Bestway 65131 Bedienungsanleitung

Bestway Stiefel 65131

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Bestway 65131 (32 Seiten) in der Kategorie Stiefel. Dieser Bedienungsanleitung war für 34 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/32

65131

www.bestwaycorp.com

WARNING

Follow all the Safety and Operating Instructions. If you don’t follow this instructions, it may cause overturn, explode the

boat and causes to drowning.

1. Do not exceed the maximum recommended number of persons. Regardless of the number of persons on board,

the total weight of persons and equipment must never exceed the maximum recommended load. Always use the

seats / seating spaces provided.

2. When loading the craft, never exceed the maximum recommended load: Always load the craft carefully and

distribute loads appropriately to maintain design trim (approximately level). Avoid placing heavy weights high up.

The maximum recommended load includes the weight of all persons onboard, all provisions and personal NOTE:

effects, any equipment not included in the light craft mass, cargo (if any) and all consumable liquids

(water, fuel, etc.).

3. When using the boat, life saving devices such as life jackets and buoys should be pre-inspected and used at all

times.

4. Before every use, carefully inspect all boat components including air-chambers, grab ropes, oars, and air valves, to

ensure everything is in good condition and tightly secured. Please stop to repair if you find any damage.

5. Buckets, water scoops and air pumps should always be available in case of air leakage or if the boat takes on

water.

6. Passenger numbers and load weights shall by no means exceed specified capacities. Refer to the Technical

Specifications section of this manual to determine passenger numbers and load weights for your boat. Overweight

will cause overturn and drowning.

7. Inflate according the numbered air chamber and rated pressure on the boat, or it will cause overinflation and boat

explosion. Exceeding the data given on the capacity plate may cause the craft to damage, overturn and lead to

drowning.

8. Keep the boat balanced. Uneven distribution of persons or load in the boat may cause overturn the boat and

drowning.

9. When the boat is in motion, all passengers must remain seated at all times to avoid going overboard.

10. Use the boat in protected shore-zones, up to 300 m (984 feet). Be careful with natural factors such as wind,

tidewaters and tidal waves. BE AWARE OF OFFSHORE WINDS AND CURRENTS.

11. Be careful when landing on the shore. Sharp and rough objects such as rocks, cement, shells, glass, etc. may

puncture the boat.

12. If one chamber is punctured when the boat is in the water, it may be necessary to fully inflate the other air chamber

to prevent the boat from sinking.

13. To avoid damage do not drag the boat on rough surfaces.

14. Don’t leave the boat exposed to sun for long periods of time, as high temperatures shall give rise to air expansion,

which can cause irreparable damage.

15. Always wear a lifejacket!

16. It is the responsibility of the owner/operator to have at least on bucket/bailer on board, secured against accidental

loss.

17. Never transport the boat in inflated condition on the car. Be aware of the potential harmful effects of liquids such as

battery acid, oil, petrol. The liquids may damage your boat.

18. Be responsible, do not neglect the safety rules, this could jeopardize your life and the lives of others.

19. Follow these instructions to avoid drowning, paralysis or other serious injuries.

20. Know how to operate a boat. Check in your local area for information and/or training as needed. Inform yourself

about local regulations and dangers related to boating and/or other water activities.

SAVE THESE INSTRUCTIONS

Assembling of the boat

NEVER USE HIGH PRESSURE AIR TO INFLATE INFLATABLES. THIS CAN DAMAGE YOUR PRODUCT.

1. Spread out the boat on level ground.

2. Assemble the removable fin to the bottom of the boat (Fig.1). Make sure the curvature of the fin is pointed towards the

back end of the boat.

NOTE: Assemble the fin before inflation and also disassemble it after deflation.

NOTE: To avoid damage to the removable fin, do not enter shallow water.

WARNING: To avoid damage to the boat and injury to passengers, please don’t exceed the

data given on the builder’s plate.

Technical Specifications

• Inflate the air chambers with a HAND air pump.

An inflation scale is provided with the product.

Inflate the product until the printed scale is charged up to the same level as that of the supplied scale. (refer the

belowing Table and Illustration)

Caution: Under and over-inflation of the boat will result in safety hazards. It is better to check the pressure of the boat

each time before using. If you use other pressure gauge, the boat pressure should not be more than the data given on

the builder’s plate.

• Never stand on or rest objects on the boat during inflation.

• Inflate bottom chamber and other accessories such as seat until it is stiff to the touch but NOT hard.

• Extended exposure to sun can shorten the lifespan of your boat. We suggest not leaving boats in direct sunlight for

more than 1 hour after use.

NOTE: In the case of a single user, the seat needs to be adjusted to the middle position.

Oars Installation

0.03 bar

0.5 psi

Item

65131

Maximum Number of Persons

2 adults

Maximum Load Capacity

180 kg (397 lbs)

Inflated Size Recommended

Working Pressure

3.31 m x 88 cm

(10'10" x 35")

Fig. 1

OWNER’S MANUAL

Boat

Rope x 2Inflation Scale

Removable Fin x 1 Removable Fin x 1

Hand Pump Elastic Cord x 2

Footrest Cushion

Oar Blade X 4 Oar Ring X 4Shaft x 4 Shaft x 2

Components:

• Repair Patch

• Deflation Pipe

mc1112

1112

131415

NOTE: All drawings for illustration purpose only. May not reflect actual product.

Storage

1. Keep all accessories for future use.

2. Carefully clean the boat using a mild soap with clean water.

Note: Do not use acetone, acid, and/or alkaline solutions.

3. Use a cloth to gently dry all surfaces.

Note: Do not dry the product in direct sunlight. Also, never dry with equipment such as electric blowers. Doing so will

cause damage and shorten the boat’s life span.

4. Deflate the hull chambers. Deflate all the hull chambers at the same time so the

air-pressure drops together. This will prevent damage from occurring to the boat

inner structures. Next deflate the floor and seat.

5. Fold the boat from front to back to remove additional air. You can also use a pump

to drain any remaining air.

Repair

1. If there is a small puncture, repair it according to the instruction on repair patch.

2. If the hole is too big to be repaired with the provided patch, purchase a Bestway repair kit or send the boat to a

speciality shop to make the repair.

Registration (For US/Canada customers only)

If you need to register your boat, please have the boat Hull Identification Number and model name ready and then visit

bestwaycorp.com/support to obtain your Certificate of Origin, or you can send e-mail to service@bestwaycorp.us for the

Certificate of Origin.

The HIN is located on the starboard outboard side of the hull and near the stern.

PLEASE KEEP THIS MANUAL IN A SECURE PLACE, AND HAND IT OVER TO THE NEW OWNER WHEN YOU

SELL THE CRAFT.

Item

5 cm / 10 cm 5.3 cm / 11.1 cm

Product Inflated Size

Deflated Size

Printed Scale

Inflated Size

65131 3.31 m x 88 cm (10'10" x 35")

Produktspezifikationen

Marke:	Bestway
Kategorie:	Stiefel
Modell:	65131
Breite:	880 mm
Gewicht:	10695 g
Produktfarbe:	Black, Blue
Höhe:	450 mm
Höchstgewichtskapazität:	180 kg
Verpackungsbreite:	450 mm
Verpackungstiefe:	265 mm
Verpackungshöhe:	620 mm
Paketgewicht:	12163 g
Zertifizierung:	ISO 6185
Typ:	Aufblasbares Kajak
Menge pro Packung:	1 Stück(e)
Verpackungsart:	Vollfarben-Box
Länge des Versandkartons:	465 mm
Breite des Versandkartons:	280 mm
Höhe des Versandkartons:	635 mm
Anzahl der Sitze:	2 Sitz(e)
Anzahl der Personen:	2 Person(en)
Länge (mm):	3310 mm
Akkus/Batterien enthalten:	Nein
Verpackungsvolumen:	83000 cm³
Griffanzahl:	2
Hauptkarton GTIN (EAN/UPC):	06941607313206
Ergonomische Griffe:	Ja
Menge pro Versandkarton:	1 Stück(e)
Flickzeug enthalten:	Ja
Rückenlehne:	Ja
Größe in unaufgeblasenem Zustand (B x L):	910 x 3310 mm
Ruder enthalten:	Ja
Anzahl der enthaltenen Ruder:	2
Abschleppseil:	Ja
Pumpe:	Ja
Wegnehmbarer Sitz:	Ja