the Ripped Speaker. Plug your — 1/4” is to
instrument into here. input impedance . The is 1MΩ
AMP Jack This jack the Ripped output. Connect this the — 1/4” is Speaker’s to
input your next effect amplifier. Output impedance . of or is 100Ω
PWR Jack — The Ripped Speaker can be powered by a 9V battery or you can use
an optional 9VDC AC Adapter capable of delivering least the power at 25mA to 9V
jack, such the EHX9.6DC- AC Adapter must have a center negative as 200. The
plug. battery may left taken out when using AC Adapter. The be in or an The
Ripped Speaker current draw 9VDC. ’s is 10mA at
Please Note: Using the wrong adapter a plug with the wrong polarity or
may damage your Ripped Speaker void the warranty. and
CHANGING THE BATTERY
To change the 9V battery, you must remove the 4 screws the bottom the on of
Ripped Speaker. Once the screws are removed, you can take off the bottom plate
and change the battery. Please not touch the circuit board while the bottom do
plate off, you risk damaging a component. is or
N & S OTES PECIFICATIONS
• Audio input impedance at INPUT jack: 1MΩ
• Audio output impedance at AMP jack: 1 00Ω
• Current draw mA at 9.0VDC : 10
• Bypass type True :
C OMPLIANCE
The logo indicates that this product has been tested and shown conform CE to
with all applicable European Conformity directives.
The WEEE logo indicates that this product made electronic or “trashcan” is up of
components that should trashed alongside household waste but instead not be
should recycled a proper electrical waste facility. be by


Produktspezifikationen

Marke: Electro Harmonix
Kategorie: Nicht kategorisiert
Modell: Ripped Speaker

Brauchst du Hilfe?

Wenn Sie Hilfe mit Electro Harmonix Ripped Speaker benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Electro Harmonix

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂĽr -Kategorien-