DeLonghi Bar 32 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für DeLonghi Bar 32 (6 Seiten) in der Kategorie Kaffeemaschine. Dieser Bedienungsanleitung war für 38 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/6
5
Read this manual thoroughly before installing and
using the appliance.
This is the only way to ensure best results and
maximum safety for the user.
DESCRIPTION
(see figure on page 3).
The terminology below will be used repeatedly on the
following pages.
1 Filter holder for ground coffee
2Large filter for 2 cups ground coffee
3Small filter for 1 cup ground coffee or pods (if present)
4 Steam knob
5Presser
6 Cup tray
7 Power cable
8Temperature OK light (coffee/hot water or steam)
9 light (appliance on)
10 Function selector knob
11 position to run off coffee/hot water
12 Off position
13 Steam position
14 Coffee measure
15 Boiler outlet
16 Steam/hot water tube
17 Cappuccino maker
18 Water tank
19 Water tank lid
SAFETY WARNINGS
• This appliance is designed to "make espresso coffee"
and "heat drinks". Use with care to avoid scalds
from the water and steam jets or through incorrect
use.
• Never touch hot parts.
• After removing the packaging, make sure the
product is complete. If in doubt, do not use the
appliance and contact a professionally qualified
person.
• The packing elements (plastic bags, polystyrene
foam, etc.) should be kept out of the reach of children
as they are a safety hazard.
• This appliance is intended for domestic use only. Any
other use is considered improper and thus
dangerous.
• The manufacturer cannot be held responsible for any
damage caused through incorrect, wrong or
unreasonable use.
• Never touch the appliance with wet or damp hands
or feet.
• Never let children or unfit persons use the appliance
without supervision.
• Never allow children to play with the appliance.
• In the event of malfunction or faulty operation, switch
off and do not attempt to repair.
• If it requires repair, contact an authorised service
centre only and ask for original spare parts to be
used.
• Failure to respect the above could reduce the safety
of the appliance.
• The power cable for this appliance must not be
replaced by the user as this operation requires the
use of special tools.
• If the cable is damaged or requires replacing,
contact an authorised service centre only to avoid all
risks.
INSTALLATION
• Place the appliance on a work surface away from
taps and sinks.
• Check that the voltage of the mains power supply
corresponds to the value indicated on the appliance
rating plate.
• Connect the appliance to an efficiently earthed
socket with a minimum current rating of 10 A only.
• The manufacturer may not be considered liable for
possible incidents caused by the failure to
adequately earth the mains.
• If the plug fitted to the appliance does not match the
power socket, have the socket replaced with a
suitable type by a qualified professional.
• Never install the appliance in environments where
the temperature may reach 0°C or lower (the
appliance may be damaged if the water freezes).
• If the power cable is longer than the distance
required to reach the mains socket, the extra length
can be stored inside the appliance by pushing the
cable back through the cable opening.
• The power cable can be positioned to the right or left
according to the location of the nearest socket,
resting it in the guides on the bottom of the appliance
(fig. 1).
When the power cable is in the required position,
make sure it is correctly held in place by the clips on
the bottom of the appliance (fig. 1).
6
HOW TO MAKE ESPRESSO COFFEE
FILLING THE WATER TANK
Remove the water tank lid (fig. 2) and then take out the
tank by pulling upwards (fig. 3).
Fill the tank with fresh clean water taking care not to
exceed the MAX level (fig. 4).
Replace the tank, pressing lightly to open the valve
located on the bottom of the tank.
More simply, the tank can also be filled without
removing it, pouring the water directly from a jug.
IMPORTANT: It is normal for there to be water in the
space under the tank. This should therefore be dried
regularly with a clean sponge.
NB: Never use the appliance without water in the tank
and always remember to top up when the level drops
to a couple of centimetres from the bottom.
PREHEATING THE COFFEE UNIT
To obtain espresso coffee at the right temperature, the
coffee machine must be preheated. Turn the selector
knob to the position (fig. 5) at least 15 to 30
minutes before making the coffee, making sure the filter
holder is attached to the appliance (check that the
steam knob is closed). To attach the filter holder,
position it under the boiler outlet with the handle
towards the left (see fig. 6), push it upwards and at the
same time rotate the handle towards the right. Rotate
firmly. Wait for half an hour, then make the coffee as
described in the following chapter.
Alternatively, preheating can be achieved more rapidly
proceeding as follows:
1.Turn the appliance on by rotating the selector knob to
the position (fig. 5) and attach the filter holder to
the appliance without adding ground coffee.
2.Place a cup under the filter holder. Use the same cup
as will be used to prepare the coffee in order to
preheat it.
3.Wait for the OK indicator light to come on (fig. 7),
then immediately rotate the selector knob to the
position (fig. 7), run the water off until the OK
indicator light goes out, then interrupt delivery by
rotating the selector knob to the position (fig. 5).
4.Empty the cup. Wait until the OK indicator light
comes on again then repeat the same operation.
HOW TO PREPARE ESPRESSO COFFEE USING THE
FILTER HOLDER FOR GROUND COFFEE
1.After preheating the appliance as described above,
place the ground coffee filter in the filter holder,
making sure the projection is correctly inserted in the
slot as shown in fig. 9. For appliances with two
filters, use the smallest for one coffee and the largest
for two coffees.
2.To make a single coffee only, place one level measure
of ground coffee, about 7 grams, in the filter (fig. 10).
To prepare two coffees, place two loosely filled
measures of ground coffee (about 6+6 g) in the filter.
Fill the filter a little at a time to prevent the ground
coffee from overflowing.
IMPORTANT: for correct operation, before adding the
ground coffee to the filter holder, clean the filter from
residues of ground coffee from the previous infusion.
3.Distribute the ground coffee evenly and press lightly
with the pressing pad (fig. 11). NB: Correct pressing
of the ground coffee is essential to obtain a good
espresso. If pressing is excessive, coffee delivery will
be slow and the froth will be dark. If pressing is too
light, coffee delivery will be too rapid and the froth
will be skimpy and light coloured.
4.Remove any excess coffee from the rim of the filter
holder and attach the filter holder to the appliance.
Rotate firmly (fig. 6) to avoid leaks of water.
5.Place the cup or cups (ideally preheated by rinsing
with a little hot water) under the filter holder spouts
(fig. 12).
6.Make sure the OK light (fig. 7) is on (if off, wait until
it comes on), then turn the knob to the position
(fig. 8) until the required quantity is obtained. To
interrupt, place the selector back in the position
(fig. 5).
7.To remove the filter holder, rotate the handle from
right to left.
IMPORTANT: to avoid splashes, never remove the
filter holder while the appliance is delivering
coffee.
8.To eliminate the used coffee grounds, block the filter
in place using the lever incorporated in the handle
and empty the coffee by turning the filter holder
upside down and tapping (fig. 13).
9.To turn the appliance off, rotate the selector knob to
the "O" position (fig. 14).
IMPORTANT: the first time the appliance is used, all
accessories and the internal circuits must be washed
through by making at least five coffees without using
ground coffee.
HOW TO PREPARE ESPRESSO COFFEE USING PODS
(FOR APPLIANCES WITH TWO FILTERS ONLY)
1.Preheat the appliance as described in the section
"PREHEATING THE COFFEE UNIT", making sure the
filter holder is attached This obtains a hotter coffee.
NB: use pods conforming to the ESE standard,
indicated on the pack by the following symbol:
The ESE standard is a system accepted by leading pod
producers and enables espresso coffee to be prepared
simply and cleanly.
2.Place the small 1 coffee or pod filter in the filter
holder, making sure the projection is correctly
inserted in the slot as shown in fig. 9.
3.Insert a pod, centring it as far as possible on the filter
(fig. 15).Always follow the instructions on the pod
pack to position the pod on the filter correctly.
4.Attach the filter holder to the appliance. Always
rotate as far as it will go (fig. 6).
5.Proceed as in points 5, 6 and 7 in the previous
paragraph.
HOW TO MAKE CAPPUCCINO COFFEE
1.Prepare the espresso coffees as described in the
previous paragraphs, using sufficiently large cups.
2.Rotate the selector knob to the position (fig. 16)
and wait until the OK light comes on (fig. 7). This
indicates that the boiler has reached the ideal
temperature for steam production.
3.In the meantime, fill a recipient with about 100
grams of milk for each cappuccino to be prepared.
The milk must be at refrigerator temperature (not
hot!). In choosing the size of the recipient, bear in
mind that the milk doubles or triples in volume.
NB: You are recommended to use semi-skimmed milk
at refrigerator temperature.
4.Place the recipient containing the milk under the
cappuccino maker (fig. 17).
5.Immerse the cappuccino maker in the milk for about 5 mm
and rotate the steam knob anticlockwise (fig. 18) (rotating
the knob more or less varies the quantity of steam
discharged by the cappuccino maker). The milk now starts
to increase in volume and take on a creamy appearance.
6.When the milk has doubled in volume, immerse the
cappuccino maker deeply and continue heating the
milk (fig. 19). When the required temperature is
reached (the ideal is 60°C), interrupt steam delivery
by rotating the steam knob clockwise and placing the
selector in the "O" position (fig. 14).
7.Pour the frothed milk into the cups containing the
espresso coffee prepared previously.
The cappuccino is ready. Sweeten to taste and if
desired, sprinkle the froth with a little cocoa powder.
NB: to make coffee again after the milk has been
frothed, cool down the boiler first or the coffee will
be burnt. To cool, place a container under the boiler
outlet, turn the selector to the "coffee" position and
run off the water until the OK light goes out. Turn the
selector back to the position and make the coffee
as described above.
IMPORTANT: always clean the cappuccino maker
after use. Proceed as follows:
1.Discharge a little steam for a few seconds by rotating
the steam knob (fig. 18).
2.Wait several minutes for the steam tube to cool
down. Unscrew the cappuccino maker by rotating
clockwise (fig. 20) and wash thoroughly with warm
water.
3.Make sure the three holes in the cappuccino maker
shown in fig. 21 are not blocked. If necessary, clean
with a pin.
4.Clean the steam tube, taking care to avoid burns.
5.Screw the cappuccino maker back in place.
HOT WATER PRODUCTION
1.Turn the appliance on by rotating the selector knob to
the position (fig. 5).
2.Place a recipient under the cappuccino maker.
3.When the OK indicator light comes on, turn the
selector knob to the position (fig. 8) and at the
same time, rotate the steam knob anticlockwise (fig.
18). Hot water is delivered from the cappuccino
maker.
4.To interrupt delivery of hot water, rotate the steam
knob clockwise and position the selector knob to "O"
(fig. 14).
CLEANING AND MAINTENANCE OF THE
FILTER
About every 300 coffees or when the coffee drips out
of the filter holder or not at all, clean the ground coffee
filter holder as follows:
• Remove the filter from the filter holder.
• Remove the filter cap (fig. 22) by unscrewing in the
direction indicated by the arrow on the cap.
• Remove the frother from the container by pushing it
from the cap end.
• Remove the gasket (fig. 25).
• Rinse all components and clean the metal filter
thoroughly in hot water using a brush (fig. 23).
Make sure the holes in the metal filter are not
blocked. If necessary, clean with a pin (see fig. 24).
• Replace the filter and gasket on the plastic disk as
7


Produktspezifikationen

Marke: DeLonghi
Kategorie: Kaffeemaschine
Modell: Bar 32

Brauchst du Hilfe?

Wenn Sie Hilfe mit DeLonghi Bar 32 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Kaffeemaschine DeLonghi

Bedienungsanleitung Kaffeemaschine

Neueste Bedienungsanleitung für -Kategorien-