BeamZ S700 Bedienungsanleitung

BeamZ Lichteffektmaschine S700

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für BeamZ S700 (11 Seiten) in der Kategorie Lichteffektmaschine. Dieser Bedienungsanleitung war für 31 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/11

Ref. Nr. 160.426

S700

LED SMOKE MACHINE

Flame eﬀect

INSTRUCTION MANUAL

GEBRUIKSAANWIJZING

BEDIENUNGSANLEITUNG

NOTICE D’UTILISATION

V1.1

- 2 -

Warning:

- The smokemachine must be placed at least 100 cm away from inﬂammable materials such as curtains,

books, etc. Make sure that the housing cannot be touched by accident.

- Use only Beamz water-based smoke ﬂuid recommended by your dealer.

- Poor smoke liquid caused permanent damage, bad eﬀect, clogging, spitting of unevaporated liquid etc.

- Never add ﬂammable ﬂuids (oil, gas, perfume) to the fog liquid.

- Always keep enough smoke liquid in the tank.

Use of the device without liquid will cause damage to the pump and heater.

- Do not obstruct the openings on top of the case to guarantee a good ventilation.

- ut any objects on the smoke machine. Don’t p

- For indoor use only.

- During installation, nobody should stand beneath the mounting area.

- Prior to the ﬁrst use, have the unit checked by a qualiﬁed person.

- The unit contains voltage carrying parts. DO NOT open the smokemachine

- Never plug or unplug the unit with wet hands.

- If the plug and/or mains lead are damaged, they need to be repaired by a qualiﬁed technician.

- If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a mains outlet. It

needs to be repaired by a qualiﬁed technician.

- Only connect this unit to an earthed mains outlet of 220- Vac/50Hz . 240

- Always unplug the unit during a thunderstorm or when it is not in use.

- If the unit has not been used for a longer period of time, condensation can occur inside the housing. Please

let the unit reach room temperature prior to use.

- When you unplug the unit from the mains always pull the plug, never the lead.

- In order to prevent dropping of the unit, a safety fastening needs to be installed. This can be a solid chain, a

steel cable, etc. which has to be fastened separately from the mounting bracket.

- The supplied bracket is the main ﬁxing and must be used to solidly mount the light eﬀect.

- In order to avoid accidents in public premises, the local legal requirements and safety regulations/warnings

must be fulﬁlled.

- Keep out of the reach of children.

Location

Select a location where it is easy to ﬁll the tank. It is also possible to hang the unit by means of the supplied

holder and ﬁxing screws.

Intro : A compact 700W smoke machine with orange LEDs for an astonishing and unique flame eﬀect while

producing fog. The smoke machine has a built in reservoir for the smoke ﬂuid. The LEDs flame eﬀect can be

switched oﬀ on the back of the smoke machine. Smoke production can be activated on the supplied remote

control.

Installation and Use

Unpack the fog machine. Do not connect yet the net cable. Fill the ﬂuid tank by means of a funnel. Plug the unit

into a mains outlet. Thus the heating element is automatically switched on. Depending on the room temperature,

it takes about 3 minutes until the working temperature is reached. Then the thermostat is clicking and the LED

on the manual control lights up. Push the switch once and the smoke machine will produce a nice thick fog.

Once the smoke machine has reached its working temperature (the LED is lit) the smoke machine can produce

fog for a while. After this period of time, the fog generator is cooled so much down that the thermostat switches

oﬀ. Wait a while until the working temperature is reached again. It is recommended to produce smoke with small

pauses in between so that the temperature is maintained and th e thermostat doesn’t switch off.

Make sure that there is always enough liquid smoke contained in the tank. Use of the smoke machine without

liquid can permanently damage the unit. Once the smoke machine generates little smoke or pump generate

another 'rattling' sound i turn oﬀ the unit direct. Check the ﬂuid level and ﬁll the tank when it is empty, check the

hose and ﬁlter blockages and restore it. Plug in the unit and check if the problem is resolved. If problem persists,

switch unit direct off to prevent further damage and contact your dealer.Switching the unit off :Switch the unit off

by unplugging it from the mains. Otherwise the 700W heating element will draw unnecessarily current.

- 3 -

Maintenance

Reﬁlling the ﬂuid reservoir should be done carefully. Remove the plug from the mains ﬁrst! Then unscrew the

cap of the reservoir and ﬁll it by means of a suitable funnel. Use only the original Beamz smoke liquid. This ﬂuid

is environmentally friendly, biodegradable and leaves no residue when used correctly. Make sure the smoke

liquid to become contaminated, close the cap of the liquid smoke can and after ﬁlling tank right.

After 40 hours, the smoke machine must be cleaned to avoid deposits in the machine, pump and heater.

Clean procedure

Run clean procedure in a well-ventilated area

 Remove smoke liquid from the tank dd cleaning solution to tank , a

 Switch smoke machine and wait until it is warm up

 Press the button to switch the liquid pumped through the machine

 Perform the above operation until the tank is empty

 Fill the tank with liquid smoke

Speciﬁcations

Power supply: ........................................................... 230V~/50Hz

Heating element: ........................................................... 700 watts

Heat up time: 3 minutes ................................................................

Smoke production: ............................................ ca. 75 m3/minute

Tank capacity: ................................................................. 0,5 liters

Dims: ............................................................. 250 x 160 x 140mm

Weight ................................................................................. 2.5 kg

Accessories

Smoke fluid, high quality ﬂuid on water basis, specially designed for Beamz smoke machines. Guarantees a

trouble-free use.

5 liter packaging, ref. no. 160.582 160.583 160.586

1 liter packaging, ref. no. 160.643 160.644

Flavor, adds a pleasant fragrance to the air. One bottle is suﬀicient for 5 liter smoke ﬂuid.

coconut 160.650 tropical 160.653

mint 160.651 strawberry 160.654

vanilla 160.652 energizer 160.655

Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local

authorities or your dealer about the way to proceed.

Do not attempt to make any repairs yourself. This would invalid your warranty.Do not make any changes to the unit. This would also

invalid your warranty.The warranty is not applicable in case of accidents or damages caused by inappropriate use or disrespect of the

warnings contained in this manual.Tronios BV cannot be held responsible for personal injuries caused by a disrespect of the safety

recommendations and warnings. This is also applicable to all damages in whatever form.

Produktspezifikationen

Marke:	BeamZ
Kategorie:	Lichteffektmaschine
Modell:	S700
Gewicht:	2500 g
Produktfarbe:	Schwarz
AC Eingangsspannung:	220-240 V
AC Eingangsfrequenz:	50 Hz
Leistung:	700 W
Kabellänge:	3 m
Fernbedienung:	Ja
Fernbedienungstyp:	Kabelgebunden
Kapazität Flüssigkeitstank:	0.25 l
Abmessungen Gerät (B x H x T):	260 x 145 x 130 mm
Arbeitende Flüssigkeit:	Wasser
Rauch output volumen:	75 m³/min