ECS GF6100PM-M2 V3.0 Bedienungsanleitung

ECS Hauptplatine GF6100PM-M2 V3.0

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für ECS GF6100PM-M2 V3.0 (64 Seiten) in der Kategorie Hauptplatine. Dieser Bedienungsanleitung war für 24 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/64

Preface

This publication, including all photographs, illustrations and software, is protected

any of the material contained herein, may be reproduced without written consent of

the author.

Version 3.0

Disclaimer

The information in this document is subject to change without notice. The manufac-

turer makes no representations or warranties with respect to the contents hereof and

specifically disclaims any implied warranties of merchantability or fitness for any

particular purpose. The manufacturer reserves the right to revise this publication and

to make changes from time to time in the content hereof without obligation of the

manufacturer to notify any person of such revision or changes.

Federal Communications Commission (FCC)

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installa-

tion. This equipment generates, uses, and can radiate radio frequency energy and, if

not installed and used in accordance with the instructions, may cause harmful inter-

ference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one

or more of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and the receiver

• Connect the equipment onto an outlet on a circuit different from that to

which the receiver is connected

• Consult the dealer or an experienced radio/TV technician for help

Shielded interconnect cables and a shielded AC power cable must be employed with

this equipment to ensure compliance with the pertinent RF emission limits governing

this device. Changes or modifications not expressly approved by the system’s manu-

facturer could void the user’s authority to operate the equipment.

Trademark Recognition

Microsoft, MS-DOS and Windows are registered trademarks of Microsoft Corp.

nVIDIA is a registered trademark of nVIDIA Corporation

Other product names used in this manual are the properties of their respective owners

and are acknowledged.

Preface

Declaration of Conformity

This device complies with part 15 of the FCC rules. Operation is subject to the

following conditions:

• This device may not cause harmful interference, and

• This device must accept any interference received, including interfer-

ence that may cause undesired operation

Canadian Department of Communications

This class B digital apparatus meets all requirements of the Canadian Interference-

causing Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Réglement sur

le matériel brouilieur du Canada.

About the Manual

The manual consists of the following:

Chapter 1

Introducing the Motherboard

Chapter 2

Installing the Motherboard

Chapter 3

Using BIOS

Chapter 4

Using the Motherboard Software

Describes features of the

motherboard.

Go to Hpage 1

Describes installation of

motherboard components.

Go to Hpage 7

Provides information on us-

ing the BIOS Setup Utility.

Go to Hpage 27

Describes the motherboard

software

Go to Hpage 45

Chapter 5

Setting Up NVIDIA RAID Configuration

Provides information about

SATA RAID Setup

Go to Hpage 51

iii

TABLE OF CONTENTSABLE OF CONTENTS

ABLE OF CONTENTSABLE OF CONTENTS

ABLE OF CONTENTS

Preface i

Chapter 1

Introducing the Motherboard 1

Introduction......................................................................................1

Feature...............................................................................................2

Motherboard Components.............................................................4

Chapter 2 7 7

7 7

Installing the Motherboard 7

Safety Precautions...........................................................................7

Choosing a Computer Case............................................................7

Installing the Motherboard in a Case............................................7

Checking Jumper Settings...............................................................8

Setting Jumpers...................................................................8

Checking Jumper Settings...................................................9

Jumper Settings...................................................................9

Installing Hardware........................................................................10

Installing the Processor.....................................................10

Installing Memory Modules...............................................12

Expansion Slots..................................................................15

Connecting Optional Devices.............................................17

Installing a Hard Disk Drive/CD-ROM/SATA Hard Drive...20

Installing a Floppy Diskette Drive.....................................21

Connecting I/O Devices................................................................22

Connecting Case Components.....................................................23

Front Panel Header...........................................................25

Chapter 3 27

Using BIOS 27

About the Setup Utility................................................................ 27

The Standard Conﬁguration..............................................27

Entering the Setup Utility...................................................27

Resetting the Default CMOS Values...................................28

Using BIOS......................................................................................29

Standard CMOS Setup......................................................30

Advanced Setup.................................................................33

Advanced Chipset Setup....................................................35

Produktspezifikationen

Marke:	ECS
Kategorie:	Hauptplatine
Modell:	GF6100PM-M2 V3.0
Prozessorhersteller:	AMD
Breite:	244 mm
Tiefe:	214 mm
Energiequelle:	ATX
Kopfhörerausgänge:	1
Anzahl USB 2.0 Anschlüsse:	4
Anzahl Ethernet-LAN-Anschlüsse (RJ-45):	1
Audio Kanäle:	6.1 Kanäle
Mikrofon-Eingang:	Ja
RAID Level:	0, 1,0+1, 5
Prozessorsockel:	Socket AM3
Anzahl VGA (D-Sub) Anschlüsse:	1
Kompatible Prozessoren:	AMD Sempron
Motherboardformfaktor:	micro ATX
Audio-Chip:	Realtek ALC662
Anzahl der Speichersteckplätze:	2
Unterstützte Arbeitsspeichergeschwindigkeit:	400,533,667,800 MHz
RAM-Speicher maximal:	16 GB
Maximaler Grafikkartenspeicher:	256 MB
Parallele Verarbeitungstechnologie:	Nicht unterstützt
Anzahl PS/2 Anschlüsse:	2
ATX Stromstecker (24-pol.):	Ja
Anzahl USB 2.0 Schnittstellen:	3
CPU Ventilatorstecker:	Ja
Front Panel Audiostecker:	Ja
BIOS-Speichergröße:	64 Mbit
BIOS-Typ:	AMI
ACPI-Version:	1.0
Anzahl serielle Anschlüsse:	1
Eingebaute Grafikadapter:	Ja
Power Fan Connector:	Ja
PCI-Express x16-Slots:	1
PCI-Express x1-Slots:	1
PCI-Slots:	2
Anzahl Parallelanschlüsse:	1
Netzwerkfunktionen:	Schnelles Ethernet
S/PDIF aus Stecker:	Ja
SATA Anschlüsse:	4
CD/AUX Audio-Eingang:	Ja