Chief PXRUB Bedienungsanleitung

Chief Flachbildschirmunterstützung PXRUB

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Chief PXRUB (32 Seiten) in der Kategorie Flachbildschirmunterstützung. Dieser Bedienungsanleitung war für 10 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/32

I N S T A L L A T I O N I N S T R U C T I O N S

Automated Wall Mount

This device complies with part 15 of the FCC rules. Operation is subject to the following 2 conditions: (1) This device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if

not installed and used in accordance with the instructions, may cause harmful interference to radio or television communications. However, there is no guarantee that

the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment to an outlet on a circuit other than that to which the receiver is connected

Consult the dealer or an experienced radio/TV technician for help.

PXR

PXR Installation Instructions

DISCLAIMER

Milestone AV Technologies, and its affiliated corporations and

subsidiaries (collectively, "Milestone"), intend to make this

manual accurate and complete. However, Milestone makes no

claim that the information contained herein covers all details,

conditions or variations, nor does it provide for every possible

contingency in connection with the installation or use of this

product. The information contained in this document is subject

to change without notice or obligation of any kind. Milestone

makes no representation of warranty, expressed or implied,

regarding the information contained herein. Milestone assumes

no responsibility for accuracy, completeness or sufficiency of

the information contained in this document.

Chief® is a registered trademark of Milestone AV Technologies.

IMPORTANT SAFETY INSTRUCTIONS

WARNING alerts you to the possibility of

serious injury or death if you do not follow the instructions.

CAUTION alerts you to the possibility of

damage or destruction of equipment if you do not follow the

corresponding instructions.

WARNING: FAILURE TO READ AND

FOLLOW THE FOLLOWING INSTRUCTIONS CAN RESULT

IN SERIOUS PERSONAL INJURY, DAMAGE TO EQUIPMENT

OR VOIDING OF FACTORY WARRANTY. It is the installer’s

responsibility to make sure all components are properly

assembled and installed using the instructions provided.

When using an electrical mounting system, basic precautions

should always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING THIS

PRODUCT!!!!

DANGER: TO REDUCE THE RISK OF

ELECTRIC SHOCK:

1. Always turn off power at source before cleaning.

WARNING: TO REDUCE THE RISK OF

BURNS, FIRE, ELECTRIC SHOCK, OR INJURY TO

PERSONS:

• Always turn off power at source before putting on or

taking off parts.

• Use this mounting system only for its intended use as

described in these instructions. Do NOT use

attachments not recommended by the manufacturer.

• Never operate this mounting system if it has a

damaged cord or plug. If it is not working properly

during testing, return the mounting system to a service

center for examination and repair.

• Keep the power cord away from heated surfaces.

• Never operate the mounting system with the air

openings blocked. Keep the air openings free of lint,

hair, and the like.

• Never drop or insert any object into any opening.

• Do not use outdoors unless marked for outdoor use.

• Route cords and cables as shown in the installation

instructions.

• To disconnect, turn all controls to the off position, then

turn off power at source.

WARNING:RISK OF ELECTRIC SHOCK!

Connect this mounting system to a properly grounded outlet

only. See Grounding Instructions.

CAUTION: Changes or modifications to this

unit not expressly approved by the manufacturer can void the

units FCC compliance rating and make the unit illegal to

operate.

WARNING:Failure to provide adequate

structural strength for this component can result in serious

personal injury or damage to equipment! It is the installer’s

responsibility to make sure the structure to which this

component is attached can support five times the combined

weight of all equipment. Reinforce the structure as required

before installing the component.

WARNING:Exceeding the weight capacity

can result in serious personal injury or damage to equipment!

The weight capacity of the PXR varies based on the depth of

the display (including spacers), but must not exceed 150 lbs

(68.0). It is the installer’s responsibility to make sure the weight

of all components attached to the PXR meet this criteria.

NOTE: This system has no user serviceable parts.

--SAVE THESE INSTRUCTIONS--

Installation Instructions PXR

TABLE OF CONTENTS

DISCLAIMER . . . . . . . . . . . . . . . . . . . . . . . . . 2

TABLE OF CONTENTS . . . . . . . . . . . . . . . . . 3

DIMENSIONS . . . . . . . . . . . . . . . . . . . . . . . . . 4

LEGEND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

TOOLS REQUIRED FOR INSTALLATION . . 7

PARTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7

SITE PREPARATION . . . . . . . . . . . . . . . . . . 8

Locating and Preparing a Mounting Site . .8

Power Requirements and Wiring . . . . . . .8

Grounding Instructions . . . . . . . . . . . . . . .8

PXR DIAGRAM . . . . . . . . . . . . . . . . . . . . . . . 9

INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . 9

Installing to a Wood Stud Wall . . . . . . . .10

Installing to a Solid Concrete Wall . . . . . 12

Installing in an In-Wall Box . . . . . . . . . . . 14

Arm Engagement . . . . . . . . . . . . . . . . . . 16

Installing IR Sensor . . . . . . . . . . . . . . . . . 17

SET-UP AND TESTING CONFIGURATION 17

Running Learn Mode (Test). . . . . . . . . . . 17

Attach Interface Brackets to Display . . . . 18

Hanging Display on PXR . . . . . . . . . . . . 19

Cable Management . . . . . . . . . . . . . . . . . 20

SET-UP AND CONFIGURATION WITH

DISPLAY ATTACHED . . . . . . . . . . . . . . 21

Running LEARN MODE . . . . . . . . . . . . . 21

Saving a Preset . . . . . . . . . . . . . . . . . . . 22

Final Attachment to Wall Mounting

Bracket . . . . . . . . . . . . . . . . . . . . . . . . . 23

ADVANCED SETTINGS . . . . . . . . . . . . . . . 23

IR Repeat Conditions . . . . . . . . . . . . . . 23

Heavy Screen Mode . . . . . . . . . . . . . . . 23

Emergency Service Extend. . . . . . . . . . . 23

PROGRAMMING VIA RS485 . . . . . . . . . . . 24

Setting PXR Address . . . . . . . . . . . . . . 24

RS-485 Commands . . . . . . . . . . . . . . . 24

Calculating a Check Digit Code . . . . . . . 24

Common Commands . . . . . . . . . . . . . . . 25

Get Status (0x01) Command . . . . . . . . . 25

Get System Status (0x2F). . . . . . . . . . . . 26

PXR Blink Codes . . . . . . . . . . . . . . . . . . 26

Fault Conditions . . . . . . . . . . . . . . . . . . . 26

RS-485 Terminal Block Wiring . . . . . . . . 28

IR Receiver Pinout . . . . . . . . . . . . . . . . . 28

Produktspezifikationen

Marke:	Chief
Kategorie:	Flachbildschirmunterstützung
Modell:	PXRUB
Breite:	743 mm
Tiefe:	114 mm
Produktfarbe:	Schwarz
Höhe:	487 mm
Befestigungstyp:	Wand
Höchstgewichtskapazität:	68 kg
Zertifizierung:	FCC
Neigungswinkelbereich:	-12 - 0 °
Projektionsflächenkapazität:	32 - 65 "
Maximale Bildschirmgröße:	65 "
Minimum Bildschirmgröße:	32 "
Minimale VESA-Halterung:	200 x 100 mm
Maximale VESA-Halterung:	200 x 100 mm
Abstand zur Wand (max):	685.8 mm
Abstand zur Wand (min):	114.3 mm