CDA KC73WH Bedienungsanleitung

CDA Waschbecken KC73WH

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für CDA KC73WH (4 Seiten) in der Kategorie Waschbecken. Dieser Bedienungsanleitung war für 6 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
www.cda.eu
Ceramic Sinks
Installation
2
Installation
Before Installation
Oer up the sink to the worktop and/or the cabinets to confirm that
the external dimensions of the bowl are compatible with the cabinets
themselves.
Confirm that with the sink in position:
There is adequate space to install any taps or other required
accessories.
There is adequate space to install the waste pipework and that any
necessary modification to internal shelves to accommodate the waste
(and trap) is acceptable.
Access to any water stop-cock or other services will still be adequate
after the installation.
Cutting the tap hole
Only cut/punch the tap hole from the top face of the sink.
Select the tap hole position based on whether left hand or right hand
drainer is required.
Locate the centre of the required tap hole by transferring
measurements from the cast in features on the underside. Cover the
top of the tap hole cut-out area with masking tape.
Caution: Ensure that the sink is supported under the hole to be cut
out.
Using a centre punch and hammer, make an initial cut in the glaze at
the centre of the required hole.
Still using the punch and hammer enlarge the cut to the full hole size
required for the tap by carefully chipping away.
3
E & O E. All instructions, dimensions and illustrations are provided for guidance only. CDA reserve the
right to change specifications without prior notice.
Installation
Refer to the cut-out sizes on the back of this manual and use them
to mark out where the worktop needs to be cut. Double-check the
dimensions before cutting the worktop aperture.
After cutting out the worktop aperture, we recommend you seal the
cut edges with silicone (or similar) sealant to help prevent ingress of
water.
It is often easier to mount the taps, waste-fitting and overflow onto the
sink prior to fitting the sink to the worktop.
Position the sink on the worktop, bedding it into a bed of silicone
sealant.
After positioning the sink, leave it untouched for 24 hours to allow
the sealant to cure before any water is run into it.
The taps, waste-fitting and overflow can now be mounted onto the
sink (if not already done) and fully connected to their respective
services.
To check the waste for leaks, close the plug/basket of the waste
fitting, open the tap and fill the sink to the level of the overflow; turn
o the tap and wait several minutes to verify that the water doesn’t
drain away.
Empty the sink.
After fitting, ensure that the enclosed “Ceramic Sinks Use and
Maintenance” guide is retained for the customer and/or user of the
sink.


Produktspezifikationen

Marke: CDA
Kategorie: Waschbecken
Modell: KC73WH

Brauchst du Hilfe?

Wenn Sie Hilfe mit CDA KC73WH benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Waschbecken CDA

Bedienungsanleitung Waschbecken

Neueste Bedienungsanleitung für -Kategorien-