Chief PAC116 Bedienungsanleitung

Chief Flachbildschirmunterstützung PAC116

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Chief PAC116 (4 Seiten) in der Kategorie Flachbildschirmunterstützung. Dieser Bedienungsanleitung war für 48 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/4
I N S T A L L A T I O N I N S T R U C T I O N S
Steel Stud / Dry Wall Anchor Kits
PAC115-116-117
PAC115-116-117 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT WARNINGS AND
CAUTIONS!
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component. The wall to which the mount is being attached
may have a maximum drywall thickness of 5/8" (1.6cm).
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components does not exceed 175 lbs (79.38 kg) or the
maximum weight capacity of the mount to which this
accessory is being installed. This product is NOT designed
for use with articulating wall mounts.
TOOLS/PARTS FOR INSTALLATION
(A)
[1/4-20 toggler anchor]
(B)
1/4-20 x 1-3/4"
(C)
1/4"
A B C
MODEL (qty) (qty) (qty)
PAC115 4 4 4
PAC116 8 8 8
PAC117 28 28 28
Installation Instructions PAC115-116-117
3
Assembly and Installation
1. Drill a 1/2" hole at the desired location, making sure wall is
at least 1/2" thick. If the wall is made with metal studs, it is
recommended to install the anchor through the drywall and
the metal stud.
2. Hold metal channel on anchor (A) flat alongside plastic
straps and slide channel through hole. (See Figure 1)
Figure 1
3. Holding plastic straps on anchor (A), pull anchor away from
wall until channel rests flush behind wall making sure anchor
channel is positioned vertically on stud. (See Figure 2)
4. Slide plastic cap on anchor (A) towards wall until flange of
cap is flush with wall. (See Figure 2)
Figure 2
5. Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 3)
6. Repeat steps 1 through 5 for each mounting hole.
Figure 3
7. Place mount over anchors and align mounting holes in
display mount with holes in anchors. (See Figure 4)
8. Insert 1/4-20 x 1-3/4" Phillips pan head screws (B) through
1/4" washer (C), corresponding mounting hole on mount
and into anchor (A) and tighten until flush against mount.
DO NOT overtighten! (See Figure 4)
9. Repeat steps 7 and 8 for remaining mounting holes.
WARNING: IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Overtightening of
mounting hardware can damage the steel studs. DO NOT
overtighten mounting hardware!
Figure 4
(A)
Drywall
Plastic Straps
2
(A)
Plastic Cap
Drywall
Anchor Metal Channel
SIDE VIEW
3
Steel Stud
4
Plastic Straps
Drywall
Anchor Metal Channel
Plastic Cap
SIDE VIEW
5
Steel Stud
Drywall
Anchor Metal Channel
Mount
SIDE VIEW
(B)
8
Steel Stud
(C)

Produktspezifikationen

Marke: Chief
Kategorie: Flachbildschirmunterstützung
Modell: PAC116

Brauchst du Hilfe?

Wenn Sie Hilfe mit Chief PAC116 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Flachbildschirmunterstützung Chief

Chief

Chief MSA3029 Bedienungsanleitung

20 August 2024
Chief

Chief SLB185 Bedienungsanleitung

18 August 2024
Chief

Chief KSA1017S Bedienungsanleitung

27 Mai 2024
Chief

Chief RSMA198 Bedienungsanleitung

25 Mai 2024
Chief

Chief MTA3301 Bedienungsanleitung

25 Mai 2024
Chief

Chief RPEU Bedienungsanleitung

23 Mai 2024
Chief

Chief SLB620 Bedienungsanleitung

22 Mai 2024
Chief

Chief MSM3124 Bedienungsanleitung

19 Mai 2024
Chief

Chief SL151 Bedienungsanleitung

19 Mai 2024
Chief

Chief PWR2059B Bedienungsanleitung

18 Mai 2024

Bedienungsanleitung Flachbildschirmunterstützung

Neueste Bedienungsanleitung für -Kategorien-

NewStar

NewStar FPMA-CF200 Bedienungsanleitung

11 August 2024
Mount-It!

Mount-It! MI-442 Bedienungsanleitung

24 Juni 2024
Sanus

Sanus WSEDM1 Bedienungsanleitung

23 Juni 2024
Sanus

Sanus VMPL Bedienungsanleitung

23 Juni 2024
Sanus

Sanus VLT35 Bedienungsanleitung

23 Juni 2024
Sanus

Sanus MEHUCM-B2 Bedienungsanleitung

23 Juni 2024
Sanus

Sanus WSEHUCM Bedienungsanleitung

23 Juni 2024
Sanus

Sanus LMT1 Bedienungsanleitung

23 Juni 2024
Sanus

Sanus VMPL50 Bedienungsanleitung

23 Juni 2024
Sanus

Sanus VM200 Bedienungsanleitung

23 Juni 2024