Bogen TBL1S Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Bogen TBL1S (3 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war fĂĽr 41 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/3
TBL S1
Transformer Balanced
Line Input Module
Features
• Transformer-isolated line level input
• Gain/Trim control
• Bass and treble
• Audio Gating
• Gating with threshold and duration adjustments
• Variable signal ducking when muted
• Fade back from mute
• 4 levels of available priority
• Can be muted from higher priority modules
• Can mute lower priority modules
• Pluggable screw terminal strip
Printed in Taiwan.
© 2007 Bogen Communications, Inc.
54-2084-01D 0704
Specifications subject to change without notice.
Gain
Provides control over the level of input signal that can be applied to the
internal signal buses of the main unit. Allows a way to balance the input
levels of various devices so that the main unit controls can be set to
relatively uniform or optimum levels.
Gate - Threshold (Thresh)
Controls the amount of input signal level necessary to turn the module’s
signal output on and mute lower priority modules. Clockwise rotation
increases the necessary input signal level required to produce audio output
and mute lower priority modules.
Ducking (Duck)
Controls the module’s output level when the module is muted or gated.
The range is adjustable from no reduction in level to full muting of the out-
put signal.
Module Installation
1. Turn off all power to the unit.
2. Make all necessary jumper selections.
3. Position module in front of any desired module
bay opening, making sure that the module is
right-side up.
4. Slide module on to card guide rails. Make sure
that both the top and bottom guides are
engaged.
5. Push the module in to the bay until the faceplate
contacts the unit’s chassis.
6. Use the two screws included to secure the mod-
ule to the unit.
WARNING:
Turn off power to unit and make all jumper
selections before installing module in unit.
Jumper Se
Priority Level*
This module can
priority. Priority 1
modules with low
Priority 2 can be
can mute module
Priority 3 can be
modules and can
4 modules are m
ules. Remove all j
* The number of pr
by the amplifier the
Gating
Gating (turning o
insufficient audio
disabled. Detectio
muting lower pr
regardless of this
Bus Assignmen
This module can
mono signal can
B bus, or both bu
600/10K
GATE
ENABLE/
DISABLE
BUS
ASSIGNMENT
BUS A
BUS B
50 Spring Street, Ramsey, NJ 07446, U.S.A.
201-934-8500; Fax: 201-934-9832
www.bogen.com
Block Diagram
Input Wiring
Balanced Connection
Use this wiring when the source equipment
supplies a balanced, 3-wire output signal.
Connect the shield wire of the source signal
to the “G” terminal of the input. If the “+”
signal lead of the source can be identified,
connect it to the plus “+” terminal of the input. If the source lead polarity cannot be identified,
connect either of the hot leads to the plus “+” terminal. Connect the remaining lead to the minus
“-” terminal of the input.
Note: If polarity of the output signal versus the input signal is important, it may be necessary to
reverse input lead connections.
Unbalanced Connection
When the source device provides only an
unbalanced output (signal and ground), the
input module should be wired with the "-"
input shorted to ground (G). The unbal-
anced signal's shield wire is connected to
the input module’s ground and the signal
hot wire is connected to the "+" terminal. Since unbalanced connections do not provide the same
amount of noise immunity that a balanced connection does, the connection distances should be
made as short as possible.


Produktspezifikationen

Marke: Bogen
Kategorie: Nicht kategorisiert
Modell: TBL1S
Gewicht: 107 g
Energiebedarf: 24VDC
Frequenzbereich: 10 Hz - 40 kHz
Abmessungen (BxTxH): 25 x 76 x 76 mm

Brauchst du Hilfe?

Wenn Sie Hilfe mit Bogen TBL1S benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Bogen

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂĽr -Kategorien-