DeLonghi EC 9.1 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für DeLonghi EC 9.1 (4 Seiten) in der Kategorie Kaffeemaschine. Dieser Bedienungsanleitung war für 14 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
10
SAFETY WARNINGS
• Take care when using the appliance. Improper use
and jets of hot water or steam could cause scalding
or burns. Do not touch hot parts (water, discharge
area in contact with the filter holder (O) and filter
(P)).
• Never touch hot parts.
• After removing the packaging, check that the
appliance is intact and undamaged. If in doubt, do
not use the appliance and contact a professionally
qualified person.
Packaging elements (plastic bags, polystyrene
foam, etc.) must not be left within reach of children,
as they are potential sources of danger.
• This appliance must be used for household purpo-
ses only. Any other use is considered inappropria-
te and consequently dangerous.
• The manufacturer declines all liability for any
damage deriving from improper, erroneous and
unreasonable use of the appliance.
• Never touch the appliance with wet or damp hands
or feet.
• Never allow the appliance to be used without
supervision by children or incapable persons.
• Make sure that children do not play with the
appliance.
• In the event of failure or malfunction, switch off the
appliance and do not tamper with it in any way. If
the appliance requires repair, contact an authori-
sed technical service centre only and ask for origi-
nal spare parts to be used. Failure to respect the
above could reduce the safety of the appliance.
• The power cable of this appliance must never be
replaced by the user as it requires the use of spe-
cial tools. If the cable is damaged or requires
replacing, contact an authorised service centre
only to avoid all risks.
INSTALLATION
• Place the appliance on a work surface far away
from water taps and basins.
• Before use, make sure the mains voltage corre-
sponds to the voltage indicated on the appliance
rating plate.
Connect the appliance to an efficiently earthed
mains socket with a minimum rating of 10A only.
The manufacturer may not be considered liable
for possible incidents caused by the failure to
adequately earth the mains.
• If the plug fitted to the appliance does not match
the power socket, have the socket replaced with
ENGLISH
Read this manual thoroughly before installing
and using the appliance. Keep for future consul-
tation. This will ensure optimum performance
and safety.
DESCRIPTION
(See drawing on page. 3)
The following terminology and letters will be used
repeatedly on the following pages.
A. Selector for STRONG, MEDIUM, LIGHT and CAP-
PUCCINO coffee
B. Boiler cap
C. Milk tank cover
D. Emulsifier
E. Milk tank
F. Steam knob
G. Splash hood
H. Power cable
I. "Steam ready" indicator light
L. Luminous switch
M. Drip tray
N. Measure
O. Filter holder
P. Filter
Q. Jug with cover
R. Adapter for cups
one that is suitable by qualified personnel. If the
power cable (H) is damaged or requires repla-
cing, contact an authorised service centre only as
the operation requires special tools.
• Do not install the appliance in an atmosphere
where the temperature may drop to or below 0°C
(if the water freezes, the appliance may be dama-
ged).
PREPARING THE COFFEE
1 Unscrew the boiler cap (B) by rotating anti-
clockwise.
2 Using the jug (Q) provided (fig. 1), pour the water
into the boiler (fig. 2) respecting the quantities
given in the table at the end of the manual. Never
exceed the quantities indicated as this would lead
to poor functioning of the appliance. Always fill
the boiler with the luminous switch (L) off.
3. Place the filter in the filter holder (Fig.3).
4. Using the measure provided, pour the coffee into
the filter respecting the quantities indicated in the
table at the end of the manual and distributing it
evenly (fig.4). Use medium ground coffee as
excessively finely ground coffee could clog the fil-
ter (coffee for MOKA coffee makers can be used).
5. Remove any excess coffee from the edge of the fil-
ter (fig.5).
6. To attach the filter holder to the appliance, hold it
under the boiler outlet (fig. 6).
Push the filter holder upwards and at the same
time rotate it towards the right as far as it will go.
Make sure the filter holder is firmly in place, the
position of the filter holder handle with respect to
the appliance is irrelevant.
7 The jug must be positioned under the filter holder
in such a way that the spout of the filter holder is
inside the opening in the cover of the jug (fig.7).
8 Position the selector (A) to the type of coffee you
want to obtain: "LIGHT" for light coffee,
"MEDIUM" for normal coffee, "STRONG" for
strong coffee (fig.8).
9 Make sure the steam knob (F) is fully closed and
press the luminous switch. The indicator light
comes on (fig.9).
10 It takes about three minutes for coffee delivery to
begin. After the coffee has been delivered, turn
the luminous switch off.
IMPORTANT: To avoid discharge of steam, before
removing the filter holder, always vent all steam
left inside the boiler by rotating the steam knob
completely (fig. 10).
NOTE: For safety reasons, when the boiler is hot
the cap cannot be opened as it rotates without
unscrewing. If it must be removed for any reason,
always vent the steam from the boiler first using
the steam knob as described in the previous point.
To remove the coffee grounds from the filter hol-
der, turn it upside down and knock it repeatedly
until the grounds are eliminated (fig. 11). Alter-
natively, rinse the filter holder and filter under run-
ning water.
IMPORTANT: To eliminate the "new" smell, the first
time you use the appliance, perform the coffee-
making cycle a couple of times without coffee
grounds.
FITTING THE ADAPTER
To make coffee directly in the cup, the adapter (R)
must be used. To fit, simply insert it in the bottom part
of the filter holder (fig.12).
PREPARING CAPPUCCINO COFFEES
• Pour the quantity of milk required to make the
cappuccino coffees (about 100 cc for each cap-
puccino) into the milk tank (E) (fig. 13). Never
exceed the MAX level (corresponding to about
250 cc) marked on the tank (fig. 14) otherwise
milk may continue to drip from the milk tank tube
after frothing has been completed. Always use
fresh unboiled milk. Never use hot milk.
When preparing four cappuccino coffees, the
milk in the tank must be topped up.
• Prepare the coffee as described in the paragraph
"PREPARING THE COFFEE" from point 1 to point
8, but using more water as specified in the table
at the end of the manual.
• Turn the appliance on by pressing the luminous
switch. Run off the coffee into the jug. When the
coffee reaches either the 2 or 4 level indicated on
the jug, stop delivery of the coffee by placing the
coffee selector in the "CAPPUCCINO" position.
IMPORTANT: The 2 or 4 mark should correspond
not to the level of the light coloured cream, but
to the darker coloured coffee under the cream.
Great care must be taken during this operation.
If the level of coffee exceeds the 2 or 4 line, there
will not be sufficient steam to froth the milk.
•Pour the coffee into the cups.
• One at a time, place the cups containing the cof-
fee under the milk tank tube (fig. 15) and wait
11
until the steam ready light (I) comes on. When
using small cups, to avoid splashes of milk, fit
the splash hood (G) onto the milk tube (fig. 16).
• Rotate the steam knob anticlockwise to discharge
the frothed milk from the tube (fig. 15). For correct
frothing and to avoid splashes of milk, rotate the
knob at least one turn. Continue until half the milk
has been emptied from the tank, then shut off the
steam by rotating the knob clockwise.
• Repeat the operation for the number of cups
required until the milk tank is empty. IMPORTANT:
always wait until the "steam ready" light (I)
comes on.
• Immediately after preparing the cappuccino cof-
fees, pour a little water into the milk tank and
place the jug under the milk tank tube. Rotate the
steam knob and vent the steam completely (about
one minute).
IMPORTANT: Even when apparently unneces-
sary, it is essential to perform this operation
each time to empty the boiler completely of all
residual water or steam which might otherwise
compromise correct operation next time the
appliance is used. For hygiene reasons, this ope-
ration also cleans all the holes in the emulsifier
and empties internal circuits of possible milk
residues.
CLEANING AND MAINTENANCE
Before cleaning or servicing, disconnect the applian-
ce by removing the plug from the socket.
Cleaning the milk frother
The milk frother must be cleaned each time you use
the appliance. Proceed as follows:
• Remove the milk tank by pressing the "PRESS"
lever and at the same time pulling upwards. Wash
with hot water (fig.17).
• Remove the red emulsifier by pressing on the clip
(A) and at the same time pulling upwards (fig.
18). Remove the rubber mixer, wash and clean
with hot water (fig. 19), particularly the four holes
indicated in figure 20 (use a needle). Make sure
the hole indicated with the arrow B is not blocked.
•Once clean, all elements must be replaced cor-
rectly. In particular, make sure the rubber mixer
is inserted completely and that the red emulsifier
is pushed in fully until it clicks into place. If you
do not clean the tube after use, milk frothing
may not be successful, the milk may not be
sucked up or milk may drip from the milk tube.
Other cleaning
• Also clean the jug, filter holder and filter regularly.
• When cleaning plastic components of the
appliance, do not use solvents or abrasive deter-
gents. Clean with a soft cloth only.
• NEVER immerse the appliance in water.
DESCALING
You are recommended to descale the coffee machine
about every 300 coffees. You should use a commer-
cially available product specifically for descaling
espresso coffee machines. If you cannot obtain such a
product, you can also follow the procedure below.
1. First clean the coffee machine, turn off and unplug
from the mains.
2. Fill the jug to the brim.
3. Dissolve 1 spoonful (about 10/15 g) of citric acid
(obtainable from chemist's or drug stores);
4. Pour the solution into the boiler.
5. Replace the boiler cap and leave the solution to
work for about 30 minutes.
6. Place the selector in the "LIGHT" position.
7. Put the filter and filter holder in position (without
coffee).
8. Position the jug on the drip tray.
9. Plug the appliance into the mains.
10.Turn the coffee machine on. After a few minutes,
the hot solution will start to flow through the filter
holder on the jug.
11.Place the steam tube in a glass or cup. Open the
steam knob for a few seconds while the descaling
solution flows through the filter holder. This cleans
all residues of milk from inside the tube.
12.Close the steam knob (the descaling solution will
continue to flow into the jug).
13.When the solution stops flowing into the jug, turn
off and allow the machine to cool down.
Remove the filter holder, filter and jug and rinse
with hot water.
14.To remove traces of descaler, perform at least 2
coffee-making cycles without coffee.
Failure to clean as described above invalidates the
guarantee.
SERVICE AND REPAIR
If the machine breaks down or is faulty, contact your
nearest technical service centre. Repairs not carried
out by authorised personnel invalidate the guarantee.
12


Produktspezifikationen

Marke: DeLonghi
Kategorie: Kaffeemaschine
Modell: EC 9.1

Brauchst du Hilfe?

Wenn Sie Hilfe mit DeLonghi EC 9.1 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Kaffeemaschine DeLonghi

Bedienungsanleitung Kaffeemaschine

Neueste Bedienungsanleitung für -Kategorien-