Belling Baby 121R Bedienungsanleitung

Belling Ofen Baby 121R

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung fĂŒr Belling Baby 121R (8 Seiten) in der Kategorie Ofen. Dieser Bedienungsanleitung war fĂŒr 15 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/8
Baby Belling
121R
Installation and User Instructions
2
Installing Your Cooker
Your Belling Cooker Even if you have used an electric cooker before, it is important that you read
these instructions thoroughly before starting to cook, paying particular attention
to the installation and safety instructions.
Getting help If you have any problems with installing, operating, or cooking with your Belling
Cooker, please check through these instructions thoroughly to make sure that
you have not missed anything. If you still need help, then please contact:
Belling Customer Care Centre
Stoney Lane
Prescot
Merseyside
L35 2XW
Tel 0844 815 3746
If your query relates to cooking then please write to the Senior Home
Economist at the same address.
Details of how to contact a Belling Approved Service Agent, should your cooker
ever require maintenance, can be found in the ‘Care of your cooker’ section of
this book. Please quote the cooker model and serial number with all enquiries,
this can be found on the voltage label which is located on the outer back panel.
WARNING! For your own safety, make sure that these instructions on
installation, use and maintenance are followed.
We advise you to keep these instructions in a safe place for future reference. if
you sell or transfer ownership of this product, please pass on these instructions
to the new owner.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Unpacking After unpacking your cooker, make sure that you remove all the packing from the
oven and grill compartment, and the packing from under the hob on radiant ring
models, and any stickers from the oven door and the hob. Examine your cooker
for any damage. If there is any damage to your cooker or anything is missing,
please contact your supplier for advice.
Locating the cooker Your cooker must stand on a flat surface, or be fitted to the special Belling stand,
so that when it is in position the hob is level. Make sure that the cooker is stable
and cannot be rocked. If it is used between units, allow 10mm (3/8”) clearance
on each side. It must not be situated with either side closer than 150mm (6”) to a
wall or cupboard that is higher than the hob. Do not remove the cooker feet.
Any overhanging surface or cooker hood should be at least 450mm (18”) above
the cooker hob. We do not recommend positioning the cooker below wall
cupboards, as the heat and steam from the cooker may cause damage to the
cupboards and its contents. Make sure that the walls near the cooker are
resistant to heat, steam, and condensation.
3
Installing Your Cooker
Connecting the cooker WARNING THIS APPLIANCE MUST BE EARTHED -
The Baby Belling 121R is designed to operate from a 13A socket outlet.
If the cooker is not already fitted with a plug proceed as follows:
IMPORTANT:
The cooker must be connected to the supply by a properly earthed 3-pin plug
(minimum capacity 13 Amp). If a BS1363 fused plug is used it should be fitted
with a 13 Amp fuse ASTA or BSI approved to BS1362.
The wires in the mains lead are coloured in accordance with the following
code:
Green and Yellow Earth
Blue Neutral
Brown Live
As the colours of the wires in the mains lead of this appliance may not
correspond with the markings identifying the terminals in your plug, proceed
as follows:
1. The wire which is coloured green and yellow must be connected to the
terminal in the plug which is marked with the letter or by the earth symbol E
or coloured green, or green and yellow.
2. The wire which is coloured blue must be connected to the terminal which is
marked with the letter or coloured black. N
3. The wire which is coloured brown must be connected to the terminal which
is marked with the letter or coloured red. L
If you are not sure how to connect your cooker please consult a competent
electrician.
Warning! During use the appliance becomes hot. Care should be taken to avoid
touching heating elements inside the oven.
The cooker may already be fitted with a non-rewirable plug. If this is not of the
correct type for the sockets in your home it must be cut off and the correct
type fitted. If it is cut off it must be disposed of safely. There is a danger of
electric shock if it is inserted into a socket.
To replace the fuse in a non-rewirable plug, simply prise out the fuse carrier,
fit an appropriate replacement fuse, (13 Amp, ASTA or BSI approved to BS1
362) and replace the fuse carrier. Never use the plug without the fuse carrier
fitted. If the fuse carrier is lost, a replacement can be obtained from your
nearest Belling Spares Distributor, or most Electricity Company shops. The
replacement fuse carrier will be identified by either colour coding to match the
plug, or by markings on the fuse carrier and the plug. Make sure that a correct
replacement is fitted.
This appliance has been approved by the British Electrotechnical Approvals
Board to the latest European safety standards.


Produktspezifikationen

Marke: Belling
Kategorie: Ofen
Modell: Baby 121R

Brauchst du Hilfe?

Wenn Sie Hilfe mit Belling Baby 121R benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Ofen Belling

Bedienungsanleitung Ofen

Neueste Bedienungsanleitung fĂŒr -Kategorien-