Caliber MCD 300M Bedienungsanleitung

Caliber Autoradio MCD 300M

Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Caliber MCD 300M (24 Seiten) in der Kategorie Autoradio. Dieser Bedienungsanleitung war fĂĽr 22 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/24
E N G L I S H
1
S P E C I F I C A T I O N S
GENERAL
Power Supply DC 12V
Polarity Negative Ground
Speaker impedance 4 ohms
Power Output 4 x 55W
CD PLAYER
System Compact disc audio system
Usable disc Compact disc
Sampling frequency 44.1KHz
No of quantization bits 1bit
Frequency 20-20,000Hz
Number of channels 2 stereo
S/N Ratio >60dB
RADIO SECTION
FM
Frequency Range 87.5-108 Mhz
Intermediate Frequency 10.7 MHz
Usable Sensitivity Better than 15dB at S/N 30dB
Stereo Separation >30dB
S/N Ratio >60dB
REMARK :
Specifications subject to change without notice.
1. POWER BUTTON
2. MODE BUTTON
3. MUTE BUTTON
4. ROTARY VOLUME KNOB
5.AF BUTTON
6.TA BUTTON/
7. PTY BUTTON
8. DISPLAY BUTTON
9. BAND BUTTON
11.TUNING UP/DOWN,TRACK UP / DOWN BUTTONS
12. PRESET STATIONS BUTTONS (M1~M6)
13.AUTOMATICALLY STORE / PRESET SCAN (AS/PS) BUTTON
14. PANEL RELEASE BUTTON
19. RESET BUTTON
20. MICROPHONE
21. USB PORT
22. SD/MMC PORT
23. BLUETOOTH
24. CD EJECT BUTTON
RESET
E N G L I S H
2
D I S C P L A Y
P R E C A U TI O N S
• Use only in a 12-volt DC negative-ground electrical system.
• Disconnect the vehicle's negative battery terminal while mounting and connecting the
unit.
• When replacing the fuse, be sure to use one with an identical amperage rating.
• Using a fuse with a higher amperage rating may cause serious damage to the unit.
• DO NOT attempt to disassemble the unit. Laser beams from the optical pickup are dan-
gerous to the eyes.
• Make sure that pins or other objects do not get inside the unit; they may cause mal-
functions, or create safety hazards such as electrical shock or laser beam exposure.
• If you have parked the car for a long time in hot or cold weather, wait until the tem-
perature in the car become normal before operating the unit.
• Keep the volume at a level at which you can hear outside warning sounds (horns
sirens, etc.).
CD N OTE S
• Playing a defective or dusty CD can cause dropouts in sound.
• Hold CDs as illustrated.
• DO NOT touch the unlabeled side.
• DO NOT attach any seal, label or data protection sheet to either side of a disc.
• DO NOT expose a CD to direct sunlight or excessive heat.
• Wipe a dirty CD from the center outward with a cleaning cloth.
• Never use solvents such as benzine or alcohol.
• This unit cannot play 3-inch ( 8cm ) CDs.
• NEVER insert a 3-inch CD contained in the adapter
or an irregularly shaped CD.
• The unit may not be able to eject it, resulting in a
malfunction.
B E F OR E O P E R ATION
• DO NOT raise the volume level too much, as this
will block outside sounds, making driving dangerous.
• Stop the car before performing any complicated
operation.
C A U T I O N
DO NOT open covers and do not repair by yourself.
Consult the dealer or an experienced technician for help.
Installation procedures
First complete the electrical connections, and then
check them for correctness.
Anti-Theft System
This unit is equipped with a detachable panel.
Removing this panel makes the radio totally inoperable.
Removing the panel
1. Switch off the power of the unit.
2. Remove the detachable panel.
3. Gently press the button of the case and open the
cover. Place the panel into the case and take it with you
when you leave the car.
Install detachable panel
1.Fix right part of face plate in the right part of panel slot
of the unit.
2.Press down the left side of the face plate until it clicks
into the panel slot of the unit.
Remove the unit
Switch of the power of the unit.
1. Remove the panel and the trim plate.
2. Insert both T-Keys into hole in front of the set until
they lock.
3. Pull out the unit.
1. Insert mounting bracket into the
dashboard, and bend the mounting
tabs out with a screwdriver. (Make
sure that lock lever is flush with
the mounting bracket. Not projec-
ting outward)
2. Secure the rear of the unit After
fixing mounting bolt and power
connector, fix the rear of the unit
to the car body by rubber cushion.
3. Insert trimplate
E N G L I S H
3
5. BAS IC OP E R ATION S
14) PANEL RELEASE BUTTON (REL)
Press this button to remove the control panel.
1) POWER ON/OFF BUTTON
Press PWR button or any other button on the front of the radio (except Open/Eject)to
turn the unit on. Press PWR button again to turn the unit off.
2) MODE BUTTON (MODE)
Press MODE button to select a different mode of operation as indicated on the display
panel.Available modes include Tuner, CD, CARD, USB mode .
3) PWR BUTTON (MUTE)
Press the PWR button momentarily to mute the audio volume, and "Mute" will flash in
the display. Press the PWR button again to restore volume to the previous setting.
4) VOLUME KNOB
To increase the volume rotate the volume knob clockwise, to decrease the volume rota-
te the volume knob anticlockwise.
Press the VOLUME knob, the display will be displayed first option is Volume, Bass,
Treble, Balance, Fader and back to Volume. >>
When adjusting audio functions, the unit will automatically exit audio control mode
after 5 seconds of inactivity. Use the volume knob to adjust the settings.
8) DISPLAY (DSP)
Selects the radio frequency, clock display and PTY NONE.
To set the clock:
1. With clock display selected, hold down the “DISP” button until clock display starts
flashing.
2. Rotate the volume knob to change minutes and hours.
3. Press “DISP” button to start the clock
Pressing the “DISP” key will display the following modes;
In case of receiving a RDS station:
Tuner mode PS – PTY – FREQ – CT
CD/MP3 player mode CDP – PS – PTY – FREQ – CT
In case of receiving NON RDS station
Tuner mode CLOCK – FREQ – NO PTY
CD/MP3 player mode CDP – FREQ – CT – NO PTY
CT = clocktime
6 . T U N E R O P E R AT I O N
11) TUNING UP/DOWN BUTTON
Manual Tuning
Press the Up Tuning or Down Tuning button for more than 3 seconds to move the radio
frequency number up or down one step.
Auto Seek Tuning
Press the Up Tuning or Down Tuning button for less than 3 seconds to move to next
station automatically.
12) PRESET STATIONS BUTTONS
Six numbered preset buttons store and recall stations for each band (3 FM bands).
Store a Station
Select a band (if needed), then select a station. Hold a preset button for 3 seconds.The
preset number will appear in the display.
Recall a Station
Select a band (if needed).Press a preset button to select the corresponding stored station.
13) AUTOMATICALLY STORE / PRESET SCAN (A/PS)
Automatically Store
Automatically select 6 strong stations and store them in the current band. Select a band
(if needed). Press A/PS button for more than three seconds. The new stations replace
stations already stored in that band.
Preset Scan
Scan stations stored in the current band. Select a band (if needed). Press A/PS button
for less than 3 seconds.The unit will pause for ten seconds at each preset station. Press
A/PS button again to stop scanning when the desired station is reached.
Stereo
The unit will automatically pick up a stereo signal, if stereo signal is available.When in
stereo mode, the ST icon will appear on the display.
7. CD P L AYE R O P E R ATION
INSERT AND EJECT CD
Insert a CD label-side up with the unit turned on, and the disc will begin to play. Press
the Eject button to stop CD play and eject the CD.The unit does not have to be turned
on to eject the CD.
PAUSE BUTTON (PAU)
Press the pause button to suspend disc play. Press the pause button again to resume disc
Play.


Produktspezifikationen

Marke: Caliber
Kategorie: Autoradio
Modell: MCD 300M

Brauchst du Hilfe?

Wenn Sie Hilfe mit Caliber MCD 300M benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Autoradio Caliber

Bedienungsanleitung Autoradio

Neueste Bedienungsanleitung fĂĽr -Kategorien-