Crestron Ultimate IGS12T-PRIMED-EACH Bedienungsanleitung

Crestron Lautsprecher Ultimate IGS12T-PRIMED-EACH

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Crestron Ultimate IGS12T-PRIMED-EACH (4 Seiten) in der Kategorie Lautsprecher. Dieser Bedienungsanleitung war für 16 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
The Crestron® ULTIMATE IGS12T-PRIMED-EACH in-ground subwoofer
made by Origin Acoustics provides the full impact of your music
outdoors with rich and deep bass. Its compact, watertight enclosure
installs beneath the ground’s surface, affording a virtually hidden
appearance with just the port tube and dome visible. The port tube is
topped with a primed, paintable dome-shaped cap, providing a subdued
appearance.
In the
In the
In the
In the In the Box
Box
Box
BoxBox
1 ULTIMATE IGS12T-PRIMED-EACH
 
Additional Items
Additional Items
Additional Items
Additional ItemsAdditional Items
1 Dome
2 Wire Nuts
Installation
Installation
Installation
Installation Installation
Prepare the
Prepare the
Prepare the
Prepare the Prepare the Site
Site
Site
SiteSite
1. Choose a location that will not flood and where the port tube and
dome will not be affected by an in-ground sprinkler system. The
installation must comply with all national and local codes.
ULTIMATE
ULTIMATE
ULTIMATE
ULTIMATEULTIMATE IGS12T-PRIMED-EACH
IGS12T-PRIMED-EACH
IGS12T-PRIMED-EACH
IGS12T-PRIMED-EACHIGS12T-PRIMED-EACH QuickStart
Ultimate
Ultimate
Ultimate
UltimateUltimate 12
12
12
1212 in.
in.
in.
in.in. In-Ground
In-Ground
In-Ground
In-GroundIn-Ground Subwoofer,
Subwoofer,
Subwoofer,
Subwoofer,Subwoofer, Primed
Primed
Primed
PrimedPrimed Paintable,
Paintable,
Paintable,
Paintable,Paintable, Single
Single
Single
SingleSingle
1
1
1
11
2. Dig a hole with minimum dimensions to bury the speaker:
 Height: 15-17 in. (381-432 mm)l
 Diameter: 22 in. (559 mm) l
3. Prepare a flat bed for the subwoofer that is free of voids and large
rocks (see Figure B).
NOTE:
NOTE:
NOTE:
NOTE:NOTE: The hole must be deep enough to allow a 2 to 4 in. (51 to 102
mm) layer of material (sand and gravel mix or other material
approved by local codes) and position the base of the speaker 15 to
17 in. (381 to 432 mm) below ground level.
2
2
2
22
ULTIMATE
ULTIMATE
ULTIMATE
ULTIMATEULTIMATE IGS12T-PRIMED-EACH
IGS12T-PRIMED-EACH
IGS12T-PRIMED-EACH
IGS12T-PRIMED-EACHIGS12T-PRIMED-EACH QuickStart
Ultimate
Ultimate
Ultimate
UltimateUltimate 12
12
12
1212 in.
in.
in.
in.in. In-Ground
In-Ground
In-Ground
In-GroundIn-Ground Subwoofer,
Subwoofer,
Subwoofer,
Subwoofer,Subwoofer, Primed
Primed
Primed
PrimedPrimed Paintable,
Paintable,
Paintable,
Paintable,Paintable, Single
Single
Single
SingleSingle
Mount the
Mount the
Mount the
Mount the Mount the Subwoofer
Subwoofer
Subwoofer
SubwooferSubwoofer
1. Remove the tap cap and rotate the dial to the 70V/100V or 8 Ohm
tap selection and then firmly reinstall the tap cap (see Figure A).
NOTE:
NOTE:
NOTE:
NOTE:NOTE: Make sure the desired tap selection is done on the subwoofer
before lowering it into the ground.
2. Place the subwoofer into the ground.
NOTE:
NOTE:
NOTE:
NOTE:NOTE: Ensure that the bottom of the dome is about 4 in. (102 mm)
above ground level – it should not be buried or set at ground level.
3. Dig a 5 in. (127 mm) deep trench to run the speaker cable in. Make
sure trenching is done as per local codes.

Connect the
Connect the
Connect the
Connect the Connect the Speaker Cable
Speaker Cable
Speaker Cable
Speaker CableSpeaker Cable
1. Run the speaker cable (not included) from theaudio source to the
wire nut, observing all appropriate local codes.
2. Run the speaker cable from the speaker location to the wire nut,
observing all appropriate local codes.
NOTES:
NOTES:
NOTES:
NOTES:NOTES:
 The speaker includes a hardwired direct-burial speaker cable.l
 Make sure that the positive cable is attached to the red lconnection, and the negative cable is attached to the black
connection.
3. Combine and twist the positive (+) cables together in a clockwise
motion. Repeat this step for the negative (-) cables.
4. Secure the two cables together using the wire nuts ensuring that NO
COPPER is exposed.

3
3
3
33
ULTIMATE
ULTIMATE
ULTIMATE
ULTIMATEULTIMATE IGS12T-PRIMED-EACH
IGS12T-PRIMED-EACH
IGS12T-PRIMED-EACH
IGS12T-PRIMED-EACHIGS12T-PRIMED-EACH QuickStart
Ultimate
Ultimate
Ultimate
UltimateUltimate 12
12
12
1212in.
in.
in.
in.in. In-Ground
In-Ground
In-Ground
In-GroundIn-GroundSubwoofer,
Subwoofer,
Subwoofer,
Subwoofer,Subwoofer, Primed
Primed
Primed
PrimedPrimedPaintable,
Paintable,
Paintable,
Paintable,Paintable, Single
Single
Single
SingleSingle


Produktspezifikationen

Marke: Crestron
Kategorie: Lautsprecher
Modell: Ultimate IGS12T-PRIMED-EACH

Brauchst du Hilfe?

Wenn Sie Hilfe mit Crestron Ultimate IGS12T-PRIMED-EACH benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Lautsprecher Crestron

Bedienungsanleitung Lautsprecher

Neueste Bedienungsanleitung für -Kategorien-