Digital Watchdog DWC-MC355T Bedienungsanleitung

Digital Watchdog Überwachungskamera DWC-MC355T

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Digital Watchdog DWC-MC355T (3 Seiten) in der Kategorie Überwachungskamera. Dieser Bedienungsanleitung war für 7 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/3
■
■
■
■■ CONNECTIONS
■
■
■
■■ DIMENSIONS
INSTRUCTION MANUAL
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for later reference.
■Do not open or modify
Do not open the cabinet exit during maintenance and
installation, as it may be dangerous and cause damages.
■Do not put objects inside the unit
Make sure that no metal objects or flammable substances get inside
the camera. It could cause fire, short-circuits or damages.
■Be careful when handling the unit
To prevent damage, do not drop the camera or subject
it to strong shock or vibration.
■Install away from electric or magnetic fields
■Protect from humidity and dust
■Protect from high temperature
Be careful when installing close to the ceiling , in a kitchen or boiler
room, as the temperature may raise to high levels.
■Cleaning
Dirt can be removed from the cabinet only by wiping it
with a soft cloth moistened with a soft detergent solution.
■Mounting Surface
The mounting surface material must be strong enough to secure the
camera.
INSTALLATION
CONNECTIONS
WARRANTY INFORMATION
Digital Watchdog
(referred to as
“
the Warrantor
”
) warrants the
This warranty gives you specific legal rights and you may also have
other rights that vary from state to state.
If the problem is not handled to your satisfaction, then write to the
PRECAUTIONS
MC355T
About this manual
12VDC
CAUTION :
Check for polarity when using a DC 12V.
5436 W Crenshaw Street
Tampa, FL 33634
www.digital-watchdog.com
Technical Support : 1-866-446-3595 / 813-888-9555
VIDEO OUT
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for later reference.
TROUBLESHOOTING
Before sending the camera out for repair, check the items below. If the
problem persists after checking these items, contact your service
center.
■
■
■
■■ If no image appears.
Is the coaxial cable attached securely?
Are the power and voltage normal?
Has the iris of the lens inside the camera been
adjusted correctly (with the level volume) ?
Is there adequate illumination?
■
■
■
■■ If the image is unclear
Is the lens in focus?
Is the lens dirty?
Dirt of fingerprints on the lens can adversely affect the
images. Gently wipe any dirt or fingerprints off the lens
with a soft cloth or lens cleaning paper and cleaning
fluid (commercially available).
Is the monitor adjusted correctly?
WARNING:
TO PREVENT THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
■Do not open or modify
Do not open the cabinet exit during maintenance and
installation, as it may be dangerous and cause damages.
■Do not put objects inside the unit
Make sure that no metal objects or flammable substances get inside
the camera. It could cause fire, short-circuits or damages.
■Be careful when handling the unit
To prevent damage, do not drop the camera or subject
it to strong shock or vibration.
■Install away from electric or magnetic fields
■Protect from humidity and dust
■Protect from high temperature
Be careful when installing close to the ceiling , in a kitchen or boiler
room, as the temperature may raise to high levels.
■Cleaning
Dirt can be removed from the cabinet only by wiping it
with a soft cloth moistened with a soft detergent solution.
■Mounting Surface
The mounting surface material must be strong enough to secure the
camera.
INSTALLATION
CONNECTIONS
WARRANTY INFORMATION
Digital Watchdog (referred to as “the Warrantor”) warrants the
Camera Series against defects in materials or workmanship as follows:
LABOR: For the initial five (5) years from the date of original purchase,
if the camera is determined to be defective, the Warrantor will repair or
replace the unit, with
new or refurbished product at its option, at no charge.
PARTS: In addition, the Warrantor will supply replacement parts for
the initial five (5) years. To obtain warranty or out of warranty service,
please contact a Technical Support Representative at 1-866-446-3595
Monday through Friday from 9:00 AM to 5:00 PM Eastern.
A purchase receipt or other proof of the date of the original purchase is
required before warranty service is rendered. This warranty only
covers failures due to defects in materials and workmanship which
arise during normal use. This warranty does not cover damage which
occurs in shipment or failures which are caused by products not
supplied by the Warrantor or failures which result from accident,
misuse, abuse, neglect, mishandling, misapplication, alteration,
modification, faulty installation, set-up adjustments, improper antenna,
inadequate signal pickup, maladjustment of consumer controls,
improper operation, power line surge, improper voltage supply,
lightning damage, rental use of the product or service by anyone other
than an authorized repair facility or damage that is attributable to acts
of God.
This warranty gives you specific legal rights and you may also have
other rights that vary from state to state.
If the problem is not handled to your satisfaction, then write to the
Address above.
Service calls which do not involve defective materials or workmanship
as determined by the Warrantor, in its sole discretion, are not covered.
Costs of such service calls are the responsibility of the purchaser.
LIMITS AND EXCLUSIONS
There are no express warranties except as listed above. The Warrantor
will not be liable for incidental or consequential damages (including,
without limitation, damage to recording media) resulting from the use of
these products, or arising out of any breach of the warranty. All express
and implied warranties, including the warranties of merchantability and
fitness for particular purpose, are limited to the applicable warranty
period set forth above.
Some states do not allow the exclusion or limitation of incidental or
consequential damages, or limitations on how long an implied warranty
lasts, so the above exclusions or limitations may not apply to you.
PRECAUTIONS
MC355T
About this manual
12VDC
CAUTION :
Check for polarity when using a DC 12V.
A. Removing the screw on the upper case by using
L-wrench.
B. Separate the upper case from the bottom case
C. Make the 4 mounting screw hole on the ceiling/wall by drawing
the positions using the bottom case
D. Put Power cable andVideocable intotheceiling/wall.
E. Align the bottom case to the ceiling/wall by using
the screws.
F. Adjust the camera to its position
(Referance - "CAMERA SETTING" )
G. Connect the upper case and bottom case.
H. Tighten the Stop Screw to the upper case using L-wrench.
5436 W Crenshaw Street
Tampa, FL 33634
www.digital-watchdog.com
Technical Support : 1-866-446-3595 / 813-888-9555
E
D
C
B
A
F
VIDEO OUT
■
■
■
■■ CAMERA SETTINGS ■
■
■
■■ LENS ADJUSTMENTS
CONNECTIONS AND CAMERA SETTINGS
Adjust the panning(360 ) position. ˚) and tilt(70˚
■
■
■
■■ CAMERA DIP SWITCH
CONNECTIONS AND CAMERA SETTINGS
Adjust the panning(360 ) position. ˚) and tilt(70˚
1 2 3 4
ON NTSC x x x
OFF PAL x x x
Model
Camera TYPE Color/BW - MC355T Micro-Vandal Day/Night PIXIM Dome Camera
Mount In-Ceiling ( mounting adaptor available- optional)
Image Device 1/3" PIXIM
Pixels-Total 742(H) x 552(V)
Pixels-Effective 720(H) x 540(V)
Scanning System 525 line, 2:1Interlace
Horizontal Frequency Internal Mode 15,734Hz
Vertical Frequency Internal Mode 59.94Hz
Min. Scene Illumination F1.2 0.08 Lux [TDN 0.01 Lux]
WDR WDR LEVEL -20 to 20
DIP Switch NTSC/PAL on/off
Lens Fixed Length 3.6mm
2.9mm(MC355T29)
Resolution Horizontal 480 TV Lines [at TDN (B/W) :520 TV Lines]
Video Output VBS 1.0Vp-p VBS 1.0Vp-p(75 Load)
S/N Ratio S/N Ratio 48dB
Environmental Conditions Operating Temperature -10 ~ +55 (14 ~ 131 )℃ ℃ ℉ ℉
Humidity Less than 90%
Power Power Requirement 12VDC
Power Consumption 12VDC: 130mA
Physical Specification Dimensions(W x H) 80.0 x 59.5mm
Nema Type IP66
Weight 255g
Certifications CE, FCC, RoHS Certified
Ultra WDR Camera MC355T (micro Dome)

Produktspezifikationen

Marke: Digital Watchdog
Kategorie: Überwachungskamera
Modell: DWC-MC355T

Brauchst du Hilfe?

Wenn Sie Hilfe mit Digital Watchdog DWC-MC355T benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Überwachungskamera Digital Watchdog

Digital Watchdog

Digital Watchdog MegaPix DWC-MVT4WiA Bedienungsanleitung

30 August 2024
Digital Watchdog

Digital Watchdog DW-VMAXD1 Bedienungsanleitung

30 August 2024
Digital Watchdog

Digital Watchdog MegaPix IVA+ DWC-MPV85WIATW Bedienungsanleitung

30 August 2024
Digital Watchdog

Digital Watchdog MegaPix CaaS DWC-MF4WI4C2 Bedienungsanleitung

30 August 2024
Digital Watchdog

Digital Watchdog Star-Light Flex DWC-VS753WT Bedienungsanleitung

30 August 2024
Digital Watchdog

Digital Watchdog VMAX AHD CORE DW-VAC42T Bedienungsanleitung

30 August 2024
Digital Watchdog

Digital Watchdog MegaPix CaaS DWC-MF4WI6C6 Bedienungsanleitung

30 August 2024
Digital Watchdog

Digital Watchdog MEGAPIX DWC-MV421TIRB Bedienungsanleitung

30 August 2024
Digital Watchdog

Digital Watchdog MegaPix DWC-MV72I4V Bedienungsanleitung

30 August 2024
Digital Watchdog

Digital Watchdog MegaPix CaaS DWC-MV84WIAC6 Bedienungsanleitung

30 August 2024

Bedienungsanleitung Überwachungskamera

Neueste Bedienungsanleitung für -Kategorien-

Trebs

Trebs CCD-401C Bedienungsanleitung

15 Oktober 2024
D-Link

D-Link DCS-7510 Bedienungsanleitung

15 Oktober 2024
Foscam

Foscam FI9900EP Bedienungsanleitung

14 Oktober 2024
Alecto

Alecto DVC-215IP Bedienungsanleitung

14 Oktober 2024
Hikvision

Hikvision DS-2CD2326G2-IU Bedienungsanleitung

13 Oktober 2024
Hikvision

Hikvision DS-2TD2166-15/V1 Bedienungsanleitung

13 Oktober 2024
Hikvision

Hikvision DS-2DE7A245IX-AE/S1 Bedienungsanleitung

13 Oktober 2024
Hikvision

Hikvision DS-2CD7A26G0-IZ(H)SY Bedienungsanleitung

11 Oktober 2024
Hikvision

Hikvision DS-2CE79DF8T-AZE Bedienungsanleitung

11 Oktober 2024
Hikvision

Hikvision DS-2XM6726G0-I(D)(S)(M)(/ND) Bedienungsanleitung

11 Oktober 2024