Ctek MXTS 40 Bedienungsanleitung

Ctek Ladegerät MXTS 40

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Ctek MXTS 40 (18 Seiten) in der Kategorie Ladegerät. Dieser Bedienungsanleitung war für 29 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/18
EN • 3
EN
CONGRATULATIONS
on the purchase of your new professional switch mode battery charger.
This charger is included in a series of professional chargers from
CTEK SWEDEN AB and represents the latest technology in battery
charging. MXTS 40 is a charger with multiple adjustable parameters.
MANUAL
• THE CHARGER IS DESIGNED FOR CHARG-
ING ONLY BATTERIES ACCORDING TO THE
TECHNICAL SPECIFICATION. DO NOT USE
THE CHARGER FOR ANY OTHER PURPOSE.
ALWAYS FOLLOW BATTERY MANUFACTUR-
ERS RECOMMENDATIONS.
• NEVER TRY TO CHARGE NON RECHARGE-
ABLE BATTERIES.
• CHECK THE CABLES PRIOR TO USE. ENSURE
THAT NO CRACKS HAVE OCCURRED IN
THE CABLES OR BEND PROTECTION. A
CHARGER WITH DAMAGED CABLES MUST
NOT BE USED. A DAMAGED CABLE MUST
BE REPLACED BY AN ORIGINAL PART SUP-
PLIED BY CTEK.
• NEVER CHARGE A DAMAGED BATTERY.
• NEVER CHARGE A FROZEN BATTERY.
• NEVER PLACE THE CHARGER ON TOP OF
THE BATTERY WHEN CHARGING.
• ALWAYS PROVIDE FOR PROPER VENTILA-
TION DURING CHARGING.
• AVOID COVERING THE CHARGER.
• A BATTERY BEING CHARGED COULD EMIT
EXPLOSIVE GASES. PREVENT SPARKS CLOSE
TO THE BATTERY.
• ALL BATTERIES FAIL SOONER OR LATER. A
BATTERY THAT FAILS DURING CHARGING IS
NORMALLY TAKEN CARE OF BY THE CHARG-
SAFETY
ERS ADVANCED CONTROL, BUT SOME
RARE ERRORS IN THE BATTERY COULD STILL
EXIST. DON’T LEAVE ANY BATTERY DURING
CHARGING UNATTENDED FOR A LONGER
PERIOD OF TIME.
• ENSURE THAT THE CABLING DOES NOT
JAM OR COMES INTO CONTACT WITH HOT
SURFACES OR SHARP EDGES.
• BATTERY ACID IS CORROSIVE. RINSE IMME-
DIATELY WITH WATER IF ACID COMES INTO
CONTACT WITH SKIN OR EYES, SEEK IMME-
DIATE MEDICAL ADVICE.
• ALWAYS CHECK THAT THE CHARGER HAS
SWITCHED TO STEP 7 BEFORE LEAVING THE
CHARGER UNATTENDED AND CONNECTED
FOR LONG PERIODS. IF THE CHARGER
HAS NOT SWITCHED TO STEP 7 WITHIN
55 HOURS, THIS IS AN INDICATION OF
AN ERROR. MANUALLY DISCONNECT THE
CHARGER.
• BATTERIES CONSUME WATER DURING USE
AND CHARGING. FOR BATTERIES WHERE
WATER CAN BE ADDED, THE WATER LEVEL
SHOULD BE CHECKED REGULARLY. IF THE
WATER LEVEL IS LOW ADD DISTILLED WATER.
• (IEC 7.12 ED.5) THIS APPLIANCE IS NOT
INTENDED FOR USE BY PERSONS (INCLUD-
ING CHILDREN) WITH REDUCED PHYSICAL,
SENSORY OR MENTAL CAPABILITIES, OR
LACK OF EXPERIENCE AND KNOWLEDGE,
UNLESS THEY HAVE BEEN GIVEN SUPER-
VISION OR INSTRUCTION CONCERN-
ING USE OF THE APPLIANCE BY A PERSON
RESPONSIBLE FOR THEIR SAFETY. CHILDREN
SHOULD BE SUPERVISED TO ENSURE THAT
THEY DO NOT PLAY WITH THE APPLIANCE.
(EN 7.12) THIS APPLIANCE CAN BE USED
BY CHILDREN AGED FROM 8 YEARS AND
ABOVE AND PERSONS WITH REDUCED
PHYSICAL, SENSORY OR MENTAL CAPA-
BILITIES, OR LACK OF EXPERIENCE AND
KNOWLEDGE IF THEY HAVE BEEN GIVEN
SUPERVISION OR INSTRUCTION CON-
CERNING USE OF THE APPLIANCE IN A SAFE
WAY AND UNDERSTAND THE HAZARDS
INVOLVED. CHILDREN SHALL NOT PLAY
WITH THE APPLIANCE. CLEANING AND
USER MAINTENANCE SHALL NOT BE MADE
BY CHILDREN WITHOUT SUPERVISION.
• CONNECTION TO THE MAINS SUPPLY
MUST BE IN ACCORDANCE WITH THE
NATIONAL REGULATIONS FOR ELECTRICAL
INSTALLATIONS.
• CHARGERS WITH GROUNDED MAINS
PLUG MUST ONLY BE CONNECTED TO A
GROUNDED SOCKLET OUTLET.
• DON´T PLACE A FAN-COOLED CHARGER
SO THAT DUST, DIRT OR SIMILAR CAN BE
SUCKED INTO THE FAN.
• CHARGERS WITH IP-CLASS LOWER THAN
IPX4 ARE DESIGNED FOR INDOOR USE.
SEE TECHNICAL SPECIFICATION. DO NOT
EXPOSE TO RAIN OR SNOW.
4 • EN
MODE
START
STOP
STOP
SUPPLY
BOOST
Ca/Ca
AGM
NORMAL
SET
12345678
12V/40A
24V/20A
MXTS 40
CORD SET PRO
CORD SET PRO
female connector +
Temperature sensor
male connector
CORD SET PRO
female connector -
Charger cable
male connector +/-
Mains cable
Clamps
Eyelets M6
Temperature sensor
Mains cable connector/
Mains switch
Temperature sensor
female connector
USB Type B contact


Produktspezifikationen

Marke: Ctek
Kategorie: Ladegerät
Modell: MXTS 40
Gewicht: 1300 g
Produktfarbe: Schwarz
Internationale Schutzart (IP-Code): IP20
Eingebautes Display: Nein
Stromstärke: 3 A
LED-Anzeigen: Ja
Ladespannung: 12 V

Brauchst du Hilfe?

Wenn Sie Hilfe mit Ctek MXTS 40 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Ladegerät Ctek

Bedienungsanleitung Ladegerät

Neueste Bedienungsanleitung für -Kategorien-